Besides being light, it does not suffer from any memory effect, which is the loss in capacity when a battery is recharged without being fully depleted.
除了它比较轻之外，它不受任何记忆效应的影响——电池没有耗竭就充电会导致容量上有损失，这种效应称为记忆效应。
The i3′s battery will charge to 80% capacity in one hour with a charging option, otherwise a full charge will require six hours on the plug.
利用快速充电的方式来为i3充电的话，在仅仅1小时内就可充满80%的电量，而利用标准的电源插座为电池充满电则需耗费6小时的时间。
In fact, Dr Cui says, it is so good that it rivals the energy-storage capacity of the familiar lead-acid battery.
实际上，崔博士说，它表现得很出色，其能量存储能力上能与我们所熟悉的铅酸蓄电池相匹敌。
Older phones were rather inelegant in their charging behavior; usually filling the battery to capacity and then switching to a trickle current to maintain the highest charge possible.
旧款的手机充电相当粗放，通常是电池充满后，充电器切换到涓流电流，来维持一个最高的电量。
Filter plant, officials say, will work in Germany sunshine battery discharge, the staff should be full of electricity within 24 hours, prevent the battery will affect the storage capacity.
过滤器厂的负责人说，将德国阳光蓄电池放电工作后，工作人员应在24小时内布满电量，防止电池会影响存储容量。
Using the BREAK-IN mode, I am seeing a charging capacity much higher than the capacity I programmed. Why is the battery overcharged?
当使用BREAK - IN模式的时候，我看到充电容量比我设置的电池容量高很多，为什么电池会被过冲？
Germany sunshine battery deep discharge resistance is strong, 100% still can pick up on the load continuously after discharge, dominant charging can restore the revival capacity of 95% in January.
德国阳光蓄电池抗深放电能力强，100%放电后仍可连续接在负载上，在一月支配充电可恢回复复兴容量95%。
If low charging rate is desired, you should use the BREAK-IN mode. Charging in that mode is terminated by only time (1.6 times battery capacity) and temperature.
如果你想用很低的充电电流进行充电，应该使用BREAK -IN模式。此充电模式只会因为时间(1.6倍电池容量)和温度终止充电。
The amount of current the battery can supply is strictly limited by the "capacity" of the battery, which in turn depends on the amount of chemicals it contains.
电池所能提供的电流受限于电池的容量；同时，电池的容量又取决于电池中所含的化学物质的含量。
Produced in Germany sunshine battery electrolyte dry, thermal runaway, early capacity loss, internal short circuit, which seriously affect the reliability of power supply system. Have a data sheet.
产生了德国阳光蓄电池的电解液干涸、热失控、早期容量损失、内部短路等问题，进而严重影响到供电系统的可靠性。有资料表。
The recent technical progress in the improvement of the battery capacity and the quick charge performances of Cd-Ni hattery was briefly introduced.
本文扼要地介绍了近期镉镍电池在提高容量和快速充电性能等方面所取得的技术进展。
In the DISCHARGE mode, the final capacity displayed is also the discharging capacity. However, the battery is not recharged.
在DISCHARGE模式下，最后显示的依然是放电电量。但是电池会在放电结束后不会对电池进行充电。
Alkaline manganese batteries with high capacity, stable work voltage, good low temperature property and long service life were widely used in all the primary battery.
在碱性电池中，碱锰电池具有容量高、工作电压比较稳定、低温性能较好、贮存寿命长等优点，其应用最为广泛。
The calculation process is proposed, which proves to be convinent for the capacity choosing of the storage battery in integrated automation substation.
该文介绍了其计算过程，对综合自动化变电站蓄电池容量的选择有一定的借鉴意义。
To supervise on battery and configure properly their capacity is propitious to battery life and keep UPS system operate in a stable and safe status.
对蓄电池组进行监测管理与合理配置容量，有利于延长其寿命，保证UPS系统稳定、安全运行。
However, when the battery was discharged at high rate, the voltage peak would be in the curve of discharge voltage and the discharge capacity would also be increased.
然而在高倍率放电的条件下，电池的放电电压曲线会出现电压峰，同时电池的放电容量也有所增大。
It was shown that the particle size distribution of lead powder played an important role in plate porosity, initial capacity and cycle life of the battery.
结果表明：铅粉粒径对极板的孔隙度、成品电池的初始容量、充电接受性和循环寿命有较大影响。
The battery charger capable of correcting the deterioration of a secondary battery left unattended in a charge state and capable of accurately grasping a residual capacity.
所述电池充电器能够校正在充电状态下保持被搁置的二次电池的劣化，并且能够准确地掌握剩余容量。
In the meantime, they were required to download a program that limits the battery capacity to 60 percent and to reinstall all of applications for exchanged devices.
与此同时，机主们还被要求下载一个软件来将电池电力控制在60%的水平，而且要想更换手机他们还必须重新安装所有应用软件。
Transition metal compound has been the focus as anode material in lithium ion battery since it has high lithium storage capacity and new energy storage mechanism.
过渡金属化合物由于具有较高的储锂容量和崭新的储能机理，成为近些年锂离子电池负极材料中的研究热点。
Uses in the electric conductance monitor solution the density change, determined differently circulates under the sufficient electric discharge condition battery capacity.
采用电导监测溶液中浓度的变化，确定不同循环充放电条件下的电池的容量。
From parts above we can know battery we usually buy is battery unit which can be series or parallel connected in several sets. Battery volume increases with the capacity.
通过这三个参数可以知道，我们购买的电池其实是一个电池组，由许多单节的电池通过并联和串联得到的电池组，通常电压越高容量越大的电池体积也越大。
Leads battery package design, technical standard and specification development to meet project needs in quality, cost, lead-time and capacity.
负责电池包装设计，确认技术标准和规格以满足项目在质量，成本，周期时间和生产能力上的要求。
In addition to trying to identify specific instruments that would have vocational and communication-related applications, I also wanted to build into the battery some form of validation capacity.
除了需要选出能够在职业和沟通相关问题方面使用的特定工具外，我还需要在这个评估体系中加入再确认的能力；
One option I did select was the 3-year extended warranty for the battery. In my experience a battery loses about half its capacity in about 18 months.
我还为电池选了3年的保修，因为根据我的经验，18个月内，电池的容量就会减少一半。
In addition, the battery should be store in half-charging state, in order to avoid over-discharge caused by self-discharge, and this will lead to irreversible capacity loss.
另外必须使电池处于半充满状态贮存，以防止电池因自放电而产生过放电，发生不可逆容量损失。
It is one necessary procedure to format high-capacity power battery in production process. To complete the entire battery production, every battery should be charged and discharged several times.
在大容量动力型电池生产过程中必须要经过化成工序，即在生产过程中对电池进行多次充放电才能完成整个电池的生产。
Capacity: Article 2 of the Regulation lists out the determination of capacity of battery, an accumulator and automotive batteries. Certain test method is specified in Annex II.
条列出可？式(可充电)电池，汽车电池和蓄电池的确定容量。某些测试方法在附件二中已列明。
Capacity: Article 2 of the Regulation lists out the determination of capacity of battery, an accumulator and automotive batteries. Certain test method is specified in Annex II.
条列出可？式(可充电)电池，汽车电池和蓄电池的确定容量。某些测试方法在附件二中已列明。
应用推荐