Due to lack of data and address parallel bus on TMS320F2808, the two DSPexchange data by means of communication through SPI interface.
由于采用的TMS320F 2808不具备数据总线与地址总线，两个DSP之间采用SPI串行通讯的方式实现数据交换。
This interface can be used to data exchange with peripheral apparatus for processor and controller which have not SPI interface function.
通过该方法的介绍，使得那些没有SPI接口功能的处理器和控制器能够扩展SPI接口，以便同外部设备进行数据交换。
DSP based F28335 AD2S1210 serial communication program, the use of software simulation SPI interface for communication, tested available.
基于DSP F28335的AD2S1210的串行通信程序，采用软件模拟SPI接口进行通信，经测试可用。
MPC850 SPI interface drive is an example of procedures, but also practical application under specific circumstances and conditions changed.
MPC850的SPI接口的驱动，是一个范例程序，实际应用中还要根据具体环境和条件加以修改。
Customers can achieve higher frame rates for the sensor with windowed or sub-sampled readout modes, and can program the sensor's Settings over an SPI interface.
客户可以实现具有更高的帧速率传感器窗口或子采样读出模式，并可以通过SPI接口方案传感器的设置。
The STHR01 is a MCU based temperature and relative humidity sensor module, comprising a SPI interface (master mode) for direct temperature and humidity read out.
该STHR01是一款基于温度和相对湿度的传感器模块，包括一个SPI接口（主模式）为直接的温度和湿度读出。
It is available reading some configuration information required by control process from external FLASH memory through SPI interface and writing data records in the memory.
控制过程中所需的一些配置信息可通过SPI接口从外部FLASH存储器读取，所需记录的数据也可写入该存储器中。
On the system software design aspect, I use current protocol, API function and source code to code a SPI interface software, data transmit program, system test program and configuring software on PC.
在系统软件设计方而，利用现有协议、API函数和源代码，编制了SPI接口软件、数据传输程序以及PC机配置软件等。
Using the JDBC service provider interface (SPI).
使用JDBC服务提供程序接口(SPI)。
The Connector's service Provider interface (SPI) just so happens to closely match the services provided by the JDBC interfaces.
连接器服务提供者接口(The Connectors Service Provider Interface,SPI)恰好和JDBC接口提供的服务紧密配合。
JSSE is architected such that it provides for two sets of interfaces: one is referred to as the Service Provider interface (SPI) and the other one is an Application Programming interface (API).
将JSSE这样架构以便其能够提供两套接口：一套被称为服务提供方接口(Service Provider Interface,SPI)，而另一套是应用程序编程接口(Application Programming Interface, API)。
While an interface from the battery system to the main can bus may be desirable, SPI or I2C communications can be advantageous within the battery pack.
尽管从电池系统到主CAN总线有一个接口也许是可取的，但在电池组内部，SPI或I2C通信是有利的。
A single microcontroller controls the entire stack of battery monitors via the SPI-compatible serial interface, and it also is the gateway to the main CAN bus.
单个微控制器通过spi兼容的串行接口控制整组电池监视器，该微控制器也是至主CAN总线的网关。
The PAM service modules are a set of dynamically loadable objects invoked by the PAM-SPI (PAM-service provider interface) to provide a particular type of user authentication.
PAM服务模块是一组动态可加载对象，PAM -SPI (PAM - serviceproviderinterface)可以调用它来提供某种类型的用户验证。
The PUMA Service Provider Interface (SPI) is used by portlets and portal applications to obtain information about portal users and groups.
Portlet和门户应用程序使用PUMA服务提供程序接口 (SPI)获取关于门户用户和组的信息。
In this last part of the series on the WebSpherer portal V5.1.0.1 programming model, we covered some of the more advanced portal API's that fall under the System programming Interface (SPI) category.
这是关于WebSphererPortalV5.1.0.1编程模型系列文章的最后一部分，在此部分中，我们介绍了一些属于SystemProgrammingInterface (SPI)类别的更高级门户API。
Model Service Provider Interface (SPI).
模型服务提供程序接口(SPI)。
PUMA Service Provider Interface (SPI).
PUMA服务提供程序接口(SPI)。
At last, this paper provides initialized program of SPI and interface program between FRAM and DSP.
最后，文章给出了SPI模块初始化程序及DSP与FRAM之间接口程序设计。
Programming for setup and control is accomplished using a 3-bit SPI-compatible serial interface.
设置与控制的编程利用3位SPI兼容串行接口来完成。
This paper presents a design of human computer interface based on SPI-bus module ZLG7289A.
本文介绍了基于SPI总线模块ZLG7289A的人机接口设计。
The key points lies in interface resolve method in hybrid voltage-logic design, A/D sampling circuit, SPI communication port and the protect of the main circuit.
然后分别介绍控制电路和主电路设计原理与思路，重点论述了混合电平逻辑设计中的接口解决方案、A/D采样电路、SPI通讯接口电路及主电路的保护等；
The device includes a sensing element and an IC interface that communicates through I2C or SPI from the sensing element to the application.
该装置包括一个传感元件和IC的界面，通过I2C或SPI从感测元件的应用进行通信。
Taking W77E58 and MAX3100 as example, the paper introduces a method of using I/O interface of singlechip to simulate Serial Peripheral Interface (SPI) at first.
以W77E58和MAX3100芯片为例，首先介绍了一种利用单片机I/O接口软件模拟串行外设接口（SPI）的方法。
A dual communication interface with USB and SPI is designed to make the system more scalable.
USB和SPI双通信接口的设计使系统更具有可扩展性。
SPI now is one of the very fashioned series synchronous interface.
SPI接口是现在很流行的一种同步串行接口。
The Serial peripheral Interface is a sort of technology with high speed and efficiency, which makes the SPI device convenient in data communication.
SPI接口技术是一种高速，高效的串行接口技术，因而SPI设备在数据通信中应用十分方便。
The serial peripheral interface (SPI) is a standard communication protocol, which is used in many fields.
串行SPI通信协议是一种标准的通信协议，很多场合下都是采用这种机制。
The serial peripheral interface (SPI) is a standard communication protocol, which is used in many fields.
串行SPI通信协议是一种标准的通信协议，很多场合下都是采用这种机制。
应用推荐