The stability of U-shaped bellows under torsion load is numerically analyzed in the thesis.
本文采用数值分析的方法对U 型波纹管膨胀节在扭转载荷作用下的稳定性进行分析。
The simulation torsion load can be used to make up torsion fatigue load spectrum for test and estima…
计算载荷可以用来编制货车传动系统扭转疲劳试验载荷谱、估计零部件的疲劳寿命。
The greater the high pressure torsion load and the more turns applied,? The more obvious refinement effect and the higher the microhardness value.
高压扭转载荷越大，扭转圈数越多，细化效果越明显，显微硬度值也越高。
The simulation torsion load can be used to make up torsion fatigue load spectrum for test and estimate the fatigue life of component parts of truck transmission system.
计算载荷可以用来编制货车传动系统扭转疲劳试验载荷谱、估计零部件的疲劳寿命。
Operating environment, life expectancy, and spring load are taken into account when designing your custom torsion springs.
当为您定做扭转弹簧时，工作环境，生命周期和弹簧荷载我们都会考虑。
Through a lot of experiments and analysis, it was pointed out that the twist number of steel wire in torsion test decreased gradually with increasing axial tension load.
本文通过大量的试验和分析，得出钢丝扭转试验时，随着轴向拉力负荷的增加，其扭转次数趋于递减的变化过程。
The concrete slabs strengthen the torsion buckling capacity of the steel grids and enhance the minimum geometric nonlinear buckling load.
混凝土面板加强了网架的抗扭转屈曲能力，提高了最小几何非线性屈曲荷载。
Steel beams are often suffering combined bending and torsion as the influence of eccentric load in actual projects.
实际工程中，由于荷载偏心等影响，使得钢梁常常同时承受弯矩和扭矩的联合作用。
A load signal on the sensor is transmitted to the transmitter and then is sent to the receiver through the antenna so that the torsion value is outputted.
传感器上的载荷信号输送到发射机经天线发送到接收机，输出扭矩数值。
The torsion moment due to wind load on building is also discussed.
对建筑物的风载扭矩问题，也进行了初步探讨。
Therefore, it is necessary to analyze and calculate the performance of the tower when it is exerted pull, press, torsion and wind load in order to design a stable, secure and reliable tower.
因此为了设计出运行稳定、安全、可靠的塔架，分析计算塔架受拉、压、扭转力和风载作用下的特性是有必要的。
Due to the large span of the floor slab, the moment torsion of the beam, under the vertical load, is obvious.
由于板跨较大，竖向荷载使梁截面承受的扭矩较大。
Compared with the spring analogy method, the method has big computation load and can treat the situation with big displacement and torsion.
和弹簧方法相比，虽然弹性体方法的计算量大，但是可以处理大位移的情况，尤其善于处理网格扭转很厉害的情况。
Using the Line-loaded Integral Equations the corresponding principle and Laplace transformation, the torsion problem of the Linear viscoelastical shaft in which load "Point Ring Couple"can be solved.
应用线载荷积分方法，相应原理和拉氏变换，求得点圆力偶作用于粘弹性回转体的基本解。
Using the Line-loaded Integral Equations the corresponding principle and Laplace transformation, the torsion problem of the Linear viscoelastical shaft in which load "Point Ring Couple"can be solved.
应用线载荷积分方法，相应原理和拉氏变换，求得点圆力偶作用于粘弹性回转体的基本解。
应用推荐