Suspension lines, pull lines, backup lines and snub lines should be inspected weekly and before every job for specifications (job load ratings), wear limits, damage, or improper installation.
悬吊绳、拉力绳、安全绳、固定绳应该每周或每次使用前检查一次，规格(额定工作负荷)、磨损限度、损坏程度或安装。
Aiming at the decline of maximum braking force caused by the mass transfer during the course of braking, the article advances a method which USES active suspension system to reduce dynamic wheel load.
针对汽车制动过程中质量转移而使最大制动力下降的问题，提出利用主动悬架系统减小汽车动态车轮载荷的方法。
The purpose of the complete suspension system is to isolate the vehicle body from road shocks and vibrations, which will otherwise be transferred to the passengers and load.
整个悬架系统的作用是隔离来自路的冲击和振动对车身的影响，防止它们传递给乘客和货物。
But there's an all new double wishbone rear suspension set-up to offset this, with much less intrusion into the load area than the previous strut configuration.
但有一个全新的双叉骨后悬挂的设定，来抵消这种与低得多侵入负荷面积比前麦弗配置。
Lift the suspension coop vacant load for 300mm and stop.
将吊笼空载提升300毫米左右高度停止。
This paper introduces the math-models found of interconnect oil-air suspension vehicle in normal state, under different load of two wheels, and on vehicle turning the corner state.
介绍了连通式油气悬挂车辆在正常行驶、两侧车轮载荷不同及车辆转弯时三种不同状态下数学模型的建立。
The application results show that laser welding can meet higher strength stress demands for those fatigue load parts, such as intake and exhaust valves, timing gear, suspension equipment.
应用结果表明：对于进排气门、正时齿轮和悬架装置等承担疲劳载荷的零部件，激光焊接可满足其较高的强度要求；
The four-link rods type suspension is an advanced suspension type, can guarantee in design the better straight driving performance of automotive vehicle and reduce in maximum the load effect.
四连杆式悬架是技术比较先进的悬架形式，可以从设计上保证车辆良好的直线行驶性能并最大程度减轻载荷的影响。
The four link rods type suspension is an advanced suspension type, can guarantee in design the better straight driving performance of automotive vehicle and can reduce in maximum the load effect.
四连杆式悬架是技术比较先进的悬架形式，可以从设计上保证车辆良好的直线行驶性能并最大程度减轻载荷的影响。
The results show that aerobus suspending cable structure is different from suspension bridge in mechanical properties when it acted by external factors, such as temperature change, load, etc.
研究表明该种结构在温度变化和外荷载等作用下的力学特性与悬索桥有明显的不同。
Rear suspension system under light load has higher supporting frequency than under deadweight.
而后悬架系统在轻载荷下较之重载荷时具有较高的支承频率。
We establish the theoretical model for the relationship between the vertical load and vertical displacement of a driver's seat suspension system that contains two level-layout linear spiral springs.
建立了一种含两水平布置线性弹簧的驾驶员座椅悬架系统垂向力与垂向位移特性关系的理论模型。
A vehicle suspension assembly includes a shock absorber that provides variable damping dependent on the load conditions of the vehicle.
车辆悬挂系统的安装，包括减震器，提供可变阻尼依赖于车辆的负载条件。
The catenary theory and geometrical nonlinear finite element method were adopted in determining the dead-load state of self-anchored suspension bridge with spatial cables.
结合悬链线理论和几何非线性有限元方法，对空间缆索自锚式悬索桥成桥状态的确定方法进行了研究。
It is shown that the cable wind load affects remarkably the aerostatics of long-span suspension Bridges, but its effect on the aerodynamic stability becomes negligible.
结果表明：缆索风荷载对悬索桥静风效应的影响比较显著，但对于空气动力稳定性则没有影响。
It was suggested to decrease such an instantaneous stiff impact load by supplementing elastic suspension between the wheelset and side frame.
而通过增加轮对与侧架的弹性悬挂可以有效减弱这种瞬时刚性冲击。
Even though these rivers carry a significant sediment load in suspension, the density of the sediment-laden water is rarely at or above the density of seawater.
尽管这些河流带着大量悬浮的颗粒，这带有沉淀物的水的密度仍仅仅达到或者低于海水的密度。
New stiffening girder suspension bridge adopts a castellated steel and concrete composite structure, which has obvious advantages of structural stability in light load span suspension bridge.
新型加劲梁悬索桥采用了蜂窝型加劲梁组合结构，在轻荷载大跨径悬索桥中有较明显的结构稳定性优势。
In the palper, with resonance between the secondary coil of suspension transforMer and capacitance load the active ESS has been developed.
本文利用高压支承变压器高频载波下付边电感与负载电容的谐振特性，设计并研制了有源谐振的ESS。
For reducing roll Angle to avoid roll-over of heavy truck during steering, an active anti-roll bar is installed in suspension to compensate lateral load transfer.
为了减小重型货车在转向操作时的侧倾角，从而避免货车转向时发生侧翻，可以通过在悬架中安装主动抗侧倾杆以补偿横向载荷转移的方法来实现。
Level ride rear suspension helps to maintain good road manners even with a full load.
平液后悬挂可保证即使满载情况下也能保持良好的公路性能。
This paper will provide theoretical basis and research methods which can lead our country to develop high-tech heavy vehicle road-friendliness suspension that can reduce the dynamic load of wheel.
本论文将为我国开发能够减小道路破坏的载重汽车道路友好悬架提供理论基础和研究方法。
By means of spectral analysis method, the problem of dynamic loads acting on the load-carring components of rear bogie suspension system of a truck is analysed in this paper.
本文采用功率谱分析法讨论了作用在三轴汽车平衡悬挂承载部件上的动载荷问题。
Through the test analysis of model Bridges, we discuss the static live-load characteristics, the morphology of deformation and dynamic characteristics of the upside suspension bridge.
通过对模型桥的试验分析，讨论了上承吊桥的静力特性、变形形态和动力特性。
The suspension weights of a fighter alters the actual service load for each take-off.
飞机不同的装挂重量使飞机每次起飞时实际载荷变化。
Finally, the mid-span deflection of a long span suspension bridge under vertical live load is analyzed when the elastic module of cable and hangers are assumed to be random correlated variables.
最后针对一座大跨悬索桥，计算了在竖向活载作用下材料、几何尺寸的随机性对主梁跨中位移的影响。
With their very high ground clearance and a flexible frame that is essentially a part of the suspension, Unimogs are not designed to carry as much load as regular trucks.
他们非常高的离地间隙和灵活的框架中基本上是暂停的一部分，Unimogs不是为了进行定期卡车一样多的负载。
It reduces the construction difficult, releases the dead load of pulling bar and steel suspension box and saves material.
降低了施工难度，又减轻了拉杆及钢吊箱的自重，节约材料。
It reduces the construction difficult, releases the dead load of pulling bar and steel suspension box and saves material.
降低了施工难度，又减轻了拉杆及钢吊箱的自重，节约材料。
应用推荐