The compliance-calibration specimen has a slot of finite-tip radius in place of a crack.
柔度算定试样是用一个有限端部半径的槽来代替裂纹。
The line width of nanostructures is influenced by many factors such as tip curvature radius, detained time in the base surface, scanning speed, humidity, surface roughness etc.
尖端曲率半径、针尖在基底表面滞留时间、针尖扫描速度、空气湿度、表面粗糙度等均会影响纳米结构的线宽。
The maximum lesion size was determined ultimately by the radius of the electrode tip , no matter what method was used. It is about 2.49 times the radius.
不论用哪种方法，最大损伤斑的尺寸是不变的，它仅仅与电极头半径有关，大约是半径的2．49倍。
The methods of reducing centrifugal fan fixed in oil gas machine are studied by altering the gap between cases and tip of rotor, radius of tongue of case and inclining the tongue of case.
采用改变蜗舌间隙、蜗舌半径及倾斜蜗舌等方法对家用油烟机主要噪声源的离心风机进行降噪研究。
The answer turned out to be the radius of the tip.
答案竟然是尖端的半径。
The excess pore pressure measured in the same site is also compared with them. The maximum influence radius of the increment of soil pressure under the pile tip is discuss...
也将同一场地测得的侧压力增量与超孔隙水压力进行比较，并对桩端下土压力增量的最大影响半径进行了讨论。
A model is developed for the calculation of the initial rotor tip vortex core radius aiming at eliminating the empirical parameters of the tip vortex in rotor free-vortex wake analysis.
建立了一个旋翼桨尖涡初始涡核半径计算模型，用于消除旋翼自由尾迹分析中桨尖涡涡核半径依靠经验设定的现状。
Full radius hob on tooth tip is one of the effective measures by increasing gear tooth bending strength.
应用齿顶整圆弧滚刀是提高齿轮弯曲疲劳强度的有效措施之一。
The tip of specimen for FIM analysis is prepared by "thin layer" electropolishing. A Clean tungsten tip about 500 A radius was prepared.
描述了场离子显微镜样品的制备，并得到曲率半径为500（?），表面光洁的钨针尖。
This paper introduces application and design of full radius hob on tooth tip.
介绍了齿顶整圆弧滚刀的应用和设计。
Meanwhile, with rising in anisotropic value, the growth velocity of dendritic tip is promoted with decreasing in curvature radius.
各向异性强度越大，枝晶尖端的生长速度越快，曲率半径越小。
Apparent stress intensity factor KI with different radius are calculated by the stress method and KI is obtained by interpolation to the crack tip circular arc.
采用应力法计算不同半径处的表观应力强度因子，插值到裂尖圆弧而得。
Apparent stress intensity factor KI with different radius are calculated by the stress method and KI is obtained by interpolation to the crack tip circular arc.
采用应力法计算不同半径处的表观应力强度因子，插值到裂尖圆弧而得。
应用推荐