The condition of applied voltages for pinched sample injection was optimized.
通过实验优化了夹流式进样的电压条件。
The liquid-phase sample injection valve ensured the sampling reproducibility.
使用液相进样阀液态直接进样保证了试样的代表性。
In this article the theory, detection, sample injection of HSCE and its application in various fields are introduced.
本文着重介绍了高速毛细管电泳技术的理论、进样方法、检测器及其在各个领域的应用。
A simple sample injection technique which can he considered as a simplification of cold on-column injection has been proposed.
本文提出了一种简化的毛细管色谱“冷柱上进样”技术并对其性能进行了研究。
The effect of SDS concentration, sample matrix, water injection time, sample injection time and sample injection voltage were optimized.
讨论了SDS浓度、样品基体、进样电压、进水时间和进样时间对富集和分离的影响。
Applying backflushing helps maintain the GC and the MS source by removing later eluting compounds from the column before reaching the MS, and prior to the next sample injection.
应用反吹技术可以在下一个样品进样之前，直接除去柱中的后洗脱化合物以防止其进入质谱仪，从而帮助我们保持气相色谱和离子源性能。
This article's sample GWT application (see Download) USES a handy GWT feature: automatic resource injection.
本文随带的示例GWT应用程序(参见下载部分)使用了一个简单的GWT特性，即自动资源注入。
In Christophe's sample application he shows the Spring like syntax for injection.
在Christophe给出的示例应用中，他介绍了如何使用类似于Spring的语法进行注入？
In the analysis, pretreatment of digestion is not needful. The injection of urine sample was composed of urine sample and 2 perceut nitric acid half and half.
本法对尿样不经消化前处理，用2％硝酸对倍稀释后直接进样于石墨炉中进行分析测定的基础条件和铬在尿中的稳定性进行了研究。
An automated sequential injection system incorporating a sample pretreatment module was developed for the separation and preconcentration of ultra-trace copper in seawater without dilution.
将样品预处理模块与自动化顺序注射系统相结合，建立了未经稀释的海水中痕量铜的分离富集方法。
The effects of current velocity, sample volume, length and inside diameter of reaction pipe and shape on the dispersion of flow injection analysis system were in detail discussed in this paper.
本文详细地探讨和研究了载流速度、进样体积、反应管长度、内径与形状等因素对分散度的影响。
In the determination of total nitrogen in water sample by flow injection analysis instrument, the concentration of sulfuric acid which used for the preservation of sample affected the result.
用流动注射仪测定总氮水样，发现用不同的硫酸浓度保存总氮样品时，对其测定结果有一定的影响，并与过硫酸钾氧化-紫外分光光度法进行比对和分析。
The sample and hold circuit is employed by the bottom plate sampling technique, which could not only cancel the charge injection error but also eliminate the effect of clock feed-through.
采样保持电路设计采用了电容下极板采样技术，不仅有效地避免了电荷注入效应引起的采样信号失真，而且消除了时钟馈通效应的不良影响。
The analyser or sensing unit contains the sample - injection valve.
分析和传感单元内有注样阀。
Depending on the type of LC, check whether you have a no-waste injection mode or partial loop fill. Obviously the firse option is preferred as this prevents using more sample than actually injected.
根据液相色谱仪的型号，确认配备的是“不浪费样品进样方式”或“部分充满定量环进样方式”。
A method of determining trace bromate in drinking water by an ion chromatograph was established with direct injection and conductivity detection but without sample pre-treatment.
建立了一种无需样品前处理、直接进样、电导检测饮用水中痕量溴酸盐的离子色谱分析方法。
Several important factors are discussed, such as buffer systems, terminating ions, column effective length and injection time of sample and terminating solution.
详细讨论了影响富集的缓冲体系、尾随离子种类、毛细管有效长度、进样时间和等速电泳时间等重要因素。
The Fe and Zn in rehmannia root were determined by FAAS using flow-injection suspension pulse sample introduction method.
以流动注射悬浮液脉冲进样——火焰原子吸收光谱法进行了中草药生地中铁和锌元素的测定。
Through the rheological behavior of the analysis, using injection molding technology system to its mechanical properties of the sample for analysis.
通过对流变性能的分析，采用注射成型工艺，制出样条对其力学性能进行分析。
When it was applied in sample analysis, bupivacaine was successfully separated and determined from the rat plasma after drug injection, and its concentration monitoring in plasma was carried out.
在样品分析中，成功分离测定了注射药物的大鼠血浆中的布比卡因，实现了布比卡因血药浓度的快速监测。
The objective of this dissertation is to develop on-line sample preparation procedures based on membrane extraction and flow injection (FI) techniques.
第二部分研究了几种流动注射（FI）在线样品前处理技术，为FI应用于日常分析提供了新的思路和途径。
The intermittent injection desolvation method is used to accumulate the sample onto the graphite furnace surface.
本文所讨论的电热雾化法是采用继续喷洒去溶技术，使试样在石墨炉表面逐步积累的进样方法。
For example, the characteristics of data acquisition system for sample oil pressure signal of an injection system are of high speed, and special synchronization.
如对喷油系统油压信号的采集，即需要具有高速采集数据的性能，又要能满足特殊同步的要求。
Anionic surfactant (as) in water sample was determined rapidly by flow injection analysis with an on-line extraction functional module.
采用在线萃取预处理功能模块，配合流动注射分析法对水体中阴离子表面活性剂进行了快速测定。
Objective: to study the interference of Diammonium Glycyrrhizinate Injection in bacterial endotoxin test and to establish a bacterial endotoxin test method for the sample.
前言：目的：研究甘草酸二铵注射液对细菌内毒素检查实验的干扰情况，并建立其细菌内毒素检查的质量标准。
The traditive method of blood circulation sample made by injection of genural colour showed expensive time and labour.
血素注射标本常用的色剂及注射方法费时费事。
The effect of chemical reaction on Sample dispersion in flow injection analysis has been verified experimentally on the basis of tanks-in-series model and statistical moment analysis.
根据串联釜模型和统计矩分析法，通过实验证实了化学反应对分散度的影响；
The effect of chemical reaction on Sample dispersion in flow injection analysis has been verified experimentally on the basis of tanks-in-series model and statistical moment analysis.
根据串联釜模型和统计矩分析法，通过实验证实了化学反应对分散度的影响；
应用推荐