There are no specific design demand and computer theory of paving layer in current bridge criterion, so there are common damages on the surface.
而现行的桥梁规范中对铺装并无具体的设计要求和计算理论，桥面铺装层纵横裂纹等破坏普遍存在。
This paper states the causation and prevention of the damages on concrete bridge paving layer, points out the study direction of bridge paving layer.
本文论述了混凝土铺装层破坏产生的原因和防治措施，同时从理论上阐述了今后桥面铺装层研究的方向。
Composite bridge deck made from a variety of paving layer materials, due to the nonlinear stiffness characteristics, resulting in the force of composite bridge deck structure complex.
复合桥面铺装由多种材料分层铺筑而成，由于结构刚度的非线性特点，造成复合桥面铺装结构受力复杂。
Based on the construction experience of many years, the paper analyses the factors influencing the concrete paving layer of bridge floor and presents the effective methods to control its quality.
深入分析了对桥面砼铺装层影响因素的作用机理，并在总结多年施工经验的基础上，提出了对其质量进行控制的有效方法。
The important parameters that influence the mechanical property of the paving layer on an orthotropic steel bridge deck are the paving layer thickness and modulus of the asphalt concrete surfacing.
影响正交异性钢桥面铺装层力学性能的重要参数有铺装层的厚度和沥青混凝土铺装层的模量。
An other layer should be added in order to obtain the same finish level with the concrete paving, conformING to the design.
我想它的意思应该是：应加入一个其他层以获得与混凝土铺地相同的饰面标高，达到设计要求。
According to the project, a new paving system will be added to the existing one: a layer of stones of various sizes, between 2 and 3 cm in diameter.
根据该项目，将在现有基础上增加一个新的石板路系统：直径在2和3厘米之间的不同型号的石材面层。
The paper introduced the construction technology of bituminous concrete paving coat, the materials choice of water proof layer.
介绍了沥青混凝土铺装层的施工技术，并对防水层材料的选择等技术也作了介绍。
In this paper, the laying of asphalt for waterproofing and asphalt paving method waterproof layer the two aspects were described, to provide reference for related housing construction officers.
本文就沥青防水层的铺设准备和沥青防水层的铺设方法两个方面进行了阐述，以供相关房建人员参考。
Each layer of loose paving thickness should be 30cm, paving the last degree should be uniform, the surface should be smooth after compaction.
每层的松铺厚度以30cm为宜，摊铺阼度应均匀，压实后的表面应平整。
Each layer of loose paving thickness should be 30cm, paving the last degree should be uniform, the surface should be smooth after compaction.
每层的松铺厚度以30cm为宜，摊铺阼度应均匀，压实后的表面应平整。
应用推荐