The change of steel tube wall thickness during sinking is studied.
钢管空拉减径，伴随着管壁变化。
Strut of cell of tube wall endodermis, appear hobnail kind dash forward to tubal antrum.
管壁内皮细胞肿胀，似鞋钉样突向管腔。
The instantaneous changes of local tube wall temperature are recorded in the present work.
文中还给出了局部管壁温的瞬态变化以及垂直埋管与水平埋管传热的比较。
At present, the method for calculating the tube wall temperature in a furnace chamber is not exact.
针对目前大型煤粉锅炉屏式过热器管壁温度计算不准确的问题，提出了屏式过热器三维管壁温度计算方法。
The said calculation formula is useful for accurate control of the final tube wall thickness tolerance.
该计算式对精确控制成品管壁厚精度具有实际意义。
The tube wall of the exposed end of the flushing tube is intertwined by the section of the drainage tube.
冲洗管外露段管壁由引流管的材料延续包 绕。
For irregularly hot stress acting tube curve, it stressfully analyzes effect of body tube wall thickness difference.
对于不规则热应力作用下的身管弯曲重点分析了身管壁厚差的作用。
In order to retain ample strength at the welded seam, the tube wall thickness is increased making the overall frame heavier.
为了保留足够的实力在焊接缝，管壁厚度增加，使整体帧重。
By means of heating kerosene and the tube wall, the ignition and the subsequent detonation initiation were promoted markedly.
通过采用提高煤油温度及对爆震管壁面加热的方法，对于点火及爆震起爆过程起着十分重要的促进作用。
Abraded by flying ash and blowing ash, the tube wall of low temperature superheater of HP boiler was thinned during operation.
高压锅炉过热器在运行中受到飞灰、吹灰磨损，导致管壁减薄。
Some heterogeneity has been observed on the tube wall in the aspect of stitch structure and the linear density of constituent fibers.
线圈结构和纤维的线密度分析显示管壁三部位存在不均匀性。
An improvement is that the anesthesia needle guiding passage (3) is arranged in a guiding groove (4) on the outer wall of the tube wall.
一种改进是所述麻醉针引导通道(3)是设置于管壁的外壁上的引导槽(4)。
To ensure the heater for safe operation, a thermocouple is pro - posed to install on the tube wall to protect the heater tube from coking.
为保证加热炉安全运行，提出了安装炉管管壁热电偶、强化炉管烧焦等对策。
When the tube radius is far greater than the coil size the tube wall can be considered as a conducting plate that can be easily simulated.
当管道半径远大于线圈尺寸时，管壁可看作平板导体，问题得到简化。
The tank tube wall construction of climate laboratory is adopted with the somersaulting formwork technology and the no scaffold technology.
环境气候实验室罐体筒壁施工采用翻模施工技术和无脚手架施工技术。
The method can effectively solve the non-balanced problem of the electric power transmission-line system and wax coagulation on the tube wall.
该方法可以有效解决电网扰动和高凝油开采油管结蜡问题。
One of the fundamental measures to simplify a boiler enclosure and to improve its gas tightness is to use the welded broad-fin tube wall construction.
解决锅炉烟气侧严密性和简化炉衬的根本措施之一，是采用全焊膜式壁结构。在炉膛部分，应用膜式水冷壁已有多年运行经验，已作为成熟结构普遍采用。
After compared with the result of tests and fitting formula, it is reasonable to deduce the resolution of tube wall stiffness based on the elastic theory.
基于经典弹性板壳理论推导管壁变形解答，得到管壁变形的解析表达式，并以此计算管壁变形刚度。
With the help of a finite difference method a temperature field distribution calculation is conducted of a membrane water wall, a tube wall with an irregular shape.
采用有限差分方法对膜式水冷壁这一形状不规则的管壁进行温度场分布计算。
In this paper, based on beam-column element and single slice wall, a tube wall element is proposed, and is applied to push-over analysis for tall concrete structures.
本文在梁柱单元、单片墙单元的基础上提出了一种筒体墙单元，并将此单元应用于高层混凝土结构推覆分析中。
The results show that, under the conditions of high altitude, the flame tube wall temperature of the same axial position is increased with the increase of Mach number;
结果表明：在高空条件下，火焰筒同一轴向位置的壁温随马赫数的增大而升高；
Furthermore, regarding the distribution of pulsation speed the characteristics of pulsation and random distribution can be observed in the neighborhood of tube wall surfaces.
实验还观察到气体—颗粒两相流动的湍流强度会随粒径的减小而增加，而且其脉动速度的分布将会在壁面附近出现脉动和随机分布的特征。
For the cap of nanotube, it can be seen as the prolongation of the tube wall, therefore, the electronic structures of tube with capped ends are close to the tube with open ends.
研究表明纳米管帽的尺寸效应可以看成为一定长度管壁的简单延伸，揭示了含帽与不含帽纳米管电子结构之间的相似性。
The tube wall of same section of near end of said piston chamber has three uniformly distributed small projections to prevent the piston out of the piston chamber from near end.
所述活塞仓的近端同一截面的管壁上均匀分布有三个以上的小突起，以阻挡活塞由近端跑出活塞仓。
The X-ray backscattering from the inner electrodes and the tube wall of an X-ray image intensifier (XRII) will degrade the spatial resolution and the contrast of an output image.
影像增强器内电极和管壳对X射线的背向散射将降低增强器输出图像的空间分辨率和对比度。
Numerical calculations for the conjugate problem of in-tube convection and tube wall conduction were conducted on the basis of the experimental measurements using the FLUENT code.
论文采用FLUENT通用软件对实验工况下的管内对流换热与固壁导热的耦合问题进行了数值模拟。
The experience relationship between fin-height and rough tube wall-thickness for cold-drawn outer-spiral-fin tube is established with many-membered Iinear regression in this paper.
利用多元线性回归建立了冷拔外螺纹铜管凸筋高度与坯料壁厚之间的经验关系式。
The paper introduces a new rotating speed measuring method for diesel engine utilizing pressure pulse signal on the tube wall of high pressure fuel injection system of diesel engine.
本文介绍一种利用柴油机高压泵喷油管壁上的压力波脉冲信号，来测量柴油机转速的新方法。
The paper introduces a new rotating speed measuring method for diesel engine utilizing pressure pulse signal on the tube wall of high pressure fuel injection system of diesel engine.
本文介绍一种利用柴油机高压泵喷油管壁上的压力波脉冲信号，来测量柴油机转速的新方法。
应用推荐