The differential superposition method is used to combine concrete with bar.
混凝土与钢筋采用差量叠加式模型。
The generalized concepts on superposition method in mechanics of materials are elaborated.
阐述了“叠加法”在材料力学中较广义的概念。
Firstly, with the curvature modal superposition method, the dynamic stress responses is calculated.
首先，应用有限元方法，基于曲率模态叠加原理计算曲率，进而计算应变、应力。
The method of noise source identification and location based on Wave Superposition Method(WSM) is proposed.
提出了基于波叠加的噪声源识别和定位方法。
The computer simulation on stochastic road irregularities is performed based on the sinusoid superposition method.
在正弦波叠加模型的基础上进行了随机路面谱的计算机模拟。
Numeral superposition method of temperature and stress field in the rotor of steam turbine is studied in the paper.
探讨了汽轮机转子温度、应力场的数值叠加算法。
The superposition method should be used to the components of stresses and then the present equivalent stress will be counted.
迭加应在各应力分量上进行，然后再计算应力的当前等效值。
The superposition method of single-open chain is a new method which is quite convenicnt for doing the type synthesis by computers.
单开链迭加法是一种适应于在计算机上进行的机构类型综合的新方法。
The viscoelastic damping control of steady-state harmonic response of stiffened plate is studied by using modal superposition method.
应用模态叠加法研究了用粘弹性阻尼控制加筋板的稳态简谐响应。
A new calculation method, base the method of equivalent additional plastic loads on modes of vibration superposition method is studied.
研究一种新的计算方法——以振型叠加法为基础的等效附加塑性荷载法。
An accurate modal superposition method for calculating frequency response function of viscoelastically damped structures is put forward.
本文建立了粘弹阻尼结构频响函数计算的高精度模态展开法。
Then the linear superposition method is used to simulate irregular wave, and is verified by the autocorrelation method of wave spectrum estimation.
为模拟不规则波，采用了线性波浪叠加法。利用相关函数法进行谱估计，以检验不规则波造波效果。
The proposed approach can offer an exact solution for dynamic response of base-isolated structure, through using the complex mode superposition method.
利用复数振型叠加法，这种求解方法能够得出结构动力响应的精确解。
With regard to the nonlinear kinetics problems of a rotor system the direct integration method is more effective than the modality superposition method.
对于转子系统非线性动力学问题，直接积分法比模态叠加法更为有效。
The modal superposition method is often used for computing the Perturbation of eigenvectors in the modification for structural and correCtion for model.
模态展开法是计算特征向量摄动量的常用方法之一，但当高阶模态被截断时。
In this paper, a comprehensive method combined by DC component method, AC superposition method and loss current measurement method are described at first.
首先介绍了由“直流分量法”、“交流叠加法”和“损耗电流测量法”三者结合起来的综合判断方法，然后重点论述了交流叠加法的具体实现方案。
In this paper, linear wave theory and wave superposition method are used to study dynamic behavior of oil or gas production risers on the offshore platform.
本文应用线性波理论，通过波浪叠加法，探讨了海洋平台油气生产立管系统的动力性质。
Based on the theory of modal superposition and power series expansion, a modal superposition method for the sensitivity analysis of FRF is proposed in this paper.
基于模态展开和幂级数展开原理，提出了一种频响函数灵敏度分析的模态展开法。
The mode superposition method that was often used in the analysis of wind induced vibration in engineering had great relevance to the mode characteristics of roofs.
工程中常采用的风激振动的振型分解法与屋盖的振型特性密切相关。
Finally, in dynamic research, the impulsive loads of the frame are studied and dynamic response of the typical process is calculated and analyzed with modal superposition method.
最后进行了动态分析，对冲击载荷进行了研究，采用模态叠加法对典型工艺的动态响应进行计算。
To predict the wheel's noise radiation, a FEM analysis model of the wheel is developed. Based on the modal superposition method, the radial receptance of the wheel is calculated.
为了预测车轮辐射的滚动噪声，本文建立了车轮有限元模型，对车轮进行了模态分析，并运用模态叠加方法计算了车轮的径向导纳。
The discontinuous finite element method and time shift and superposition method are used to calculate the transmittance and reflectance in one-dimensional scattering slab medium.
采用间断有限元方法对环形激波在圆柱形激波管内绕射、反射和聚焦流场进行了数值模拟。
Finally, the study of dominant pathways of oil and gas migration has been done with the single-factor comprehensive analysis method and the multi-information superposition method.
利用单因素综合分析和多信息叠合方法对油气优势运移通道进行了研究。
The DC superposition method was mainly utilized because it was ripe theory about On-line Insulation Monitoring on the XLPE power cable, in addition of the DC partial current method.
本系统电缆绝缘在线监测理论，以比较成熟的直流叠加法为主，加上直流分量法作为理论基础。
A combination of the wave superposition method and the modified spectral representation method is applied to a wind field simulation for whole bridge including the deck and the towers.
将谐波合成法与修正的谱描述法结合用于大跨度桥梁主梁及桥塔上的随机风场模拟。
This paper introduces the basic principle to correct the photometric linearity with optical superposition method, and its measuring method; Error equation of linearity correction is given;
介绍了采用光叠加法校正分光光度计光度线性的基本原理及测量方法；
Research methods: in this paper, an accurate water tree model has been created. We have successfully developed a new hot-line diagnostic method called "high frequency superposition method".
研究方法：建立了水树精确数字仿真模型，提出一种新的在线绝缘诊断方法：高频信号叠加法。
Prandtl-Vesic of ultimate bearing capacity of strip foundation belongs to the plane strain problems, which adopt step superposition method to obtain the formula of ultimate bearing capacity.
勃郎特-维西克研究的条形基础极限承载力属于平面应变问题，采用分步叠加法，求得地基极限承载力公式。
In the present paper, the superposition method of the complex stress function is extended to calculate the general problems concerning radial cracks emanated from the multiple circular holes.
本文将复变应力函数的迭加解法进一步推广应用于求解一般的多孔边裂纹问题。
In the present paper, the superposition method of the complex stress function is extended to calculate the general problems concerning radial cracks emanated from the multiple circular holes.
本文将复变应力函数的迭加解法进一步推广应用于求解一般的多孔边裂纹问题。
应用推荐