Measurementformotor winding insulation resistance.
测量电机绕组绝缘电阻值。
The results provide a basis for the evaluation of the residual life of large motor winding insulation.
这为评定大型电动机主绝缘的剩余寿命提供了参考依据。
On-line partial discharge monitoring is one of the most effective methods for winding insulation diagnosis of large generator stator.
局部放电测量是诊断定子绕组绝缘最为有效的方法的之一。
The standard is applicable to stator coil and winding insulation alternative and direct current voltage withstanding test for AC generator, synchronous phase modifier and AC motor.
本标准适用于交流发电机、同步调相机和交流电动机定子线圈及绕组绝缘交、直流耐电压试验。
The stator winding must be impregnated with insulation paint and dried before refitting.
定子绕组在重新安装前必须侵绝缘漆和烘干。
The stator winding is F class insulation structure, the end of winding is fixed and binded reliably.
定子绕组采用F级绝缘结构，并在绕组端部有可靠的固定及绑扎。
This paper discusses the influence of the design mode on insulation system including solid insulation and insulation liquid, and carries out the heat analysis of winding and oil duct.
文章讨论了这些设计方式对绝缘系统包括固体绝缘和绝缘液体的影响，并且对绕组和油道进行了热分析。
With consideration of ST's insulation and volume, the parameter of ST was determined by the theory analysis and computation of the primary winding.
通过对初级绕组的计算分析及考虑体积、绝缘的基础上，确定了ST的相关参数。
An A. C. voltage of 2000 volts is applied between the winding and ground to test the integrity of the insulation between the winding and core iron.
在线圈绕组和地线上加上200 0伏交流电以测试线圈绕组和芯铁之间的绝缘的整体性能。
The methods of analysis on series insulation strength for continuous, interleaved and intershield winding are introduced respectively. The analysis on series insulation at VFTO is discussed.
提出了连续式、纠结式和内屏蔽结构变压器绕组纵绝缘强度的分析方法，对特高压暂态过电压(VFTO)下变压器绕组纵绝缘强度分析进行了探讨。
The resistivity of anti-halo material has non-linear property which can improves the field distribution of insulation structure at winding end of power transformer.
防晕材料的电阻率具有非线性特性，此特性能改善电力变压器绕组端部绝缘结构的电场分布。
Therefore a diagnosis of insulation condition to stator winding is an extremely important means to the assessment of electrical machine, especially for large one's insulation system.
因此，对定子进行绝缘状况诊断是评估电机特别是大电机绝缘系统非常重要的手段。
Accident -easons of winding turn-to-turn insulation in a Hv motor are analyzed, protection measures and accident inspection methods are discussed.
论述了高压电机绕阻匝间绝缘故障发生原因，保护措施以及故障检测手段等，提出了提高匝问绝缘可靠性的办法。
This paper determined the shape of the Angle rings through which calculated the ending dimension of winding-insulation configurations and the maximum electric field intensity.
通过对电力变压器绕组端部绝缘结构尺寸与最大场强的计算，确定了角环的形状。
Most of the transformers end of life because of the loss of its insulation capability, which is mainly affected by the winding temperature of the transformer in operation.
变压器绕组最热区域内达到的温度，也是变压器负载值的最主要限制因素。
The primary winding is with oil-paper capacity insulation structure.
一次绕组采用油纸电容型绝缘结构。
Impregnating coil winding system for handling, good insulation, coil heating temperature is low;
线圈绕制后浸漆处理，绝缘性能好，线圈发热温度低；
It used exploration method to fix the amount and means of arrangement for Angle rings, thereby to reduce the ending dimension of winding-insulation configurations.
采用试探法确定了角环数目及布置方式，从而降低了端部绝缘结构尺寸。
Manufacturing of the half-aired insulation from porous Teflon conductor. Thanks to the effect of cold state fluidity, tapes are sticked together during the winding process.
用多孔teflon导体制作半中空绝缘体时，由于冷态流动效应，在绞合过程中胶带会紧紧地粘固在一起。
Manufacturing of the half-aired insulation from porous Teflon conductor. Thanks to the effect of cold state fluidity, tapes are sticked together during the winding process.
用多孔teflon导体制作半中空绝缘体时，由于冷态流动效应，在绞合过程中胶带会紧紧地粘固在一起。
应用推荐