The values are strength parameters under fixed flexure rather than Max. Strength according to the latest testing standard of 1998.
改值为定挠度下的强度值，不是最大的强度值，根据1998年的最新测试标准。
For testing the tensile strength and flexure strength of wire.
用于检测金属线材的抗拉强度，及弯曲试验。
The key of calculating flexure strength of UPPC beam is to determine unbounded prestressed tendons ultimate value when the components are under their ultimate load ability.
计算UPPC梁(板)的抗弯强度，关键是确定构件在极限承裁能力时无粘结预应力筋的极限应力值。
The influence of compounding polypropylene fiber and expansion on flexure strength, impermeability and the shrinkage deformation is studied.
研究了聚丙烯纤维和微膨胀复合对混凝土抗折强度、抗渗性和收缩变形的影响。
To use WD-10A all-powerful material test machine and XJ-4 nonmetal material impact instrument to measure flexure strength and impact strength of denture base.
用WD - 10 A型万能材料试验机和XJ - 4型非金属材料冲击试验机测试义齿基托的挠曲强度和冲击强度。
The fracture toughness of the composite was increased 62% with little decrease of flexure strength when compared with mullite monolithic ceramics.
与块体莫来石陶瓷相比，在保证材料强度降低较小的情况下断裂韧性提高了62%。
Conclusion the molecular weight and the distribution of molecular weight of denture base powder obviously affect flexure strength and impact strength of denture base.
结论牙托粉的分子量和分子量分布对义齿基托的挠曲强度和冲击强度有较大影响。
The molecular weight of the third material is the smallest, It's flexure strength and impact strength are low.
分子量最小的第三种材料其挠曲强度和冲击强度都最低。
This paper presented a method of strength calculation and strength check of annular and circular section in flexure and eccentrically compressed component for reinforced concrete structure.
论述钢筋混凝土结构环形截面及圆形截面受弯构件、偏心受压构件强度计算和强度复核的计算方法。
With the increase in ha content, the flexural strength and flexure modulus of composites had been greatly increased and the tensile strength of composites had only a little change.
随着复合材料中ha含量的增加，材料的弯曲强度、弯曲模量有大幅提高，而材料的抗拉强度即韧性降低不大。
With the increase in ha content, the flexural strength and flexure modulus of composites had been greatly increased and the tensile strength of composites had only a little change.
随着复合材料中ha含量的增加，材料的弯曲强度、弯曲模量有大幅提高，而材料的抗拉强度即韧性降低不大。
应用推荐