Any LED system should be able to appropriately track overvoltage, undervoltage, short circuit, open circuit, and thermal runaway conditions.
任何LED系统都应当能够适度跟踪过高、欠压、短路、开路和热逃逸等问题。
Relays are the logic elements of a protection system which sense the fault and cause the circuit-breaker trip circuits to be energized and the breakers to open their contacts.
继电器是保护系统的逻辑元件，它感知故障，并使断路器解扣电路带电和断路器打开触点。
Aiming at developing problem of test system for circuit board for large scale and complicated electronic equipment, the open model was presented.
针对大型复杂电子装备电路板测试系统的开发问题，提出了一种开放式开发模式。
An analysis of the antenna and scattering theory is an important part in the electromagnetic problems, which describes the energy transformation from a closed circuit system to an open space system.
电磁问题中有很大一类是研究天线和散射理论，即由封闭电路系统向空间开放系统的能量转换。
The result is that open circuit fault does not affect output voltage of the system, but it apparently affects inductance current and output current of single module inverter.
分析得到开路故障不会影响系统输出电压，但会明显影响单逆变器模块电感电流和输出电流。
A simple method for calculating maximum open-circuit potential was presented when power system was in the non-full phases and swings operation.
提出了计算电力系统非全相振荡时最大断口电势的简便方法。
On the basis of three-phase inverting circuit, this paper describes how to make the control method of open loop system in closed loop system.
以三相逆变电路为基础，阐述了如何将开环系统的控制方法用于闭环系统，并且介绍了这种新的控制方法在实际中的应用，证明了该方法的有效性。
Open-control module and power convert module are added to the 5756 panel of 5700 surface system, while the open-close convert circuit being added to 3106 MSFL tool circuit.
对5700地面系统5756面板增加了收张腿控制模块、电源转换模块，在3106电子线路中增加了收张腿转换电路。
The existing control system of LED display transmits data with unidirectional open circuit way, but if any one of transmission paths was on the event of failure, LED display would not show correctly.
现有LED显示屏控制系统以单向开路的方式进行数据传输，在任意一个传输通路上发生故障时，LED显示屏都不能正确显示。
The existing control system of LED display transmits data with unidirectional open circuit way, but if any one of transmission paths was on the event of failure, LED display would not show correctly.
现有LED显示屏控制系统以单向开路的方式进行数据传输，在任意一个传输通路上发生故障时，LED显示屏都不能正确显示。
应用推荐