Valve is usually installed in horizontal pipe, the stem vertically upward.
闸阀通常安装在水平管道上，阀杆垂直朝上。
A general structure concept of a horizontal pipe-valve is also introduced.
并介绍了一种水平管阀的总体结构方案。
Gate valve are normally installed in horizontal pipe runs with the stem vertical.
闸阀通常安装在水平管道上，阀杆垂直向上。
Swing check valves are normally designed for installation in horizontal pipe runs.
旋启式通常适用于安装在水平管道上。
Gate valves are normally installed in horizontal pipe runs with the stem vertical.
通常安装在水平管道上，阀杆垂直向上。
Globe pattern check valves should be used in horizontal pipe runs with the stem straight up.
截止阀结构的止回阀应该用于水平管道，阀杆垂直朝上。
Air natural convection around horizontal pipe is a compound heat process of convection and radiation.
空气在横管外自然对流是对流和辐射的复合传热。
This allows our swing check valve to close completely even when installed in a horizontal pipe run with no flow.
这使得我们的旋启式止回阀无论安装在水平管道还是垂直管道上，都能够实现完全的关闭。
A stratified flow in a horizontal pipe represents the most important form of high concentration powder transport flow.
水平管内分层流动是高浓度粉体输送流型中最重要的形式，研究其阻力特性有着重要的意义。
The second pipe was set vertically, with a U-shaped section cut out of one side of the bottom end to mate with the horizontal pipe.
第二根管子倒竖，用一个U型的被切去底部的一边的部件跟平躺的那个管子并排。
This article makes the numerical simulation of particles flow regime in a horizontal pipe by applying the theory of particles trace.
本文采用粒子追踪理论对水平管中粒子流动状态进行了数值模拟。
This article introduced an experimental device for measuring the fluid flow characteristics in the horizontal pipe and short swirling chamber.
介绍一套测量水平圆管和短式旋风筒内流体流动特性的实验装置。
The spiral flow in the horizontal pipe can generate the spiral flow to transport sediment according to the way of equipping the guide blade in the middle of the pipe.
前两种排沙方式已经广泛应用于工程实践中，平轴螺旋管流排沙是近年提出的一种节能、高效的输沙方式，目前还处于试验研究阶段。
The conductivity probe was used to measure the instantaneous local void fraction in the horizontal pipe and the illustrative picture of probability density of flow pattern translation is obtained.
使用自行设计、制作的电导探针测量系统，测量了水平管内瞬时、局部空隙率，并且得到流型转变的特征密度概率图谱。
The differential pressure signals of flow in a horizontal pipe are studied by wavelet analysis. The flow pattern can be recognized easily according to the characteristics of plug flow and wave flow.
采用小波变换分析水平管流上的压差信号，根据段塞流与波状流的小波分析特性，可容易地识别流型。
According to the experimental and theoretical analysis, equations have been presented to predict the pressure drop of a high density gas-solids mixture flow through a horizontal pipe and bend section.
根据实验结果和理论分析，本文提出了高浓度气固混合物在L阀中流动时的压力损失的计算公式。
Developed excogitates of two decumbence and one horizontal molding die realized the increasing height of branch pipe of heat pressure tee.
研发出了两个横梁和一个水平成型模具，实现了热压三通支管高度的增加。
It should be installed in horizontal or vertical section of a pipe where there is a straight run of at least 5 pipe diameters on each side.
流量开关应该安装在水平管道或垂直管道上，每一侧至少有5倍管道直径的直线管道长度。
Valves should be installed in the (stem) vertical position with the pipe flow horizontal only. For installations other than this, please consult factory when ordering.
阀门应该只能安装在水平流向的管线上，其阀杆应该垂直向上。如果需要其它方式的安装，请在订购阀门时咨询工厂。
Swing check valves are used to prevent reversal of flow in horizontal or vertical pipe lines.
旋启式止回阀用于防止水平管路或垂直管路的流体倒流。
Parts in contact with liquid in pipe are of brass and beryllium copper. Flow switch installs in tee in horizontal or vertical piping.
在管道内与流体接触的部件是黄铜和铍铜合金。流量开关以三通管方式安装在水平或垂直管道上。
Horizontal hydrodynamics of deep sea mining lifting pipe consists of two parts: the forces caused by current and wave.
深海采矿扬矿管上的横向液动力由两部分组成：海流作用力、波浪作用力。
Dynamic analysis and parameters selection of electrochemical cutting of production pipe in horizontal hole.
水平井生产管电化学切割动态分析及参数选择。
A fault movement can be resolved into an axial component (parallel to the pipe axis), a lateral component (perpendicular to the pipe axis) in the horizontal plane and a vertical component.
断层运动可分解为轴向分量(与管轴平行)、水平面的侧向分量(与管轴垂直)和竖直分量。
Flux-cored wire is applied to the austenitic stainless steel pipe by back weld, MAG for the filling and cosmetic weld, at horizontal fixed round welding vertically up.
采用药芯焊丝对奥氏体不锈钢管道进行打底焊接，MAG焊填充及盖面焊，立向上的水平固定全位置焊接。
The principle and construction technique of horizontal frozen hole by pneumatic tamping pipe method were introduced in this paper.
介绍了气动夯管法施工水平冻结孔的工艺原理及施工工艺。
The principle and construction technique of horizontal frozen hole by pneumatic tamping pipe method were introduced in this paper.
介绍了气动夯管法施工水平冻结孔的工艺原理及施工工艺。
应用推荐