We design a set of computer aided test system for measuring the output power of the tractor motive power shaft.
为了测量拖拉机动力输出轴的输出功率，设计了一套计算机辅助测试系统。
The results have shown that the torque tube unbalance is not a key factor in high speed dynamic balance, but effects the power shaft.
结果表明：测扭基准轴的不平衡量虽然不是转子高速动平衡的决定性因素，但影响到传动轴的动平衡。
Power and non power shaft bend and adjust the pressure, and together with the roller disk axis deviation have been reflected in the design.
动力和非动力轴的弯度和调整压力，以及连同滚筒盘中的轴的偏差在设计中都得到体现。
The high power shaft alternator constant frequency systems developed by Siemens is introduced, which is suitable for large container ships.
介绍了西门子开发的大功率轴带交流发电机恒频供电装置，适用于大型集装箱船；
All the machines were set up along the shaft, with a belt giving each of them power.
所有的机器都靠这个轴带动。
To pump energy back into the grid, some of the rotational energy is bled off to power a generator on the main shaft.
把电能又送回电网时，就释放一部分转动的动能，开动位于主轴的发电机。
But because it now oil and chemical use screw compressor for flow and pressure from the shaft power, high demands, at present basically also rely on imports.
但由于目前石油和化工用螺杆式压缩机对流量、排出压力、轴功率等要求较高，目前基本上还依赖进口。
Generally speaking, hollow shaft type of small volume, but the amount of magnetic force (magnetic power) also stretch out shaft type than for small.
一般而言，空心轴式的体积较小，而所需磁化力(磁动力)亦比伸出轴式为小。
As the piston descended, a ratchet engaged the piston rod and engine shaft and thus power was transmitted.
当活塞下行时，棘轮连接活塞杆和发动机轴，因此将功率输送出去。
A lower value use of refinery gas is to generate shaft power.
炼厂气价值较低的应用是用作产生轴功率。
Power will go from the pinion shaft through the differential pinions to only one side gear because the other side gear is stationary.
来自行星齿轮轴的功率通过行星齿轮，只到达一个半轴齿轮，而另一个半轴齿轮保持静止。
At the same time, from the energy consumption perspective, the user more not concerned with the air compressor shaft power energy consumption, but the input power than the energy consumption ratio.
同时，从能耗角度上讲，用户更关心的不是空压机轴功率的能耗比，而是输入功率的能耗比。
The gear section also has the input shaft and the output shaft needed to transmit power to the drive wheels.
齿轮段也有输入轴和输出轴，它必须吧动力传递给驱动轮。
Power take - off, squared shaft drive. two stud flange without oil seal gasket.
动力启动方轴传动装置。销法兰。无油密封垫圈。
To ensure the impeller head and flow ratings, shaft power should be reduced, to reduce energy consumption, and improve impeller efficiency so as to save energy.
为保证叶轮的扬程和流量，必须降低轴功率，减少能耗，提高叶轮的效率，才能达到节能减耗的效果。
The same viscosity, pressure, shaft power and speed linearly proportional to.
同一粘度、压力下，轴功率与转速近似成正比。
An in-situ test of large industrial water primps characteristics, which is a combination of thermodynamical method and motor shaft power measurement, is described in this paper.
将热力学方法与电工仪表测算电动机轴功率方法结合起来，可以较准确地测出一台工业用大型水泵的性能。
Viscosity increases, flow rate and shaft power was increased, but because of the relationship between them is more complex and when necessary to consult professionals.
粘度增大时，流量和轴功率均增加，但由于其中关系较复杂，必要时可向专业人员咨询。
Same speed, viscosity, the shaft power and pressure approximation is proportional to.
相同转速、粘度下，轴功率与压力近似成正比。
The propulsion shaft is the most important component of power device of the ship; its stability is the basic promise of the ships life.
舰船推进轴系是舰船动力装置的重要组成部分，它的稳定性是舰船生命力的基本保证。
By comparing the calculated water head, shaft power and efficiency with the experimental results, the method was proved to he feasible.
计算了泵的扬程、轴功率和效率，并与试验进行了对比，验证了计算方法的可行性。
Cylinder profile has little influence on shaft power of rotary vane compressor.
型线的构成对压缩机轴功率的影响可以忽略。
Treatment of industrial water for cooling generators and filtration of sealing water to increase the service life of the turbine shaft sliding-ring seals in hydroelectric power stations.
工业水处理冷却发电机和封水增加的涡轮轴滑动在水力发电站的密封圈使用寿命过滤。
Based on the condition that the strength equivalent to the stiffness required to met, one equation to calculate the power convey shaft with several different section areas was derived in this article.
以满足刚度等效为条件，求得一个能方便算出多种截面的可供选用的传动轴计算公式。
Instead, the known flow, head and efficiency, shaft power can also be obtained.
反之，已知流量、扬程和效率，也可求出轴功率。
The input power of motor and shaft power of pump are key measurements in field test of pumping stations.
电动机输入功率和水泵轴功率测试是泵站现场测试的重要内容。
Power flows through the drive pinion, ring gear, case, and pinion shaft to the differential pinions. Then power splits equally and goes to the side gears, axle shafts, and drive wheels.
功率经过主动齿轮、从动锥齿轮、壳体和行星齿轮轴来到行星齿轮，然后功率被均分，送到半轴齿轮、半轴，最后到达驱动轮。
Power flows through the drive pinion, ring gear, case, and pinion shaft to the differential pinions. Then power splits equally and goes to the side gears, axle shafts, and drive wheels.
功率经过主动齿轮、从动锥齿轮、壳体和行星齿轮轴来到行星齿轮，然后功率被均分，送到半轴齿轮、半轴，最后到达驱动轮。
应用推荐