This measurement will give you the propeller shaft Angle (C).
测量结果就是传动轴工作角(c)。
Aligning intermediate shaft and propeller shaft after launching.
下水后中间轴和螺旋桨连接后校中。
In this step, work to drill for the pipe of a propeller shaft or a rudder.
在这个步骤中，演练工作，为管道的传动轴或舵。
Most cars have two universal joints, one at each end of the propeller shaft.
多数汽车采用两个万向节，在传动轴的每一端各有一个万向节。
Therefore, the optimizing of propeller shaft bracket is a very important issue.
因此，船舶尾轴架结构的优化设计是一个很重要的问题。
The propeller on the propeller shaft is located outside the rudder propeller housing.
螺旋桨轴上的螺旋桨位于所述舵桨壳体的外部。
Inspection machining dimension of propeller shaft (intermediate shaft or counter shaft).
螺旋桨轴(中间轴)机加工尺寸检查。
These drive the central propeller shaft through bevel reduction gears with a 2:1 reduction.
这些驱动器，中央螺旋桨轴通过减少锥齿轮2：1减少。
The propeller shaft frequency is one of the important target recognition features for passive sonar.
螺旋桨轴频是被动声纳极其重要的目标识别特征之一。
The driving power enters the differential through the drive pinion on the end of the propeller shaft.
也就是说，驱动力是从传动轴末端的传动齿轮输送到差速器的。
Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft.
对准传动轴和轭上安装参考标记，安装传递轴。
So it is significative to carry out a research on room temperature creep characteristic of propeller shaft .
所以对螺旋桨尾轴进行蠕变分析是十分有意义的。
For connecting the output shaft of the gear box to the rear axle, a ling shaft known as propeller shaft is used.
为把齿轮盒子的输出桥连结到后面的轮轴，鳕即是螺旋桨桥的桥被用。
Abnormal noise often occurs in motor vehicle transmission system especially in propeller shaft and final reduction gear.
汽车传动系特别是传动轴与主减速器常产生异常响声。
This accommodates any effective change of length of the propeller shaft as the rear axles move toward or away from the CAR frame.
当后桥在车架上向前或向上运动时，这种结构足以调整传动轴长度的任何变化。
This avoids the use of a traditional propeller shaft and puts the propellers in a clear flow of water, which greatly improves efficiency.
这样就避免了使用传统的螺旋轴，将螺旋桨置于干净的水流中，从而大大提高了效率。
In this paper, the correct assembly condition for the propeller shaft of an articulated vehicle is analyzed in the view of kinematics.
从运动学观点分析铰接式车辆传动轴的正确安装条件；
Rotary motion of the transmission main shaft carries through the propeller shaft to the differential, causing the rear wheels to rotate.
变速器主轴的旋转运动通过传动轴传递到差速器上，使后车轮转动。
The reason the propeller shaft shortens as the Angle increases is that the rear axle and differential move in a shorter ARC than the propeller shaft.
当角度增加时，传动轴变短的原因是后桥和差速器运动的弧度小于传动轴运动的弧度。
The 14-cylinder engine turns the longest propeller shaft (130 metres) ever built, at the end of which is the largest propeller, weighing in at 130 tonnes.
14缸发动机转动最长的推进器杆(130米)，在其末端是最大的推进器，重130吨。
This changes the Angle of drive and the distance between the transmission and the differential, and the propeller shaft may take care of these two changes.
使变速器和差速器之间的传动角度和距离发生变化。传动轴要能适应这些变化。
BMW Corporation of West Germany has developed a torsion rig for universal joint propeller shaft and axle shaft for the use of testing four-wheel-drive cars.
联邦德国的BMW公司开发了一种万向节传动轴与半轴的扭转试验台，专供四轮驱动型桥车试验用。
The propeller is to be force fitted to the propeller shaft by using the hydraulic jack which the Builder possess and secured by wet type keyless fitting method.
螺旋桨通过使用船厂提供的液压顶升装置压入螺旋桨轴并采用湿式无键固定法紧固。
The shape of the fuel tank is modified for vehicles with Real Time 4WD to accommodate the propeller shaft and dual exhaust pipe, yet retains the same capacity as 2WD models.
该油箱的形状修改的车辆，实时四轮驱动，以容纳传动轴和双排气管，但保留了后轮驱动车型相同的能力。
In this paper the author emphasizes the importance of balancing the rotating parts, such as crankshaft, flywheel, propeller shaft, wheel and tyre, etc. during automobile repair.
分析了汽车维修中曲轴、飞轮、传动轴、车轮、轮胎等旋转零件进行平衡试验的重要性。
A propeller shaft that has been in use for a long period of time cannot be adjusteIf the length of the propeller is incorrect and causing vibration, replace the propeller shaft.
已经使用很长时间的传动轴不能调整。如果传动轴的长度不正确并引起振动，更换传动轴。
The R. P. D. is presented in this paper. Except the usual ship model test, it is possible to carry out measurement of tests for the underwater model and multi-propeller shaft model.
本文提出的变磁阻式螺旋桨动力仪除用于水面船模试验外，并可用于水下模型及多桨轴模型试验。
Tiny deformation will appear in the local of the propeller shaft of certain ship which is endured an invariableness load, although the shaft stress is within the elastic limit range.
某舰的螺旋桨尾轴长期处在恒定载荷作用下，虽然尾轴应力在弹性极限范围内，但是尾轴局部还是很容易发生微量的塑性变形。
Tiny deformation will appear in the local of the propeller shaft of certain ship which is endured an invariableness load, although the shaft stress is within the elastic limit range.
某舰的螺旋桨尾轴长期处在恒定载荷作用下，虽然尾轴应力在弹性极限范围内，但是尾轴局部还是很容易发生微量的塑性变形。
应用推荐