Test by minimum Vin and constant resistive load.
测试的最低输入电压和恒定电阻负载。
Resistive load, power factor: 1, special alloy resistance.
阻性负载，功率因数为1 。采用特制合金电阻。
General pulsers can obtain sharp risetime only when it is used for a resistive load.
通常的脉冲发生器只是在电阻性负载时才能得到陡的上升沿。
On Day 8, it is time to gradually build up the non-resistive load on the Magravs PowerUnit.
第8天，这段时间逐渐在能量装置上建立非阻性负载。
This paper analyzes the harmonic component of the bridge type current limiter with resistive load.
以阻性负载为例分析了桥式限流器的谐波问题。
A resistive load placed at the end of a cable to prevent data signals from reflecting back into the data path.
终结器就是置于电缆终端的一个电阻负荷，用来防止数据信号又反射回到线路中去。
Buffer amplifier An amplifier, usually in a gain of 1 or 2, used to drive a heavy capacitive or resistive load.
缓冲器放大器一种放大器，通常可以放大1到2倍，用于驱动大容量或大阻抗负载。
Feasibility of the proposed scheme is confirmed with experimental results under resistive load and rectifier load.
阻性负载及整流负载情况下的实验结果证实了该控制方案的可行性。
The simple experimental circuit contact material is designed using time relays with digital display, contactors, switchgear and resistive load.
利用数字显示时间继电器、交流接触器、断路器以及电阻性负载设计了一个简易的触头材料实验电路。
Because the bank adopts late-model components, high power density, it has not red-hot phenomena. It is pure resistive load and three-phase current balance.
本机采用新型功耗组件，功率密度高，无红热现象，为纯阻性负载，三相电流平衡。
The model uses the effective impedance of the microstrip line as the value of matched resistive load and assign it into the RL mesh region in a proper proportion.
该模型将微带线的有效阻抗作为匹配负载电阻，然后按适当的比例分布到端接面的网格中。
The experimental model designed was used to measure arc voltage and current waveforms of alloyed contact in resistive load circuit and inductive load circuit on the condition of room temperature;
应用自行设计的实验模型，在室温条件下，并在电阻性电路和电感性电路中，测量了金合金触点的电弧电压和电弧电流波形；
Practical application demonstrates that the circuit has good performance with resistive or inductive load.
实际结果表明，电路对电阻性或电感性负载均具有较好的控制性能。
Pulse width modulation is used to reduce the total power delivered to a load without resulting in loss which normally occurs when a power source is limited by a resistive element.
脉宽调制技术是用来降低总功率交付给了负荷，没有造成损失，这是通常发生时，电源是有限的，由电阻芫件。
Pulse width modulation is used to reduce the total power delivered to a load without resulting in loss which normally occurs when a power source is limited by a resistive element.
脉宽调制技术是用来降低总功率交付给了负荷，没有造成损失，这是通常发生时，电源是有限的，由电阻芫件。
应用推荐