It is an important factor for the perfect matching between the maximal input power of the hydraulic oil pump and the maximum output power of the engine in the design process of the hydraulic shovel.
液压油泵的最大输入功率与发动机的最大输出功率之间的匹配问题是液压挖掘机设计过程中的一个重要内容。
High viscosity of the liquid transmission gear pump should be at a lower power consumption, less leakage, larger output under the pressure of the most traffic.
输送高粘度液体的齿轮泵应做到在较低的功耗、较少的泄漏、较大的压力下输出最多的流量。
In conclusion an approach under distributed pump and with nonuniform pump absorption coefficients is proposed to get the best match of temperature distribution and output power.
进一步分析得出，综合采用分段泵浦方式和不均匀泵浦吸收系数可实现温度分布和输出功率的最佳匹配。
The influences of thermal effects and the matching of the laser mode radius with the pump spot radius on the output power and beam quality are discussed.
讨论了激光晶体的热效应以及激光模半径与泵浦光斑半径匹配对激光输出功率和输出光束质量的影响。
The output power and optical efficiency of different resonator parameters and pump power have been analyzed with numerical calculation.
用数值计算给出了不同腔参数和不同的抽运功率下的输出功率和光一光效率图。
Furthermore, we analysis the effect of difference inner-cladding structures on the absorption efficiency of pump light, and the fiber length has a significantly impact on output power.
分别介绍了单包层光纤和双包层光纤的结构，分析它们的传输特性，讨论了内包层形状对泵浦光吸收效率的影响以及光纤长度对输出功率的影响。
Internal combustion water power system integrated traditional internal combustion engine and plunger pump technique, made directly use of the rectilinear motion of plunger for output water power.
内燃式水动力系统将传统内燃机与柱塞式水泵技术集成为一体，直接利用活塞往复直线运动输出水动力。
The signal power output of high conversion efficiency is depended on the optimum crystal lengths, pump intensity and signal power.
高转换效率的信号光输出取决于抽运光和初始信号光的强度及晶体长度的最佳优化值。
Based on the theory of electric motor and the characteristics of pump, a new method for calculating output power and speed of an electric motor with changed frequency is presented.
依据电机理论和泵的特性，分析并得出了在频率改变后，由频率计算电机转速及输出机械功率的方法。
Analytic solutions for the threshold pump power, the output power, the slope efficiency and optimum erbium-doped fiber length of EDFL are obtained.
获得了激光器的阈值泵浦功率、输出功率。斜率效率以及最佳掺铒光纤长度的解析解。
The effects of the curvature radius, the transmission of output coupler, the spot size of the pump, and the temperature of the heat sink on the output power are investigated.
对输出镜的曲率半径、输出镜透过率、泵浦光斑大小以及热沉温度对激光器输出功率的影响也作了研究。
The equation that determines the function of optimum reflection Rk of the output coupling mirror M1 versus pump power, dye concentration, and loss is deduced.
推导了耦合输出镜最佳反射率和泵浦功率损耗，浓度等参量的关系。
The conversion efficiency of the average power is 4.2% from pump diode to OPO signal output and the signal pulse duration is about 13 times shorter than that of the depleted pump light.
实验中获得的由二极管注入泵浦功率至opo信号光平均输出功率的转换效率达4.2%，信号光脉冲宽度比消耗后的泵浦光脉冲宽度压缩了13倍。
Based on rate equations, the laser output characteristic under different fiber length and back-cavity mirrors is studied, and the distribution of pump power and laser power is discussed.
基于激光器速率方程，分析了激光输出与光纤长度、后腔镜的关系，讨论了小功率泵浦时光纤内的功率分布情况。
The multiple pump sources are used to increase the output power of single fiber laser, and the two dimensions arrange of fiber laser array increases the number of combining fibers.
利用多泵浦源提高单根光纤激光器的输出功率，利用二维光纤激光阵列排列增加参与组束的光纤数目。
The relations between the output pulse energy of the amplifier and the different input pulse peak power or pump power are also discussed.
讨论了掺镱双包层光纤放大器输出脉冲能量随不同输入脉冲峰值功率和泵浦功率的关系。
The parameters, such as the fiber length, pump power and the transmissivity of the output mirror, which affect the output power and pulse linewidth, were analyzed.
同时从理论上分析了增益光纤长度、泵浦功率、输出镜透射率等因素对激光器输出脉冲波形和输出功率的影响。
This solution can quickly calculate the laser and pump power distribution along the fiber and the output power. The result of the percentage error is about 1% and up to 0.2%.
这种解法能够迅速计算出激光及抽运光沿光纤的功率分布状况以及输出功率，计算误差百分比约为1%，最高达到0.2%；
Pump absorption saturation makes the population of the lower pump level and the absorption coefficient decrease, and the output power is lower.
抽运光的吸收饱和使激光器运转时激光下能级的粒子数减小，吸收系数下降，激光器的输出功率较低。
Apply the cladding power stripper at the output end for stripping the remained pump power and guarantee the stability and reliability of the system.
在光纤输出端采用包层功率剥离器，去除剩余的泵浦光，保证了系统的稳定性和可靠性。
High viscosity pump is conveying liquid with high viscosity gear pump, should be in lower power consumption, less leakage, under the pressure of large output the most traffic.
高粘度泵是输送高粘度液体的齿轮泵，应做到在较低的功耗、较少的泄漏、较大的压力下输出最多的流量。
The effects of pump ratio and fiber length arrangements on the output characteristics of the L-band SFS in terms of mean wavelength, spectral linewidth, and output power are analyzed.
分析了抽运比例以及光纤长度分配对光源的平均波长、光谱线宽和输出功率的影响。
An oil pump (18) is arranged on the external part of the casing of the gear box and on a power output shaft (17), and an oil cylinder (9) is arranged on the rear upper part of the gear box.
在变速箱的壳体外部，于动力输出轴(17)上装有油泵(18)，而油缸(9)被安放在变速箱的后上部。
According to the amplitude of the input signals, the charge pump has two level output voltage rails available to save power.
根据输入信号的幅度，该电荷泵可以提供两档电压轨来节省功耗。
According to the amplitude of the input signals, the charge pump has two level output voltage rails available to save power.
根据输入信号的幅度，该电荷泵可以提供两档电压轨来节省功耗。
应用推荐