The self-excited vibration system consists of a(C. E. T. ) unit, one-way air-inlet valve and one-way fu…
燃烧室-喷管，进气单向阀和进油单向阀组成一个自振系统；
The micro crack behavior in ice is the key factor for describing and explaining ice-induced self-excited vibration.
冰内部的微裂纹行为是解释与描述冰致自激振动的关键要素。
Then transition velocity of self-excited vibration and continuous crushing is got bu the model of saw-tooth force function.
最后，根据锯齿型冰力模型得出自激振动与连续挤压破坏发生的转变速率。
The formation of fluid dynamic force and the occurrence of self-excited vibration and oil film vortex of rotor system are analyzed.
分析了转子轴承系统中流体动态力的形成和自激振动的产生与油膜涡动、油膜振荡的故障。
In order to further investigate the mechanism and build model of self-excited vibration, it is necessary to study the mechanism of DBT.
为了明确自激振动的产生机理，建立力学模型，必须研究韧脆转变机制。
Analysis of the mechanism of coal breaking by self-excited vibration water-jet; discussion on the influence of several parameters on pulverizing efficiency.
分析了自激振荡水射流超细粉碎系统对煤粉颗粒的粉碎机理，讨论了影响粉碎效率的几种因素。
Previous studies have demonstrated that self-excited vibration occurred during the ice speed at which ice fails in ductile-to-brittle transition (DBT) range.
分析表明，冰致平台自激振动发生在冰的韧脆转变的冰速范围内。
The conceptions of balance point, limited cycle and their stability are introduced as the basis of the author's discussion on the properties and mechanism of self-excited vibration.
引入平衡点、极限环及其稳定性的概念，以此为基础我们讨论自激振动的特点和机制。
It is well-known that machining efficiency doesn't depend on the machine power and the load which machine can bear, but depends on the condition in which self-excited vibration appears.
机床的切削效率往往不是由机床的功率、机床所能承受的最大载荷所决定，而是由机床切削时发生自激振动的条件所决定。
In magnetically suspended control moment gyroscope (CMG), self-excited vibration of high-speed rotor is one of principal factor which effects stability of active magnetic bearing (AMB) system.
磁悬浮控制力矩陀螺(CMG)中转子一阶弹性模态自激振动是影响磁悬浮高速转子系统稳定性的关键因素之一。
Vortex also called left turn, is the axis of rotation happened a self-excited vibration, it is neither has the free vibration characteristics, also do not belong to the type of forced vibration.
涡动又称甩转，是旋转轴发生的一种自激振动，它既不具有自由振动的特征，也不属受迫振动的类型。
This paper, based on Self-excited vibration not taking place, introduce and probe into the method of checking the rigidity of spindle System of lathe. The program checking the rigidity is given.
本文介绍和探讨了车床主轴组件在不发生自激振动条件下的刚度校核方法，编制了校核主轴组件刚度的计算机程序。
It is posed that angular air-hammer self-excited vibration and half frequency wobble self-excited vibration are two reasons for resulting angular wobble self-excited vibration for gas film face seals.
提出造成气膜端面密封角向摆动自振的内在机理，既有半频摆动自振又有角向气锤自振。
Fifth-octave mode chatter is most likely to occur in the form of self-excited steady vibration.
轧机第五倍频程颤振表现为高频微幅的自激稳态振动。
In this paper, the mechanism of the self excited vibration in wheeled vehicle powertrain was studied.
研究了轮式车辆动力传动系自激振动的机理。
This paper analyses the reason that causes the self excited vibration by ultrasonic lathe, meantime the measure to reduce the self excited vibration is discussed in this paper.
分析了超声振动车削中产生自激振动的原因，并提出了减小自激振动的措施。
Whenthe discharge is higher than a certain value in a branch pipe, on self - excited vibration will produce.
在分支管路中，当分支管中的流量大于某一值时，自激振动就不会产生。
At last, it is put forward that the severe self-excited torsional vibration due to any range of initial slip rate can be avoided by increasing the torsional damping of the driveline.
最后，提出通过增加传动系扭转阻尼来防止在任何初始滑转率下发生剧烈的扭转自激振动的措施。
The cause of severe vibration is the formation of a self-excited vibrating system by the joint of the gap jet and turbulent flow downstream the gate.
闸门产生强烈振动的主要原因是闸门侧缝射流和下游紊动水流汇合后在门侧形成了自激振荡系统的结果。
Self excited oscillation in turning process is a kind of unstable phenomenon resulting from former vibration trace. Eliminating of the phenomenon is a key technology in cutting process.
车削过程自激振荡是一种以残留振痕作为机械延时反馈造成的动态失稳现象，消除这一现象是机械加工过程中的技术关键之一。
There is increasing evidence of the self-excited mechanism in ice-induced structural vibration both from the field measurements and laboratory tests.
用自激振动理论说明由冰引起的结构振动现象已得到越来越多的现场测试和模型实验的印证。
The exact solution of linear, undamped forced vibration response is developed, and the damped forced vibration as well as the self-excited oscillation are obtained numerically.
推导了弹性轴向行进索无阻尼线性受迫振动解，用数值方法求得有阻尼行进索受迫振动和自激振动响应。
Numerical solutions denote that the amplitude of the self-excited torsional vibration is related to the initial slip rate.
数值计算表明，自激振动的振幅与初始滑转率相关。
Numerical solutions denote that the amplitude of the self-excited torsional vibration is related to the initial slip rate.
数值计算表明，自激振动的振幅与初始滑转率相关。
应用推荐