Analysis shows that the absolute values of difference workpiece diameter will increase with the increases of tool setting error.
分析表明：零件直径方向的尺寸差值的绝对值随着对刀高度误差的增大而增大；
This function can make numerical control system according to the point in the X coordinates, as the diameter of the workpiece calculated value spindle speed, and the cutting speed to be constant.
该功能可以使数控系统根据刀尖所处的X坐标值，作为工件的直径值来计算主轴转速，使切削速度保持恒定。
Diathermanous furnace inductor, is also know as through-type inductor, it is long or short according to the length of heating workpiece and the diameter of the workpiece.
透热炉感应器，又称贯通式感应器，根据加热工件的长短和工件的直径大小，感应器有长有短。
This paper presents a study of the edge cutting pin′s hole diameter and the relationship between the said diameter and the maximum angular error of a workpiece.
本文就削边销及其配合孔的直径与工件最大转角误差的关系进行了分析计算。
This operation creates a tapering of the workpiece via the use of a rotating hammer, which produces stepped columns and shafts of declining diameter.
这次行动创造了一个楔的工件通过使用旋转锤，生产，加强栏目和竖井下降的直径。
The roll lapping machine is one of the equipments processing the excircle surface of minor diameter workpiece by lapping. The working accuracy is affected directly by the guide wheel of this machine.
滚研机是小直径工件外圆表面研磨加工设备之一，该机导轮表面形状直接影响加工精度。
The thesis aims to the special areas which require non-contact and online measuring the diameter of workpiece.
本文针对需要对工件直径进行非接触在线检测的特定领域。
As for small diameter workpiece, martensite distribution can be obtained by immediately quenching.
对于直径较细的工件，轧后立即淬火几乎可得到全部马氏体。
The aiming and positioning of measured points in diameter measurement of a large-scale workpiece is a key technology. It is a difficult measurement problem, which has not been solved.
大型工件内外径测量点的瞄准和定位是大直径测量中的一个关键技术，也是国内外未能很好解决的测量问题。
Free operation is realized, thus effectively solving a problem of the bore that the diameter is big and a difficulty of a large workpiece that the work range is large.
实现了操作自由，有效解决大直径的钻孔问题并解决了大型工件加工范围大的困难。
Simulation results show strain distribution of workpiece and how outer diameter, thickness, axial elongation of some typical nodes change with time.
分析了毛坯的应变场分布，典型节点外径、壁厚、轴向伸长量随时间的变化曲线，对整个成形工艺及变形机制有较好的动态认识。
Simulation results show strain distribution of workpiece and how outer diameter, thickness, axial elongation of some typical nodes change with time.
分析了毛坯的应变场分布，典型节点外径、壁厚、轴向伸长量随时间的变化曲线，对整个成形工艺及变形机制有较好的动态认识。
应用推荐