She produced a clipboard with a sheet of ruled paper attached.
她制作一个夹着一张横格纸的剪贴板。
To take notes effectively, choose a sheet of loose, clean, lined paper, preferably college-ruled.
为了做出来的笔记有效果，你要选择活页、干净的横格纸，最好是学校用的横格纸。
In this paper, the motion rules of multiple spindle linkage motion in machining complex ruled curved surfaces by WEDM was analyzed.
开发了能实现复杂曲面零件电火花线切割加工的多轴联动加工系统。
Run through: Ruled lines run across or down the sheet from one edge of the paper to the other without breaks.
通栏画线：画线时，线条从纸的一边画到另一边，或从纸头画到纸尾而不中断的情况。
This paper gives a method to measure in-plane strain of skew ruled surface shell by using Moire interferometry of sticking film method.
本文首次提出了应用贴片云纹干涉法和变栅距光栅来测量不可展壳体表面面内位移和应变的方法。
A device for trimming paper to desired dimensions, typically a ruled board with a long pivoted cutting knife attached to one side.
裁纸刀，切纸机：一种把纸张裁剪到所需尺寸的器具，通常有一个一旁装有一把有转轴的长裁剪刀的直边。
To avoid paper maoba, ruled than perpendicular to the knife; in working life, short front than Kao Hong knife.
在避免纸毛方面，直纹刀比横纹刀好；在使用寿命上，矮锋刀比高锋刀好。
The paper introduces the principle of tool paths planning for machining ruled surface.
阐述了数控加工规则曲面时的刀轨生成原理。
Ruled-paper: paper with horizontal lines for writing.
单行纸：有着横线的书写用纸。
This paper explores three ruled surfaces geometry properties about columnar surface, cone surface and hyperbolic parabobid.
研究建筑上常用的柱状面、锥状面和双曲抛物面等不可展直纹曲面的几何性质。
In this paper, it is presented that the locus of a line crossedwith each of two guide lines and a guide conic not being on a commonplane is a ruled surface of fourth order.
本文提出了由一条二次曲线和与该二次曲线不共面的两条异面直线为导线，与该三导线均相交的直线轨迹是一个直纹四次曲面，并讨论了二次曲线分别为椭圆、双曲线和抛物线时，形成的曲面的形状特征。
Ruled-paper paper with horizontal lines for writing.
有着横线的书写用纸。
Based on the description of fitting warped blade surface with ruled surface, the locus of cathode is induced by rigid body transfer in this paper.
在阐述用直纹面拟合扭曲型面的基础上，用刚体变换的方法推算出阴极的控制轨迹。
Based on the description of fitting warped blade surface with ruled surface, the locus of cathode is induced by rigid body transfer in this paper.
在阐述用直纹面拟合扭曲型面的基础上，用刚体变换的方法推算出阴极的控制轨迹。
应用推荐