The transverse shear deformation effect is included by use of Mindlin-Reissner first-order shear deformation theory.
分析了计及高阶横向剪切变形的正交各向异性弹性板自由振动的问题。
The numerical examples show that the present delamination model is more accurate than those based on the classical theory and the first order shear deformation theory.
算例表明该模型较之基于经典理论和一阶剪切变形理论的脱层模型精度显著提高。
The Gaussian radial basis functions and first-order shear deformation theory are presented to calculate the natural frequencies of generally laminated composite plates.
采用高斯径向基函数和一阶剪切变形理论对普通复合材料叠合板的固有频率进行了计算。
The results show that the solution of differential equations' MWR is successful, and the precision of the shear deformation theory of cylindrical shells is satisfactory.
结果表明：本文提出的控制微分方程的加权残值法解是成功的；而且圆柱壳的剪变形理论有满意的精度。
Based on the first order shear deformation theory and Hamiltonian principle, the governing equations and boundary conditions of rotating multi-layer annular plate were derived.
基于一阶剪切变形理论和哈密顿原理，建立了旋转层合圆板动力学运动方程和相应的边界条件。
This paper set out from the high order shear deformation theory at first, and utilize the spline finite point method to set up a new dynamic model of piezoelectric intellectual plate.
本文首先从高阶剪切变形理论出发，利用样条有限点法，建立了压电智能层合板新的动力模型；
General analytic solutions for transverse bending of anisotropic rectangular plate using first order shear deformation theory is obtained at the first time by the complex series method (CSM).
采用复级数方法首次建立了基于一阶剪切变形理论的各向异性矩形板横向弯曲一般解析解。
This chapter shows some laminate theories such as the Classical Plate Theory and the first Order Shear Deformation Theory and the High Order Shear Deformation Theory and it's simple forms firstly.
介绍用于复合材料层合板理论计算的经典层合板理论、一阶剪切变形理论以及高阶剪切变形理论及其各种简化形式，重点介绍了前两者理论。
The deformation and stress condition of the micro-composite are studied according to the shear-lag theory and strain-hardening law.
按照剪切滞后理论和应变硬化规律，研究微复合材料的变形和应力状态。
Based on the first-order shear deformation plate theory, axisymmetric governing buckling equations are derived for a functionally graded material circular plate subjected to in-plane pressure.
基于一阶剪切变形板理论，推导了功能梯度材料圆形板在边界面内均布压力作用下的轴对称屈曲方程。
The elastic plastic deformation and stresses of the micro composite are studied according to the shear lag theory and strain-hardening law.
按剪滞理论和应变硬化规律研究微复合材料的弹塑性变形和应力状态。
Using the Simple High order Shear Deformation Laminate Theory and large deformation theory, the geometric nonlinear analysis of rubber rectangular composite laminate plate is presented.
文中应用简单高阶剪切层合理论和大变形理论对各向异性纤维增强的矩形橡胶复合材料层合板进行了几何非线性分析。
Considering the deformation of short cylindrical tank under the horizontal earthquake action, the shear effect is the main factor, therefore, it might be anal zed by shear beam deformation theory.
考虑到在水平地震作用下短圆柱形容器的变形，剪切效应起主导作用，因而可用剪切梁变形理论来近似地代替。
The vibration frequency of box gird is usually calculated by the elementary beam theory, but it will lead to a large error because of the existence of shear lag effect and shear deformation.
由于剪力滞效应及剪切变形的存在，箱梁的弯曲振动频率按照初等梁理论计算往往存在较大的误差。
The theory of calculating deformation texture on condition of cross shear rolling was introduced.
本文系统地阐述了异步轧制剪切变形条件下板材冷轧织构的模拟计算理论；
The finite deformation theory is applied to investigate the effects of boundary condition and loading speed on shear band localization of normally consolidated Fujinomori clay.
基于有限变形理论，研究了正常固结藤森黏土的边界约束效应和加载速度效应。
Dislocation theory can be used to describe the shear deformation mechanism of wet and soft soils.
可借助位错理论的某些方法来阐述湿软土壤的剪切变形机理。
Based on the basic concept and calculating theory suggested newly, the deformation calculating theory related to pure compression state and shear compression state of isolating bearing is established.
基于纯压缩原点竖向刚度和偏压原点刚度理论，提出了预测橡胶座压缩变形量的计算理论。
The deformation and interfacial stress of fiber and matrix are analyzed based on the linear elastic method and shear-lag theory.
通过采用线弹性理论和剪滞理论，对纤维和基体的变形及其界面应力进行了分析。
The finite deformation theory and the Nakai's sub-loading constitutive model are used to investigate shear band localization in plane strain model tests.
基于有限变形理论和中井的下负荷面本构关系模型，研究了平面应变试验中黏土试样变形的局部化问题。
The finite deformation theory and the Nakai's sub-loading constitutive model are used to investigate shear band localization in plane strain model tests.
基于有限变形理论和中井的下负荷面本构关系模型，研究了平面应变试验中黏土试样变形的局部化问题。
应用推荐