The tensile modulus showed a negligible change with thermal oxidation temperature.
模量随热氧化温度变化不明显。
An analytical algorithm to estimate the tensile modulus of Brazilian disk splitting tests is presented.
提出巴西圆盘劈裂试验中拉伸模量的解析算法。
Meanwhile, as the curing temperature increases, the tensile modulus of composites improves in some degree.
然而复合材料的拉伸模量随着成型温度的升高有一定幅度的提升。
The tensile modulus approximately equal to the compressive modulus of elasticity within the proportional limit.
拉伸载荷模量约等于比例极限内的弹性模量。
With VP-501 content increasing, the fracture toughness was increased, while the tensile modulus was decreased at both RT and 77 K.
随着VP-501含量的增加，体系在RT和77 K下的断裂韧性增加了，然而其拉伸模量降低了。
The results show that tensile strength and tensile modulus increase and cold-resisting property descends with temperature dropping.
结果表明，随着温度的降低，该橡胶的拉伸强度、拉伸模量升高，耐寒性下降；
The tensile strength, bending strength, impact strength, tensile modulus of elasticity and bending modulus of elasticity were determined.
测试了塑木板材的拉伸强度、弯曲强度、冲击强度、拉伸弹性模量、弯曲弹性模量等力学性能；
This article introduces a method to determine the plastic membrane tensile modulus by using a normal mart electron tensile testing machine and computers.
文章介绍了一种利用普通的智能电子拉力试验机配以计算机来计算塑料薄膜拉伸弹性模量的方法。
The effects of the content and dispersion of carbon nanotubes on the tensile strength, tensile modulus and ratio of elongation of the nanocomposites were studied.
研究了碳纳米管的加入量与分散程度对复合材料的拉伸强度、拉伸模量、断裂伸长率的影响。
In the bulk system, tensile strength, tensile modulus and impact strength are improved by 32.2%, 60.3% and 68.6%, respectively, without the loss of light transmittance.
而本体法复合材料的拉伸强度、拉伸模量及冲击强度值最大分别提高了32.2％、60.3％和68.6％，而透光性能基本未受影响。
In this paper, the relation of tensile strength, tensile modulus and breaking elongation of unsaturated polyester casting matrix cured at room temperature to curing degree was discussed.
本文讨论了常温固化不饱和聚酯树脂浇涛体的拉伸强度、拉伸模量、断裂延伸率与固化度之间的关系。
With the increase of elastomer content, the tensile strength and elastic modulus of the blends decreased, while the elongation at break increased.
随着共混物中弹性体质量分数的增加，共混物的拉伸强度和弹性模量降低，扯断伸长率增大。
There is a distinct difference between tensile and compressive modulus. Xylem is a kind of anisotropic material and modeling its mechanical model needs anisotropic constitutive relations.
拉伸弹性模量与压缩弹性模量有明显差异，木质部属各向异性材料，建立力学模型应采用各向异性的本构关系。
This contributes to the increase of tensile strength and modulus of the graphite fibers.
微观结构的改善是石墨纤维抗拉强度和弹性模量提高的主要原因。
Based on testing of partial cores taken in two areas, some rock mechanical parameters such as Poison's ratio, Young's modulus, tensile strength are determined.
通过对两地区部分岩心的测试，得出了岩石泊松比、杨氏弹性模量和抗拉强度等岩石力学参数。
The results show that the Young's modulus and tensile strength of the combinational 3d woven fabric reinforced composite are close to that of the 3d orthogonal woven fabric reinforced composite.
结果表明，组合式3d机织物增强复合材料具有接近正交3d机织物增强复合材料的弹性模量和抗拉强度。
A modified theory of metal volume fraction is put forward to precisely predict tensile properties including elastic modulus, yield stress and tensile strength.
提出了修正后的金属体积分数理论，准确预测了材料的弹性模量、屈服应力及拉伸强度。
The influence of the loading level of nylon and PET short fibres was studied on the physical properties of Nylon-NR and PET-CR Composites, such as 20% modulus, tensile strength and tear resistance.
详细研究了尼龙和聚酯短纤维用量对尼龙-天然橡胶和聚酯-氯丁橡胶复合材料的20％定伸应力、拉伸强度及撕裂性能的影响。
The high performance concrete for core wall of earth dam must be good workability, low early strength, high final strength, high seepage resistance, low elasticity modulus and high tensile strength.
黄壁庄水库副坝防渗心墙加固工程所需高性能混凝土，要求和易性好、早期强度低、后期强度高、抗渗性能好、低弹模和高抗拉强度。
The Nitinol alloy has poor mechanical characteristics, such as, tensile strength, yield strength, and elastic modulus and low suitability to a human body.
镍钛锘合金的抗拉强度、屈服强度及弹性模量等机械特性差而且人体适应性低。
The tensile strength, modulus of elasticity(MOE) and hardness of Pinus massoniana fibers were determined by using zero-span tension and nanoindentation technique.
研究了人工林马尾松的纤维零距抗张强度、细胞壁的纵向弹性模量和硬度等力学指标。
The results showed that the tensile strength, Young's modulus of soy protein plastics with complex plasticizers increased.
结果表明，采用复合增塑剂，大豆蛋白塑料的拉伸强度，杨氏模量均增加。
The experimental results show that the elastic modulus, tensile strength and fracture toughness of brittle rocks can be determined from a valid load-displacement record.
试验结果表明，可以从一次有效的载荷-位移记录中同时确定脆性岩石的弹性模量、拉伸强度和断裂韧度。
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
结果表明，复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
An experimental procedure and accompanying method for analyzing recorded data for deriving dynamic tensile strength and elastic modulus of brittle material is presented.
提出了获取脆性材料动态拉伸强度及弹性模量的实验步骤及相关记录数据的分析方法。
The changes of moisture absorption properties, tensile strength, fracture elongation and elastic modulus of APMOC fiber with aging time were investigated through the hygrothermal aging test.
通过湿热老化试验，研究了APMOC纤维吸湿性能、拉伸强度、断裂延长率以及弹性模量随老化时间的变化。
The effect of the amount of fiber, the length of fiber, the ratio of water to cement on tensile strength, shear strength, compressive strength and elastic modulus was investigated.
研究了纤维掺量、纤维长度、水泥土的水灰比等对纤维水泥土的抗折强度，抗压强度，抗拉强度和弹性模量的影响。
The result shows the concrete rebounding value, compressing strength, tensile splitting strength, rupture strength and elastic modulus are reduced in different degree by adding recycled aggregates.
试验结果表明，随着再生骨料掺入量的增加，混凝土的回弹值、抗压强度、劈裂抗拉强度、抗折强度和弹性模量均有不同程度的降低。
With the increase in ha content, the flexural strength and flexure modulus of composites had been greatly increased and the tensile strength of composites had only a little change.
随着复合材料中ha含量的增加，材料的弯曲强度、弯曲模量有大幅提高，而材料的抗拉强度即韧性降低不大。
With the increase in ha content, the flexural strength and flexure modulus of composites had been greatly increased and the tensile strength of composites had only a little change.
随着复合材料中ha含量的增加，材料的弯曲强度、弯曲模量有大幅提高，而材料的抗拉强度即韧性降低不大。
应用推荐