Therefore, to maintain uniform temperature distribution of the blank is crucial for the cooling system design of the die.
因此使板料在成形过程中保持均匀的温度分布是模具冷却系统设计的关键。
This new flow pattern can induce a strong heat conduction effect in the cooled plane, and develop a uniform temperature distribution.
这种新型的换热结构可以在被冷却面上造成强烈的导热效应,从而形成均匀的温度分布。
A high and uniform temperature distribution along the outer surface of the combustion chamber is necessary to ensure a high radiation power density.
微燃烧室的外表面必须产生一个高而均匀的温度分布,以尽可能高地输出辐射能。
To achieve a completely uniform temperature distribution on the thin strip surface, orthogonal experiment is used for optimizing the heater structure.
为了使薄板表面的温度均匀分布,应用正交试验法对感应加热器的结构进行了优化。
Non uniform temperature distribution causes deviation in emission current, the error of which is less than 5% for the shortest length of diode cathode.
对阴极温度的不均匀导致的发射电流偏差进行了计算分析,并首次得到了发射电流误差小于5%的阴极丝最小长度的计算公式。
Simulation results show a smooth filling, uniform temperature distribution and few flaws such as gas inclusion and cold shut. A casting with a good quality was obtained.
模拟结果表明,该浇注系统填充过程平稳,温度场分布均匀,所得压铸件气体夹杂和冷隔缺陷少,整体质量较高。
It is found that the more uniform temperature distribution could be acquired by strengthening the cooling in the fillet part of the H-beam in the controlled cooling process.
结果表明:在轧后控制冷却过程中,若冷却水集中从 H型钢腿部外侧对其腰腿接合处进行快速冷却可获得较均匀的温度分布。
The analysis results prove that the designed chip has uniform temperature distribution and higher temperature rising and cooling rates and could meet the requirement of PCR.
分析结果表明设计的聚合物芯片温度分布均匀,有较高的升、降温速率,可以满足PCR反应的要求。
In order to reach uniform temperature distribution in tunnel bogie hearth furnace, the technology of pulse firing control of high velocity burner with air diffusion is proposed.
为解决隧道式淬火炉炉温分布不均匀的问题,采用了高速调温烧嘴脉动燃烧控制技术。
A flat plate heat pipe (FPHP) can remove hot spots and thus results in more uniform temperature distribution in electronic devices, and also heat sink can obtain better performance.
平板热管具有很好的均热性,能够避免电子器件散热时热点的产生,使热沉具有更好的散热效果。
Complex patterns of flue gas and non-uniform temperature distribution along furnace height were taken place due to high jet velocity of bottom burners in the ethylene cracking furnace.
乙烯裂解炉底部燃烧器的燃气射流,使炉内烟气流动复杂,烟气温度分布的均匀性较差。
The production verifies that the desirable filling can be formed in the optimized ingate, which plays the uniform temperature distribution in the die and eliminates the cold shut in fi...
实际生产表明,改进后的内浇道形成了较理想的流态,使模具温度分布均匀,同时消除了铸件充型远端的冷隔缺陷。
It is demonstrated that selecting an optimum heat treatment process and making uniform temperature distribution in the furnace is favourable to improving the dynamic properties of aluminum alloy.
试验表明,选择最佳热处理工艺和改善热处理炉温度场均匀分布对提高铝合金力学性能具有重要意义。
Refrigeration system for high-quality full-closed compressor, refrigeration capacity, low noise, high-quality box with a fan device, forced air convection, a more uniform temperature distribution.
制冷系统为优质全封闭压缩机,制冷量大、噪音低,箱内配以优质风机装置,强迫空气对流,温度分布更加均匀。
Simulated results show that obtained parts has few defects, such as inclusion and cold shut due to smooth mold filling and uniform distribution of temperature field.
模拟结果表明,该浇注系统填充过程平稳,温度场分布均匀,所得压铸件气体夹杂和冷隔缺陷少,整体质量较高。
The temperature distribution and stress distribution of blast furnace tuyere with gradient coating have been studied using finite element analysis software, comparing with uniform coating.
采用有限元分析软件研究了梯度涂层高炉风口的温度分布和应力分布,并与均匀涂层进行了比较。
Temperature distribution of MHP is uniform and its amplitude depends on pressure.
微热板区域温度分布较均匀,温度大小受气压影响较大;
The SEM test results indicate that the grain size of the material become bigger with the temperature rising but the granulometric distribution has a still uniform distribution.
SEM测试表明材料的粒径随着温度的升高而迅速增大,但颗粒的分布比较均匀。
The results show that the temperature distribution in jacket mini-cold storage is the most uniform, and the weight loss of vegetables is less by 2% in comparison with one with two.
结果表明,夹套式送风方式的微型冷库具有最好的温度场分布,并且贮藏过程中白菜及菠菜的失重最少,比一拖二送风方式下的失重少2%。
Temperature lasting time has little effect on the compressive strength after the temperature distribution becomes uniform.
而当试件温度分布均匀后,温度持续时间对混凝土受压强度的影响很小。
Temperature-sensing curves show that temperature distribution of horizontal well section was well improved and uniform steam injection was realized.
测温曲线表明,水平段温度分布得到了很好的改善,实现了均匀注汽。
This paper describes a microcomputer compound control system for single phase resistance-heated furnace based on power and temperature regulations with uniform distribution and zero trigger.
本文介绍一个单相电阻炉均布式零触发调功调温的微机复合控制系统。
Transistor thermal spectrum, as a new method, different from the commonly infrared thermogram, is introduced to characterize the non-uniform property of the junction temperature distribution.
晶体管热谱是表示晶体管结温不均匀性的一种与热像图不同的新方法。
Temperature uniformity in the laser exposed area has been seldom reported. It's a significant work to research how to uniform the temperature distribution in the processed area.
国内在激光微细加工区域温度均匀化研究方面少见报道,国外也对此领域研究不多,所以很有必要研究激光微细加工微小区域的温度分布均匀化。
When a transistor dissipates power on work, its junction temperature distribution is commonly non-uniform.
晶体管在耗散功率时,结温分布一般不均匀。
To obtain more uniform distribution of temperature and heat flux could raises supply water temperature or reduces temperature difference between supply and return water;
为了得到更均匀的温度及热流密度分布,应适当提高供水温度或降低供回水温差;
Active automatic uniform distribution viscous acid unblocking technique used in high temperature and pressure fracture -pore reservoir oil well was reported.
报道了将活性自转向稠化酸用于高温高压裂缝—孔隙型油藏油井酸化解堵技术。
The thermal problem is dominant, the temperature field is complicated, thus, the non-uniform distribution of temperature field brings stress and distortions of parts produced.
成形过程中温度场是复杂多变的,这样的温度场会引起应力场而使得零件发生变形。
The thermal problem is dominant, the temperature field is complicated, thus, the non-uniform distribution of temperature field brings stress and distortions of parts produced.
成形过程中温度场是复杂多变的,这样的温度场会引起应力场而使得零件发生变形。
应用推荐