The pulley on the clutch can be easily changed to alter the rotor speed.
很容易调整离合器上的滑轮来改变璇筒的速度。
Rotating drive Experiment: Testing the rotor speed under the open-loop driving.
旋转驱动实验：测试了开环驱动作用下转子转速。
Restricting the engine maximum rotor speed based on nonlinear forecast was studied.
研究对发动机最大转速进行非线性预测限制的方法。
From the point of energy saving, change the rotor speed control is the most effective.
从节能角度讲，改变转子转速调节是最有效的。
Simultaneously, rotor speed can be calculated indirectly by using the position signals.
同时，利用转子的位置信号，还可以间接地计算出转速。
OPTIPACT motion sensors are compact, robust and ideal for primary or backup rotor speed regulation.
OPTIPACT运动传感器结构紧凑，稳健，是主要的或备用转子速度调节的理想选择。
The adjustable model contains the information of rotor speed and a current model rotor flux observer.
可调模型包含电机转速的信息和一个电流模型转子磁链观测器。
If the rotor speed is close to the frequency of the rotor system, the resonance phenomenon will occur.
假设转子的转速与其轴系本身的频率比较接近时，设备将会出现共振现象。
The rotor flux orientation method of induction motors is based on the feedback of rotor speed and position.
异步电机转子磁场定向控制依赖于电机转子角速度的反馈和位置测量。
For reducing whirling the radial sampling period must be suitable to the rotor speed not excessively short.
为减小涡动，转子径向采样周期应与转速相适应，不宜过快。
The factors, the length of shock tube, the distributor rotor speed and the ratio of gas expanding, which affect the…
同时，对振荡管长度、气体分配器的转速等影响脉管式气波制冷机性能的因素进行了试验。
The creation process of Kinetic equation considers the impact of rotor speed and bearing rigidity change on the system.
动力学方程的建立过程中考虑轴承刚度变化和转子转速对系统的影响。
Under operating condition, the effect of rotor speed on low-order frequencies is stronger than that on high-order frequencies.
在工作状态下，转速对低阶频率的影响大，对高阶频率的影响则比较小。
Then, the structure and dynamic models of improved constant rotor speed control system using electric field method are proposed.
在此基础上，提出了改进后的球形转子电场恒速控制系统的结构和动态模型。
The effect of cure temperature and rotor speed on rheological properties for epoxy resin matrix by torque rheometer are studied.
用转矩流变仪研究了温度、转速对环氧树脂基体固化性能的影响。
According to the input constraints and control objective, the roll control algorithm of rotor speed forecast restriction was proposed.
根据输入约束和控制目标，提出转速预测限制的滚动控制算法。
When the body length to 6 times the diameter of the above, the rotor speed will close to the critical speed motors, operation of vibration may occur.
当本体长度达到直径的6倍以上时，转子的第二临界速度将接近于电机的运转速度，运行中可能发生较大的振动。
The results showed that the range of the region of phase co-continuity PS/PA6 was 40/60-65/35 at experimental temperature, rotor speed or mixing time;
结果表明在一定螺杆转速、共混温度、共混时间范围内，PS/PA6共混物形成双连续相组分的比例范围为40/60—65/35；
In the process of rotor speed identification, the variable parameters PI mechanism, which has good dynamic and static performance and robustness are used.
在转速辨识过程中，应用了具有较好动态性能和鲁棒性的变参数PI算法。
The dynamic deflection may become very large due to resonance in case of the flexible rotor speed approaching or exceeding its 1st or 2nd order critical speed.
而挠性转子在接近或超过其第一、二阶临界转速时，转子处于共振状态，这时动挠度达到很大的数值。
The effects of different compounding conditions (rotor speed and feeding rate) on the interlamellar space and mechanical properties of the composite were analyzed.
分析了不同工艺条件(主要为转子转速和喂料速率)对复合材料层间距及其力学性能的影响。
A speed sensorless vector control system of induction motor with estimated rotor speed and rotor flux using a new reduced order extended Kalman filter is proposed.
提出一种估计异步电机转子速度和转子磁链的新型降阶推广卡尔曼滤波器算法，建立了基于此算法的异步电机无速度传感器矢量控制系统。
A self - calibrating algorithm for rotor field - oriented control only using measurements of the stator currents and rotor speed of an induction motor is parented.
介绍感应电动机矢量控制系统中转子磁场定向的一种自校准算法。
Results show that damping moment modulus of damper with given size and liquid medium is almost constant and basically in direct proportion to square of rotor speed.
研究结果表明，结构尺寸、液体介质密度确定的阻尼器的阻尼力矩系数接近一常数，阻尼力矩基本上与阻尼器的转子转速的平方成正比；
Blades are turned, or pitched, out of the wind to control the rotor speed and keep the rotor from turning in winds that are too high or too low to produce electricity.
叶片打开，或定，出于对风的控制转子的速度和保持转子从转折，在风是太高或太低，以产生电力。
The model inputs include the fuel flow, the nozzle area, the altitude and Mach number, and model outputs include the rotor speed, the temperature and the air pressure.
模型的输入量包括燃油流量、喷口面积、高度及马赫数，输出量则包括高、低压转子的转速及各截面的温度和压力。
The results showed the higher the output was, the shorter and narrower the residence time and distribution would be, while the rotor speed had little influence on RTD.
结果发现：混炼机产量越大，停留时间越短，分布曲线的分布越窄；而混炼机的转速对停留时间分布的影响不大。
The rotor speed observer takes the outputs from the second current observer and the rotor flux observer as its inputs and generates the estimated rotor speed as the output.
转子磁链观测器以两个电流观测器和速度观测器的输出作为输入，估计转速反馈到第二个电流观测器和转子磁链观测器。
The rotor speed observer takes the outputs from the second current observer and the rotor flux observer as its inputs and generates the estimated rotor speed as the output.
转子磁链观测器以两个电流观测器和速度观测器的输出作为输入，估计转速反馈到第二个电流观测器和转子磁链观测器。
应用推荐