The circuit parameters are then analyzed.
的电路参数，然后进行分析。
The changes of equivalent circuit parameters were used to interpret the adsorption process.
用等价线路参数变化说明吸附过程。
The circuit parameters affecting the increase of peak pulse power of the device have been found.
找出了影响提高器件脉冲峰值功率的电路参数。
With admittance circle fitting to experiment data, equivalent circuit parameters can be obtained.
通过导纳圆实验数据拟合，获得相应的等效电路参数。
The three operational modes, steady principle, and design criterion of key circuit parameters are presented.
深入分析研究了这类变换器的三种工作模式、稳态原理与关键电路参数设计准则。
Moreover, by the means of simulation, the influence of circuit parameters on the current wave were investigated.
此外，通过模拟的手段，分析了各种电路参数对放电电流波形的影响。
The effects of the circuit parameters and the geometrical parameters of an exploding foil on the burst current...
分析了起爆回路电参数和金属桥箔几何参数变化对爆发电流的影响规律。
The adjustment of circuit parameters can also induce over-resistence discharge and realize the function of diode.
回路的过阻尼放电，达到使用二极管整流的效果。
This paper also discusses how to select the appropriate circuit parameters according to short-circuit current margin.
短路电流裕量来选择合适的电路参数。
In this paper, the transistor one dimensional DC current-voltage equation which is indicated as circuit parameters is derived.
本文推导了用电路参数表示的晶体管一维直流电流—电压方程。
The main circuit parameters mainly contain AC-side input inductor, DC-side output capacitor, given output voltage of the DC-side.
主电路参数主要有交流输入侧电感值、直流输出侧电容值、给定的直流输出侧电压等。
A four power amplifier combining circuit is given as an example. The circuit parameters are shown and the method of analysis is demonstrated.
以有四个功放的合成电路为例，给出有关电路参数并介绍其分析方法。
Then introduced the theoretical basis of the antenna design and performance parameters: including the circuit parameters and radiation pattern.
接着介绍了天线设计的理论基础和性能参数：包括电路参数和辐射参数。
The design contains the main circuit parameters of the rectifier, drive circuit, measuring circuit and other hardware, and a full software program.
本文设计了该整流器的主电路参数，驱动电路，测量电路等硬件，提出了软件实现的完整方案。
The characteristics of frequency and noise are analyzed, and it is presented how the circuit parameters are selected and the stability is checked up.
同时分析了电路的频率特性和噪声特性，给出了电路参数选择方法及电路稳定性检验办法。
According to the theoretical results, we adjust the circuit parameters and then can find the phenomena of fixed point, periodic attractor, and chaos.
根据理论分析结果，调节电路的参数，可以成功地看到不动点、倍周期、混沌现象。
Then the circuit parameters related to the output characters of the laser were measured to supply the gist of the further optimization of the laser source.
并测量了与激光器输出特性相关的电路参数，为该激光光源性能的进一步优化提供了依据。
The advantage of this method lies in that there is no need to measure the parasitic network separately and estimate the circuit parameters of active region.
结合激光器的等效电路和速率方程分析，避免了单独测量寄生网络和估计有源区电路参数。
Based on the inherent frequencies the dynamic equivalent circuit parameters are calculated and the result is within the discrete range of experimental values.
根据本征频率计算了石英音叉的动态等效电路参数，计算值在实测值的离散范围内。
And factors affecting electric erosion, such as circuit parameters, mechanical parameters, contact materials working surroundings, etc., were also introduced.
还介绍了影响电侵蚀的多种因素，例如：电气参数、机械参数、触点材料、环境因素等。
An equivalent circuit of multi-winding transformer under the impulse voltage test condition has been worked out. The circuit parameters are frequency-dependent.
建立了电力变压器在冲击试验条件下的频率依赖参数的等效电路模型。
The difference of the circuit parameters in the two component circuits makes the quantum fluctuations in one component circuit smaller and that in the other larger.
两个分回路电路参数的不同会使一个分回路中的量子涨落减小，另一个分回路中的增加。
The discharge current pulse of the laser tube obtained by simulation is consistent with that of experimental measurement on the same condition of circuit parameters.
在相同电路参数时，经模拟得到的放电管电流脉冲波形和实测的波形相一致。
The concept of the generalized reflection coefficient can be used to measure the intrinsic parameters and the circuit parameters of the one-port and two-port elements.
运用广义反射系数概念可以测量单端口、二端口元件的本征参数及电路参数。
Then, through analysis of working principle of the controller, comparison between two current hysteretic control, strategies and design of main circuit parameters are given.
接着，本文介绍了控制器的工作原理，给出了两种斩波控制方式的比较、控制器主电路参数设计和驱动电路设计。
A reference sinusoidal circuit based on digital technique and synchronous with the line voltage is investigated. The design principle of the key circuit parameters is given.
本文研究了一种采用数字化技术，实现与电网电压同步的基准正弦电路的原理，给出了电路关键参数的设计原则。
And the law of the commutating current of the breaker is presented with analysis, it will be used for selecting the breaker and confirming the commutating circuit parameters.
并且分析了它们在换流过程中的规律，为电路的开关选择和电流换流回路参数的确定提供依据。
If reciprocity and symmetry exist for passive two port networks of linear time invariant under zero intial condition, the circuit parameters will have some important characters.
对于线性非时变的无源二端口网络，在零初始条件下，若存在互易性及对称性，则其电路参数具有一定的特殊性。
If reciprocity and symmetry exist for passive two port networks of linear time invariant under zero intial condition, the circuit parameters will have some important characters.
对于线性非时变的无源二端口网络，在零初始条件下，若存在互易性及对称性，则其电路参数具有一定的特殊性。
应用推荐