提出一种基于集成电路超微细加工技术制造电磁干扰滤波器的薄膜集成制造新技术。
A new technique for fabricating EMIF in thin film IC based on superfine processing technique is proposed.
为了进行可靠的浪涌保护以及满足电磁兼容的要求，将压敏电阻与电磁干扰滤波器结合起来进行浪涌抑制。
In order to suppress surges reliably and meet the requirements for EMC of the electronic devices, the metal-oxide varistor and electromagnetic interference filter are combined to suppress surge.
分析了电源电磁干扰产生的机理及电源滤波器的作用；
The function of power filter and the mechanism of electromagnetic interference is analyzed.
共模扼流圈的高频特征极大地影响了电磁干扰（EMI）滤波器抑制传导EMI噪声的性能。
The high frequency parasitic parameters of common mode(CM) choke significantly influence the performance of electromagnetic interference(EMI) filter for conducted EMI suppression.
高频开关电源是严重的电磁干扰源，很多情况下需对其安装emi电源滤波器。
Switch power of high frequency is serious electromagnetic interference (EMI) source, so EMI source filter usually should be added in switch power.
由于逆变器电源对输出接地电容的限制，对严重的共模电磁干扰难以用大容量的共模滤波器抑制共模噪声。
With the limitation to the ground capacitance by inverter, it is difficult to suppress the severe common-mode noise by large CM filter.
最终达到消除PWM信号中的开关信号和电磁干扰信号，提高效率和保真度，减小输出滤波器的体积和成本。
Filter may serve the role to eliminate switching and EMI interfere in PWM signal. Thus to improve efficiency and fidelity, lower the filter cost and component sizes.
介绍了3种新型保护器件的原理与应用，包括有源电磁干扰(emi)滤波器、集成过电压保护器件和集成过电流保护器件。
The principle and application of three new protection ICs including active EMI filter, over voltage protection IC and over current protection IC are introduced.
通过实例证明，传导性电磁干扰噪声分离网络能对共模和差模噪声进行有效地诊断，为正确选用抑制噪声的EMI滤波器提供依据。
This paper concentrates on conductive EMI noise Diagnosis and impedance matching of EMI filter Design. Experiments show that discrimination network is effect...
通过实例证明，传导性电磁干扰噪声分离网络能对共模和差模噪声进行有效地诊断，为正确选用抑制噪声的EMI滤波器提供依据。
This paper concentrates on conductive EMI noise Diagnosis and impedance matching of EMI filter Design. Experiments show that discrimination network is effect...
应用推荐