Analyzes reasons for tube blasting of steam superheater and recommends a kind of tube material which can better satisfy production requirements.
通过对蒸汽过热炉爆管原因进行分析，提出一种更能满足生产需要的炉管材料。
In this paper, the structure of steam superheater (a BA701) lining, its installation method and points for attention during installation are introduced in detail.
本文详细地介绍了某厂蒸汽过热器(a—ba70 1)衬里的结构、施工方法及施工中的注意事项，对结构相同或相似衬里的施工有着指导意义。
After the steam superheater was connected in series with a set of flue gas cooler, not only solved the above mentioned problems, but also made full use of flue gas surplus heat.
与蒸汽过热器串联一台烟气冷却器，不仅解决了上述问题，还充分利用了烟气多余的热量。
After the steam superheater was connected in series with a set of flue gas cooler, not only solved the above mentioned problems, but also made full use of flue gas surplus he...
与蒸汽过热器串联一台烟气冷却器，不仅解决了上述问题，还充分利用了烟气多余的热量。
The sootblower system shall operate with superheated steam. The steam shall be taken from the superheater outlet piping down-stream of the Purchaser's flow element.
吹灰器系统应与过热蒸汽配合工作。该蒸汽来自买方流量计的过热器出口下游管道。
Measures should be taken to prevent the vertical snake tube from steam binding, iron oxide depositing, and austenite corrosion when superheater is cleaned.
过热器整体清洗时，应有防止垂直蛇形管产生汽塞、铁氧化物沉淀和奥氏体腐蚀的措施。
The paper describes the modeling and adaptive control of a superheater. Digital simulation shows the feasibility of the adaptive controller for the steam temperature control of a superheater.
本文用多种方法建立了热电厂过热器的数学模型，还设计了过热蒸汽温度的适应控制器。仿真结果表明，用适应控制器控制过热蒸汽温度是可行的。
For manufacture wall panel, economizer, reheater, superheater and steam pipeline of boilers.
用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。
In front of the feed water regulator, split, economizer, superheater export, between superheater outlet and main steam valve, to heat the import and export, all should be installed pressure gauge.
在给水调节阀前、可分式省煤器出口、过热器出口、过热器出口与主汽阀之间，再热气进出口、都应装设压力表。
Open the add volume should be slow to be careful, be well ahead of the superheated steam temperature of superheater tube wall temperature adjustment to strengthen supervision.
开大添加风量时应缓慢当心，应超前做好过热汽温调整加强对过热器管壁温度监督。
This paper introduces the steam temperature deviation in the superheater system of 600mw tangential firing boiler and also introduces the reasons to cause these steam temperature deviations.
阐述了四角切向燃烧600MW锅炉过热器系统蒸汽温度分布特性，分析了这种温度分布特性产生的原因，并提出了解决过热器系统存在的蒸汽温度偏差的措施。
The practical experience shows that in the light of steam purging for supercritical once-through boiler, the superheater and reheater disturbance coefficients can reach 1.0 and 1.6 respectively.
利用减温水控制过热器和再热器出口温度以防止超过材料温限。实践证明，对超临界直流锅炉采用投粉稳压冲管过热器、再热器冲管系数可达1.0和1.6以上，效果良好。
The practical experience shows that in the light of steam purging for supercritical once-through boiler, the superheater and reheater disturbance coefficients can reach 1.0 and 1.6 respectively.
利用减温水控制过热器和再热器出口温度以防止超过材料温限。实践证明，对超临界直流锅炉采用投粉稳压冲管过热器、再热器冲管系数可达1.0和1.6以上，效果良好。
应用推荐