The company's engineers continue to pump seawater into the reactor pressure vessel, in an effort to cool it.
为了冷却压力容器，这个公司的工程师持续地向它注入海水。
The powerful system has the capacity to propel thousands of gallons of water a minute throughout a reactor pressure vessel and storage pool.
这种强力的系统有能力在一分钟内驱动上千加仑的水流经反应堆的高压容器和储存池。
The study on flow and heat transfer in downcomer under loss of coolant accident (LOCA) is important to the safety of reactor pressure vessel (RPV).
失水事故工况(LOCA)下反应堆下降环腔内的流动和传热研究，对反应堆压力容器(RPV)的安全具有重要的意义。
One of the basic failures of reactor pressure vessel is the failure of flange sealing system, so it is very important to study the performance of its sealing system.
法兰密封失效是核压力容器的最基本失效形式之一，研究其密封性能具有十分重要的意义。
As the basic safe wall of nuclear reactor, the reactor pressure vessel not only bears high temperature and high pressure, but also contains radioactive working substance.
反应堆压力容器作为反应堆的基本安全屏障，承受高温、高压且内部包含具有放射性的工作介质。
In this paper, a solute drag model was proposed to predict the phosphorus inter granular segregation in reactor pressure vessel steels and compared with the rate theory model.
本文提出了预测核反应堆压力容器钢中杂质元素(主要是磷)晶间非平衡偏析的溶质拖拽模型，并且与速率理论模型进行了对比。
The improved transient sealing analysis program for reactor pressure vessel is applied to analyze the 1/4 structure of the model under the cool and the thermal work conditions.
应用改进后的反应堆压力容器瞬态密封分析程序对压力容器模拟体1/4模型进行了冷态和热态密封分析。
The reactor pressure vessel composed of spherical top and lower heads, upper and lower flanges, bolts, cylinder and two O-rings, as a static indeterminate system has been studied.
本文将反应堆压力壳的球顶盖、上下法兰、螺栓、筒体及双道O形环作为一个超静定系统进行了应力和变形分析。
Structural and mechanical design are performed according to the requirement on the overall design and design input for the reactor pressure vessel support of Qinshan Phase II NPP Project.
根据总体设计要求和设计输入要求，进行了秦山核电二期工程反应堆压力容器支承的结构设计和力学设计。
Neutron irradiation-induced phosphorus intergranular segregation in the reactor pressure vessel steels is the one of main reasons resulting in brittle fracture of the nuclear reactor vessel.
中子辐照引起的核反应堆压力容器钢中磷的晶间偏析是导致核反应堆压力容器脆性断裂的主要因素之一。
In the U. S., reactors shut down for refueling typically retain most of their fuel in the thick steel reactor pressure vessel that provides much more protection against a radioactive release.
在美国，如果反应堆因补充燃料而关闭，一般来说，在厚重的钢质反应堆压力容器内仍会存有大多数燃料，因为这个容器可提供更多保护，防止辐射泄漏。
To inspect the defects on the screw hole surfaces of nuclear reactor pressure vessel in nuclear power station, an automatic moving table was designed to carry sophisticated inspecting devices.
设计了能在高辐射环境下工作的、全自动检查核电站反应堆压力壳连接处法兰面主螺栓孔螺纹表面缺陷的设备，解决了自动小车的设备承载和准确定位问题。
The reactor core which includes these rods, and the water it sits in, are contained within a thick steel pressure vessel.
这些燃料棒就是反应堆的核心，它位于水中，并包裹在厚厚的钢制压力容器中。
The entire "hardware" of the nuclear reactor - the pressure vessel and all pipes, pumps, coolant (water) reserves, are then encased in the third containment.
核子反应堆全部的“硬件”——压力管，所有的管道，泵、冷冻剂(水)储备，通通放入第三个容器。
A release of pressure from the containment vessel of number 2 reactor appears to be planned.
准备计划释放2号反应堆的主安全壳内的压力。
The nuclear fuel is encased in hard alloys to construct fuel rods; the reactor core that these rods make up, and the water it sits in, are contained within a steel pressure vessel.
核燃料的形式是在硬合金包裹下的燃料棒；并且这些燃料棒放在水中，外面还有一层钢压力容器。
In reactor 1, and later in reactor 3, steam contaminated with some radioactive elements was allowed out of the pressure vessel and into the larger containment vessel that surrounds it.
在一号反应堆以及随后的三号反应堆中，受到辐射污染的蒸气已经从压力窗口中释放出来，进入了外层的容器。
The entire primary loop of the nuclear reactor - the pressure vessel, pipes, and pumps that contain the coolant (water) - are housed in the containment structure.
整个最初的核反应循环是这样的——高压管、管道、泵、冷却剂(水)——这些被安装在容器型建筑中。
Reactor 3’s pressure vessel was then treated the same way, as, eventually, was reactor 2’s.
三号反应堆的处理方式与一号相同，接着就是对于二号反应堆的处理了。
The stress distribution situation of vessel wall after self-enhancement treatment for high pressure polyethylene reactor in Maoming petrochemical company was analyzed in detail in this paper.
文中较详细地分析了茂名石化公司高压聚乙烯反应器自增强处理后器壁的应力分布状况。
This paper introduces the structure characteristics and main designing technical parameters of the pressure vessel of Tsinghua University 10mw high temperature gas cooling reactor.
介绍了10MW高温气冷实验堆反应堆压力容器的结构特征和主要技术参数。
The reactor vessel constitutes the main part of pressure boundary of primary coolant.
反应堆压力壳构成了主冷却剂压力边界的主体。
The stress distribution situation of vessel wall after self-enhancement treatment for high pressure polyethylene reactor in Maoming petrochemical company was analyzed in detail in this pa…
文中较详细地分析了茂名石化公司高压聚乙烯反应器自增强处理后器壁的应力分布状况。
Reactor 3's pressure vessel was then treated the same way, as, eventually, was reactor 2's.
三号反应堆的处理方式与一号相同，接着就是对于二号反应堆的处理了。
Reactor 3's pressure vessel was then treated the same way, as, eventually, was reactor 2's.
三号反应堆的处理方式与一号相同，接着就是对于二号反应堆的处理了。
应用推荐