The glass transition temperature of SA indicated that SA has good heat stability.
通过测定SA的玻璃化转变温度，证明SA二元共聚物的热稳定性良好。
The glass transition temperature of PLLA decreased with the increase of cooling rate.
玻璃化温度和结晶度随着降温速率的降低而增大。
If all of the material is heated to the glass transition temperature, no folding will occur.
若所有材料以玻璃转变温度进行加热，那就再不能进行折叠了。
The glass transition temperature of POE plays a key role in the dynamic behavior of POE/ CaCO3/HDPE composites.
POE的玻璃化转变温度成为影响三元复合材料动态力学性能的重要因素之一。
The glass transition temperature of hyperbranched polymers rises with the increase of the rigidity of chain segments.
超支化聚合物的玻璃化转变温度随支化点间链段刚性的增大而增大。
The glass transition temperature of hyperbranched polymers rises with the increase of degree of functionality of central core.
超支化聚合物的玻璃化转变温度随中心核可反应官能度的增加而增大。
Improve the flexibility and ductility of the coating, reduce the glass transition temperature and make the coating feels soft.
提高涂层的弹性和韧性，降低玻璃化温度，使得手感柔软。
It is very important to truly determine the glass transition temperature of food to improve the conditions of food processing and storage.
准确测量食品的玻璃化转变温度对改进食品的加工和贮藏条件非常重要。
In this article, the glass transition temperature of a single polyoxymethylene (POM) chain adopting the modified bond fluctuation model was studied.
本文利用聚甲醛链的键长涨落模型，研究了聚甲醛单链的玻璃化转变。
The glass transition temperature (T_g), tensile and impact strengths, and the solution viscosity of the PMMA plate increased with the increase of M_w.
板材的玻璃化温度、拉伸强度、冲击强度和溶液黏度均随摩尔质量的增大而增大。
But compared to as-quenched samples, the glass transition temperature, crystallization temperature and crystallization peak temperature have same changes.
但与淬态试样相比，玻璃转变温度、晶化温度及晶化峰值温度存在一定的变化。
The results showed that the glass transition temperature and vicat softening point increased obviously with the increase of the content of the terpolymer.
结果表明：随共聚物用量的增加，共混物的玻璃化温度和维卡软化点明显提高；
In this paper, a summarization of the relationships between the glass transition temperature and some food factors e. g. water content, carbohydrate, pro...
该文就水分含量、碳水化合物、蛋白质、平均分子量及食品添加剂等因素与一定的食品体系的玻璃化转变温度的关系进行了综述。
The effects of these factors on the glass transition temperature, the temperature and heat of crystalline melting, the specific heat and adiabatic temperature...
讨论了这些结构因素对聚氨酯弹性体玻璃化温度、结晶熔融温度、熔融热、比热和绝热温升的影响。
First, the surface temperature of the hinge must exceed the glass transition temperature of the material, which is the point at which the material begins to soften.
第一，折痕表面温度必须超过材料向玻璃过度的温度点，即材料开始变柔软的温度点。
The molecular weight, molecular weight distribution and the glass transition temperature of the resulted composite polymers were analyzed by gel permeation chromato…
氢化松香的引入降低了聚甲基丙烯酸甲酯的分子量和玻璃化转变温度，加宽了分子量分布，其影响与理论预测的结果相一致。
The results showed that the storage modulus of PP was increased markedly and the glass transition temperature of PP was risen by the addition of the nucleating agents.
结果表明：有机磷酸酯成核剂使PP的储能模量显著提高，玻璃化转变温度有所增加。
The glass transition temperature of hyperbranched polymers rises with the increase of molecular weight. When the relative molecular mass was high enough it remained the same.
超支化聚合物的玻璃化转变温度随分子量的增加先增大，当分子量足够大时玻璃化转变温度不再受其影响。
The isothermal compression behaviors of MgCu-Y7Nd bulk amorphous alloy nearby the glass transition temperature (Tg) and at temperature in the supercooled liquid region are observed.
研究了MgCuY7Nd大块非晶合金在玻璃转化温度Tg附近及深过冷液相区的等温压缩变形行为。
The effects of these factors on the glass transition temperature, the temperature and heat of crystalline melting , the specific heat and adiabatic temperature rising were discussed.
讨论了这些结构因素对聚氨酯弹性体玻璃化温度、结晶熔融温度、熔融热、比热和绝热温升的影响。
In this article, we measure the glass transition temperature of the same sample in different ways so as to know more about various methods and give the further discussion of the result.
为更好的了解各种测试方法，本文用不同方法对同种样品的玻璃化转变温度进行测定，并对其结果进行讨论。
The noncrystalline structure is achieved by relatively rapid cooling below what is referred to as the glass transition temperature, around 1, 000 degrees Fahrenheit for the soda-lime variety.
它不结晶的结构往往是通过在玻璃化转变温度以下迅速冷却而得到，对于碱石灰玻璃而言，大约在华氏温度1000度左右。
The glass transition temperature Tg, melt point Tm, thermogravimetric curve, tensile strength and degradation rate of this blend were determined by DSC, TGA, tensile test and degradation test.
用差示扫描量热法、热重分析法和拉伸试验法等测定了CDA—PLLGA的玻璃化温度、熔点、热失重性能、拉伸强度和降解性能。
Dynamic mechanical thermal analysis showed that the addition of TPR improved the damping of the composite, but decreased the storage modulus and the glass transition temperature of the composite.
复合材料动态力学性能研究表明：TPR的加入提高了复合材料的阻尼性质，却降低了复合材料的存储模量和玻璃化转变温度；
The results shows that epoxy resins containing rigid rod structure or many epoxy groups have a high glass transition temperature (Tg) because of high cross-linking density.
研究结果表明：分子结构中含有刚性结构或连有较多的环氧基时，固化产物具有较高的交联密度，玻璃化转变温度较高；
The characteristic temperatures are gradually tended to high temperature zones with DSC heating rate increase, where the dynamic effect of crystallization is much higher that of glass transition.
这些特征温度随dsc升温速率的增大，不断向高温区偏移，其中晶化行为的这种动力学效应比其玻璃转变的更为显著。
The composition of carbohydrates in concentrated orange juices (COJ) and its effects on glass transition temperature and viscosity of the products were investigated.
研究了浓缩橙汁中的碳水化合物组成以及它们对产品的玻璃化转变温度和粘度的影响。
The microstructure, molecular weight, molecular weight distribution, glass transition temperature and dynamic properties of synthesized SIBR were characterized by IR, GPC, DSC, DMA.
采用IR、GPC、DSC、DMA等仪器对合成的SIBR的微观结构、分子量大小及分布、玻璃化转变温度和动态力学性能进行了分析测试。
The microstructure, molecular weight, molecular weight distribution, glass transition temperature and dynamic properties of synthesized SIBR were characterized by IR, GPC, DSC, DMA.
采用IR、GPC、DSC、DMA等仪器对合成的SIBR的微观结构、分子量大小及分布、玻璃化转变温度和动态力学性能进行了分析测试。
应用推荐