Amorolfine hydrochloride ethosomes showed a slow release rate.
盐酸阿莫罗芬醇质体释放速度较慢。
In the case of constant load, the energy release rate will increase with time until it reaches a higher limit value.
在常载荷的情况下，能量释放率将随时间而增长，直到它达到某一较高的极限值。
The general solution of the electromechanical field, intensity factors and energy release rate are obtained, which are expressed in terms of series expansion.
得到了级数形式表达的电场和弹性场的基本解、场强度因子和能量释放率。
We show from in vitro release experiments that microsphere size has a significant effect on drug release rate. The initial release rate decreased with an increase in microsphere size.
从体外释放试验中可知微球大小对药物释放率有很大的作用。药物开始释放率与微球大小负相关。
In addition, mass loss rate was not the only parameter influencing heat release rate in cone calorimeter for agaric.
同时，木耳的质量损失速率不是影响其热释放速率的惟一因素。
Microsphere size, which has a significant effect on drug release rate, can potentially be varied to design a controlled drug delivery system with desired release profile.
微球大小对药物释放率有很重要的影响，人们认为可以改变其大小以建立一个药物释放符合需要能够控制药物释放的体系。
Outlier tests have no applicability in cases where the variability in the product is what is being assessed, such as for content uniformity, dissolution, or release rate determinations.
逸出值测试在正是要评估产品的变异性的情况下不适用，如含量均一性，溶解度，释放率测定。
In the case of constant displacement, the energy release rate will decrease with time, until it reaches a lower limit value.
在常位移的情况下，能量释放率将随时间而减少，直到它达到某一较低的极限值。
Objective: To study the in vitro release rate of ambroxol HCl osmotic pump controlled release tablets.
前言：目的：研究盐酸氨溴索渗透泵控释片的体外释放度。
The heat release rate is the key factor that determines fire hazards.
材料的热释放速率是决定火灾灾害的关键因素。
Some heat release rate formulas are added to the application software for calculation on the properties of the fire smoke flow in building.
将各种非稳态火源热释放速率计算式嵌入建筑物火灾烟流性状预测软件并进行了算例验证。
With time passing, decomposition rate of mulching plants and release rate of plant nutrients are slowed down gradually, but its stability varies in different plant species.
随着时间的变化，覆盖植物分解速率和养分释放由快变慢，且稳定性因植物种类的不同而存在差异。
This model is based on gas release rate and jet fire model to estimate the hazard area.
该模型是基于气体释放速率和火灾模型来估计危险影响区域的。
The need to tailor release rate profiles from polymeric microspheres is a significant problem.
需要得到多聚体微球的释放率情况，这是一个非常大的难题。
Analysis and evaluates the characteristics of typical attack scenarios from the aspects of the possibility, ability of concealment, release rate and harmfulness of the possible attacks.
从袭击发生的可能性、隐蔽性、生化制剂的释放速度和危害性这四个方面，对典型生化袭击场景的特性进行了分析和评价。
This paper presents a theoretical analysis about the propagation rule of the micro-crack in brittle materials under axial compression, based on the energy release rate criterion.
本文利用混合型裂纹扩展的能量释放率理论对脆性材料受轴向压缩时其内部微观裂纹的扩展规律进行了研究。
The measured pressure time curves indicate the obvious pressure platform effect may be achieved when electrical energy and chemical energy release rate complemented.
测得的压力曲线表明，在电能与化学能释放速率互补的条件下，可以得到明显的压力平台效应。
The strain energy release rate of the crack propagation was calculated by using virtual crack closure technique, and fatigue life was forecasted.
采用虚拟裂纹闭合技术计算裂纹扩展的应变能释放率，并对裂纹扩展寿命进行计算。
The solutions are compared with the energy release rate of linear elasticity.
解答与线弹性的能量释放率进行了比较。
The energy release rate is calculated with the boundary collocation method.
最后，用边界配置法求解了能量释放率。
The energy release rate and failure criterion for mixed mode are investigated by means of the method of equivalent linear crack extension.
利用当量直线裂纹扩展法研究复合型裂纹的能量释放率及相应的断裂判据。
Due analysis has been made and it is found that the nonlinear energy release rate of orthotropic plate with a, crack is dependent on the biaxial load factor.
本文分析双向加载下正交异性裂纹板的非线性能量率，指出所研究的裂纹板的非线性能量释放率与双向加载因子有关。
The equations of loading and bounding surfaces are described in strain-energy release rate.
加载面、边界面方程均以损伤能量释放率表示。
Based on the boundary variational theorem, the energy release quantity and energy release rate (dynamical crack extension force) along the crack boundary are obtained.
由此求得动态裂纹扩展时，沿裂纹边界的能量释放量和能量释放率(动态裂纹扩展力)。
Compared with birch leaves, mixed leaves had a significantly higher substrate quality and showed a substantially faster decomposing rate and nutrient release rate.
在同一林型内，底物质量高的混合叶片其分解率和养分元素释放率均大于底物质量低的白桦叶片；
The varying tendencies of mass loss rate, temperatures of each point, and CO concentration were all consistent with heat release rate.
质量损失速率、各点温度以及产物一氧化碳浓度变化曲线均与热释放速率曲线的变化趋势保持一致。
Methods:The release rate of ambroxol HCl osmotic pump controlled release tablets in various mediums was observed.
方法：考察渗透泵在不同介质中的释放情况。
The formulas for radiation densification, swelling, fission gas release rate and transient release are given.
给出了辐照密实、肿胀、裂变气体释放率和瞬时释放表达式。
A release rate tensor of damage strain energy is derived.
推导出损伤应变能释放率张量。
Results: Drug release rate of the tablets did not change with the change of medium.
结果：渗透泵的释药不随释药环境的改变而改变。
应用推荐