There are three types of shaft misalignment, namely in terms of parallel misalignment, angular misalignment and shaft end-play.
轴的偏差有三种，分别是径向偏差、角向偏差和轴向偏差。
This article through the actual inspection, had discovered in modern Chinese "come", "to go" in use many parallel misalignment question.
本文通过实际考察，发现了现代汉语中“来”、“去”在使用上的许多不平行性问题。
According to this model, the parallel misalignment and angular misalignment can be calculated so long as light spot coordinate of PSD at two discretionary angles is measured.
据此模型，只要测量出任意两个角度时光斑在PS D上的坐标，即可求出两轴的径向偏差和角度偏差。
The main work can be summarized as follows: Firstly, by analyzing the ideal geometric relation in parallel CT system, the thesis presents a calibration method of geometric misalignment.
首先，本论文通过分析平行束CT系统的理想成像关系，提出了一种适用于平行束CT系统几何失真校正的方法。
The main work can be summarized as follows: Firstly, by analyzing the ideal geometric relation in parallel CT system, the thesis presents a calibration method of geometric misalignment.
首先，本论文通过分析平行束CT系统的理想成像关系，提出了一种适用于平行束CT系统几何失真校正的方法。
应用推荐