The uncleaned superheater, reheater should have oxygenated blowwash.
未经清洗的过热器、再热器应进行蒸汽加氧吹洗。
Pipe Explosion in Superheater of the boiler would damage the boiler and salt operating.
锅炉过热器爆管，对锅炉寿命和制盐工艺都是一种摧残和破坏。
For manufacture water wall panel, economizer, reheater, superheater and pipeline of boilers.
用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。
For manufacture wall panel, economizer, reheater, superheater and steam pipeline of boilers.
用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。
This paper studies the affect of style and speed of load in crease on boiler superheater safety.
本文对开负荷的方式和速率对锅炉过热器安全性的影响进行了研究。
The Beading and assembling process of IP superheater for Weihe project are introduced in detail.
着重介绍了渭河大化工程中的关键设备中压蒸汽过热器管箱堆焊和组装工艺。
This paper analyze the major contributions to burst for over-temperature of boiler's superheater.
本文对引起过热器超温爆管的主要原因进行了分析。
Therefore the service life of superheater is mainly dependent on the corrosion speed of tube top.
因此，过热器的使用年限全取决于管头的腐蚀速度。
The remaining superheater banks and the economizer shall have semi-retractable or fixed rotary blowers.
剩余的过热器管束和省煤器应有半伸缩式或固定旋转式吹灰器。
The early losing effectiveness causes of the superheater pipe welding joint were investigated and analysed.
针对某电厂异种钢焊接接头高温早期失效的过热器管件进行了调查研究和失效分析。
Retractable blowers shall be provided for the convection evaporative surface (third pass) and inlet to the superheater.
应为对流蒸发面(第三通道)和至过热器的出口进口提供伸缩式吹灰器。
The pressure component inside the boiler, represented by superheater, whose main reason of life loss is long- term creep.
对于以高温过热器为代表的炉内承压部件，其寿命损耗的主要方式主要是长期蠕变。
SA213-T91 steel with inferior welding performance is used on end superheater of domestic-made 600MW subcritical boil- er.
针对国产600MW亚临界机组锅炉末级过热器采用焊接性能较差的SA 213-T91钢材。
Abraded by flying ash and blowing ash, the tube wall of low temperature superheater of HP boiler was thinned during operation.
高压锅炉过热器在运行中受到飞灰、吹灰磨损，导致管壁减薄。
On the basic of existing model the pulverizing process and the characteristic of superheater differential pressure were analyzed.
在现有模型基础上，重点对制粉过程和过热器差压特性进行分析。
Analyzes reasons for tube blasting of steam superheater and recommends a kind of tube material which can better satisfy production requirements.
通过对蒸汽过热炉爆管原因进行分析，提出一种更能满足生产需要的炉管材料。
Expansion joint is adopted at the lower extreme of recycling machine, water cooled panel, platen superheater and the place piercing through roof.
返料器下端及水冷屏、屏式过热器穿过炉顶处均采用膨胀节。
The implement of this plan is introduced and the every procedure for superheater such as throwing over, barbed process and hoisting are elaborated.
介绍了该方案的实施过程，对过热器的扳倒、倒钩，吊装的每道工序均进行了阐述。
A new calculation formula of superheater temperature is put forward in view of over-temperature of the superheater for small capacity utility boiler.
研究了小容量电站锅炉过热器超温问题，并提出新的计算公式。
Standard Specification for Steel Tubes, Carbon and Carbon Manganese, Fusion Welded, for Boiler, Superheater, heat Exchanger and Condenser Applications.
锅炉，过热器，热交换器和冷凝器用熔焊碳和碳锰钢管规范。
Measures should be taken to prevent the vertical snake tube from steam binding, iron oxide depositing, and austenite corrosion when superheater is cleaned.
过热器整体清洗时，应有防止垂直蛇形管产生汽塞、铁氧化物沉淀和奥氏体腐蚀的措施。
Abrasion and corrosion of heating surface, superheater tube cracking and weld leakage are the main cause of waste heat boiler breakdown in sulphuric acid plant.
硫酸废热锅炉故障主要是由受热面管子的磨损、受热面的腐蚀、过热器爆管及焊缝漏水等引起的。
The superheater and reheater on-line metal temperature monitoring technique used a limited number of metal temperature measuring points situated outside of the.
过热器再热器壁温在线监测技术，可以通过安装少量的炉外壁温测点，实时计算整个管组各部位的金属壁温。
Superheater is the main conmponent of the leakage of "Four Pipes". The leak-age reason of utility boiler superheater should be analyzed and reserched carefully.
过热器是“四管”泄漏的主要部位，文章分析了过热器爆漏的原因。
Also analysed was the effect of electrical load and the commissioning of pulverizer exhauster on gas parameter excursion in the high temperature superheater zone.
同时还分析了电负荷及排粉机投运对高温过热器区域烟气参数偏置的影响。
6 ships with carbon steel alloy steel plate manufacturing ship I level pressure piping, II level pressure piping, boiler and Superheater carbon steel alloy steel.
船舶用碳钢合金钢板是制造船舶I级耐压管系、Ⅱ级耐压管系、锅炉及过热器用的碳素钢合金钢板。
The sootblower system shall operate with superheated steam. The steam shall be taken from the superheater outlet piping down-stream of the Purchaser's flow element.
吹灰器系统应与过热蒸汽配合工作。该蒸汽来自买方流量计的过热器出口下游管道。
The sootblower system shall operate with superheated steam. The steam shall be taken from the superheater outlet piping down-stream of the Purchaser's flow element.
吹灰器系统应与过热蒸汽配合工作。该蒸汽来自买方流量计的过热器出口下游管道。
应用推荐