The base unit scores with an excellent torsional stiffness.
一个出色的扭转刚度的基础单元分数与。
Section Properties: Bending, Shear, and Torsional Stiffness;
挠度，剪切和刚度；
Each specimen underwent axial and torsional stiffness testing along with cyclic axial loading to failure.
每个样本均采用循环轴向荷载以至固定失效来测定其轴向刚度和抗扭刚度。
Torsional stiffness of tower crane mast is closely related with the arrangement of Web members of the mast.
塔式起重机塔身的抗扭刚度与塔身腹杆布置密切相关。
The influence to stress of skew arch bridge was studied by changing the abutment torsional stiffness and width-span ratio.
通过改变桥台抗扭刚度和宽跨比，研究对斜交拱桥受力的影响。
Diaphragm couplings commonly used in the servo system, the membrane has good torsional stiffness, but less in the bellows coupling.
膜片联轴器常用于伺服系统中，膜片具有很好的扭矩刚性，但稍逊于波纹管联轴器。
The effective methods for controlling the torsional response are put forward by adjusting the torsional stiffness and damping of flexible jointer.
提出了通过调节柔性联接器的扭转刚度和阻尼对旋转系统周期冲击响应进行有效控制的方法。
The elastic characteristic and torsional stiffness of four kinds of typical dual mass flywheel type torsional vibration damper is analyzed in detail.
对汽车动力传动系双质量飞轮式扭振减振器的选型和设计具有一定的参考价值。
The torsional stiffness of a large turbogenerator rotor body and the factors influencing the stiffness are studied systematically in by using the finite element method.
本文利用有限元数值计算方法，系统研究了发电机转子本体部分的扭转刚度及其主要的影响因素。
Secondly, the relationship between rotary inertia coefficient, torsional stiffness, transmission gearbox and torsional vibration frequency is analyzed on the basis of the design model.
其次，在双质量飞轮设计模型的基础上，分析了双质量飞轮转动惯量系数、扭转刚度、变速器与系统扭振频率的关系。
Returnability is affected mainly by automobile velocity, torsional stiffness of steering system and caster angle and relatively little by viscous friction coefficient of steering system.
汽车车速、转向系统扭转刚度和主销后倾角对回正性能的影响较大，而转向系统的粘性摩擦系数对回正性能的影响相对较小。
The stiffness is the stricter design rule than strength in car body development. Torsional stiffness, the key factor for car body to resist the poor torsional case, is especially important.
车身刚度是较强度要求更严格的设计指标，尤其是车身扭转刚度指标，它是车身抵抗较恶劣的扭转工况载荷的关键保证指标。
The formula calculating the equivalent diameter of torsional stiffness for domestic turbogenerator rotor is presented, and the modelling of some special structures on the rotor is discussed as well.
针对国产发电机的具体特点，本文首次给出了计算大型发电机转子本体部分扭转等效直径的公式，此外，还对转子上其他一些结构的模化作了探讨。
Torsional and lateral vibration of a high-rise building with L shape plan under earthquake will couple because of large distance between center of stiffness and center of mass.
平面L形高层建筑结构的刚度中心与质量中心偏离较大，在水平地震作用下平移振动与扭转振动扭耦合。
Torsional strength and stiffness were measured.
测定各组的抗扭强度和抗扭刚度。
Compared with the purely torsional model, tangential displacements and bearing stiffness of the pinions are included in the governing equation of motion.
该模型在纯扭转模型的基础上，进一步计入了行星轮轴心沿系杆切向的位移与行星轮轴的轴承支承刚度对系统动力学性能的影响。
It should be noted that this represents the stiffness of the equivalent torsional spring and not that of the original flexural beam.
需要指出的是这里的刚性所代表的是等量的减震弹簧的而不是其他的弯曲部件。
This paper presents a new mathematical model for calculating the coupled torsional-axial vibration with non-linear stiffness for a lumped spring-mass shaft system of internal combustion engine.
本文提出了一种具有非线性刚度的弹簧一质量模型，用于计算内燃机轴系的扭转—纵向耦合振动。
This paper presents a new mathematical model for calculating the coupled torsional-axial vibration with non-linear stiffness for a lumped spring-mass shaft system of internal combustion engine.
本文提出了一种具有非线性刚度的弹簧一质量模型，用于计算内燃机轴系的扭转—纵向耦合振动。
应用推荐