The evaporator helps cool the air, the condenser helps ready the system's refrigerant for the cooling process, and the compressor helps move refrigerant back and forth between them.
蒸发器有助于冷却空气，冷凝器帮助准备冷却过程中的制冷剂，压缩机有助于制冷剂在它们之间移动来回。
The evaporator helps cool the air, the condenser readies the refrigerant for the cooling process, and the compressor moves refrigerant back and forth between them.
蒸发器帮助空气冷却，冷却器为冷却过程准备冷却剂，压缩机将冷却剂在蒸发器与冷却器之间传递。
Each evaporator shall have 2 refrigerant circuits, one for each compressor.
每台蒸发器将有2条冷却液电路，一为每台压缩机。
Refrigeration USES imported air cooling type refrigerant compressor unit.
制冷采用进口风冷式制冷压缩机组。
As its name implies, it cycles the refrigerant compressor on and off only in times of need.
正如其名称所示，它循环的制冷压缩机和关闭只在需要的时候。
The vaporized refrigerant vapor from the low temperature and low pressure, suction inlet of the compressor to be compressed, compressed and then discharged into the next cycle.
蒸发后的低温低压冷媒蒸气，从压缩机的吸气口流回，被压缩压缩后排出进入下一循环。
Replace the refrigerant line between the compressor and condenser.
更换压缩机与冷凝器之间的制冷剂管路。
The scroll compressor is commonly by sealing the refrigerant the cooling of the leak of a large amount of refrigerant, can cause to compressor cooling is not enough.
全封涡旋压缩机一般是靠制冷剂冷却的，制冷剂大量泄漏会造成对压缩机冷却的不够。
Unscrew refrigerant line fastening screw for the compressor on the pressure damper.
旋下压力风门上压缩机的制冷剂管路紧固螺钉。
Remove the refrigerant line between the compressor and condenser.
拆下压缩机与冷凝器之间的制冷剂管路。
It consists of five basic parts, the compressor, the condenser, the evaporator, the receiver, and the refrigerant flow control valve or the thermostatic expansion valve.
它由压缩机、冷凝器、蒸发器、制冷剂流量控制阀和或恒温膨胀阀五个基本配件组成。
The boot after the refrigerant compressed by the compressor from low temperature to high temperature and high pressure steam.
开机后冷媒经压缩机压缩由原来的低温低压状态变成高温高压的蒸气。
It consists of a compressor, a condenser, a throttle or expansion valve, an evaporator, and a working fluid (refrigerant).
它由压缩机、冷凝器、节流阀或膨胀阀、蒸发器，以及一种工作流体(冷冻剂)组成。
The refrigerant leaves the compressor as a hot, dense vapor and flows through a heat exchanger called the condenser, which transfers heat from the refrigerant to a body of air.
在离开压缩机时，致冷剂已变作高温、稠密的气体，流经一个被称为冷凝器的热交换器，将热量从致冷剂转换作一团气体。
Can separate compressor oil from the refrigerant and fill alternative oil.
能够把混入冷媒中的压缩机油分离，并可加入相应新油。
When a low load situation has been determined by the refrigerant system controls, the variable speed drive operates the compressor motor at lower speed mode of operation.
在制冷系统控制器确定为低负荷情况时，可变速驱动控制器以运转的较低速度模式操作压缩机马达。
The refrigerant leaves the compressor as a hot, dense vapor and flows through a heat exchanger called the condenser, which transfers heat from the refrigerant to a body of air.
出了压缩机后，制冷剂变为高温稠密的气体，流经一个被称为冷凝器的热交换器，这个冷凝器把制冷剂的热量传送到一个气团。
The tank contains compressor using freon F-12 as refrigerant, and temperature regulator for automatic controlling. It is necessary equipment for aerated water and sparkling sine production industry.
本产品采用氟利昂压缩机组，以F - 12作制冷剂，并装有压力继电器与温度调节器自动控制。是制造汽水、汽酒的配套设备。
The tank contains compressor using freon F-12 as refrigerant, and pressure sensor, and temperature regulator for automatic controlling.
本产品采用氟利昂压缩机组，以F - 12作制冷剂，并装有压力继电器与温度调节器自动控制。
This results in a much more benign forward start as less refrigerant is drawn into the compressor pump and the amount of oil pumped out of the compressor on start up is minimized.
这使得在更少制冷剂吸入到压缩机泵，并使启动时泵出压缩机的油量最小化时得到更良好的正向启动。
There is not heat exchange between the mix refrigerant entering the compressor and the mix refrigerant leaving the water cooler.
系统介绍了第一个多股换热器前高低压制冷剂之间不进行回热的典型混合制冷循环液化天然气流程的计算方法；
The drop in capacity is caused by the lessening amount of refrigerant mass moved through the compressor at one time.
加热能力的降低是由压缩机中一次流过的致冷剂质量的减少所致。
A variable speed drive is provided for operating a compressor motor in a refrigerant system.
本发明提供一种可变速驱动器，该可变速驱动器用于操作制冷系统内的压缩机马达。
Sensible heat defrost is a new defrosting method which avoids disadvantages of four-way valve reverse defrost and USES the sensible heat of hot refrigerant vapor from compressor to defrost.
显热除霜是针对四通阀换向除霜方式的缺陷而提出的一种新型的除霜方式，它是利用压缩机排出的高温制冷剂的显热对蒸发器进行除霜。
Valve motion is analyzed with different refrigerants in the compressor. It is discovered that density of refrigerant have great influence on the movement of valve.
对制冷压缩机的气阀采用不同工质时的运动规律进行了研究。
In circulatory system, the refrigerant must be convert became gas before returning to compressor.
空调循环系统中，当制冷剂回到压缩机前必须完全气化。
The speed of the compressor is varied to control the refrigerant flow rate and match the cooling load requirements of the vapor compression system.
该压缩机的速度被改变以控制该制冷剂的流速和配合蒸气压缩系统的冷却负荷需求。
It is endeavored to achieve a good performance with a small mass of the refrigerant compressor.
本发明试图使得制冷剂压缩机在质量很小时也能获得良好效率。
The pressure increases substantially as the refrigerant travels through the compressor.
制冷剂通过压缩机时，压强急剧升高。
The Auto Cascade Refrigeration Cycle (ACR) requires only one compressor with the non-azeotropic refrigerant mixture (NARM), which is very popular for its particular excellence.
自行复叠制冷循环采用非共沸混合工质作为制冷剂，而且只采用一台压缩机，正是这些独特的优点使其受到了广泛的关注。
应用推荐