At this point, you should be back to your initial position.
这个时候，你应该又回到的最初的姿势。
Given an initial position, your program is to determine the winner.
给一个最初的位置，你的节目将确定优胜者。
The historians have a record of an initial position in one of such games.
历史学家拥有这种游戏的一个初始位置的记录。
The group discussion tends to exaggerate the initial position of the group.
所以，团体讨论会倾向夸大团体最初的立场。
This is likely to improve our trade balance, bringing it back to its initial position.
这多半会改善我们的贸易差额，使它回复到最初的状况。
After the nets, stretch, throw reversing valves, make the initial position, close to power.
绷网完以后，扳动换向阀，使手轮回到初始的位置，关闭电源。
But because his initial position was so high, he didn't ask me to raise my offer each time.
但是，因为他最初的立场是云云之高，他并无要求我提出我的提议每次。
This is caused by many factors, one of the biggest problem is the initial position and planning.
造成这种局面的因素是多方面的，其中定位不准的问题尤为突出。
For the rock with single flaw, the initial position of the flaw affects the rock UCS considerably.
对于含单个缺陷的岩样，缺陷位置的不同对岩石强度影响较大。
Absolute positioning requires that robot determines its position when initial position isn't given.
绝对定位要求机器人在不指定初始位置的情况下确定自己的位置。
A simple and effective initial position detection method of surface-mounted PMSM Rotor is analyzed.
分析了一种简单有效的永磁同步电动机转子初始位置检测方法。
Thee initial position of the pieces was incorrect, the game should be cancelled and a new game played.
棋子一开始就摆错了，比赛应取消并重新开始。
The pill initial position efficiency peak value is defined as the distance between pill front end and coil end.
弹丸初始位置定义为弹丸前端与线圈末端间的距离，习惯上把其处于线圈外时效率峰值定义为负。
This method can find the exact initial position and achieve better result of facial feature point localization.
由于能够快速获得较准确的初始位置，进而取得较好的人脸特征标定结果。
The initial position of motor rotor not only affects positioning precision, also has effect on start-performance.
电机的初始位置不仅影响伺服系统的定位精度，而且会对电机的启动性能造成一定的影响。
These reloads add way too much overhead to both the browser and the server and restore the map to its initial position.
这些重载会将太多负荷添加给浏览器和服务器，还会将地图恢复到其原始位置。
The initial position is determined from a precise knowledge of the location of the point of departure of the vehicle.
初始位置是根据对车辆出发点位置的精确认识来确定的。
The initial position of rotor was checked and measured by Hall sensor, and was revised after the rotor starts to rotate.
转子初始位置由霍尔传感器识别，并在转子开始转动后进行校正。
The results show that TC initial position perturbation make its track different, but ensemble mean is close to control forecast.
试验结果表明：热带气旋定位误差影响路径预报，但扰动初始位置的集合平均预报与控制试验的预报水平相接近。
In this paper, it has been realized the recognition for weld seam and its initial position in local environment with visual method.
采用视觉方法实现在局部环境中对焊缝及其起始点的识别。
The inverted pyramid, which is also known as the equal amounts pyramid, adds to an initial position in equal share-size increments.
倒金字塔又称等额金字塔，每笔交易的加仓量等额增加。
To improve the active contour model's sensitivity to its initial position, some methods must be applied to widen the image force scope.
为了改进主动轮廓线模型求解过程中轮廓线初始位置的敏感性，通常要采用一些方法扩大图像力的作用域。
The initial position detection is one of the key technologies to realize the precise control of linear motor as same as the rotary motor.
直线电机的初始位置检测与旋转电机一样是实现电机精确控制的关键技术之一。
Adopting the method of delaying minimum time in initial position, the time-optimal and collision avoidance track of dual robots was obtained.
采用在初始位置延迟最小时间的方法，获得了双机器人时间优化的无碰撞轨迹。
Based on the saturation effect of winding inductance, an estimation method of initial position for SPMLSM without a position sensor was presented.
利用绕组电感饱和效应，即由于磁路饱和引起的电感随动子位置角变化的规律，检测表面式永磁直线同步电机动子的初始位置。
The experiments of segmenting left ventricle MRI images show that this model be independent of the initial position and can segment image automatically.
实验结果表明，该模型与轮廓线初始位置无关，能实现MRI 图像的自动分割。
Then position detection technology, hardware and software system design is discussed. The initial position of the motor is a main problem for control of PMLSM.
然后针对永磁直线同步电机控制系统的主要难点，分为位置检测技术，硬件系统设计和软件系统设计三个方面对控制系统进行分析。
Then position detection technology, hardware and software system design is discussed. The initial position of the motor is a main problem for control of PMLSM.
然后针对永磁直线同步电机控制系统的主要难点，分为位置检测技术，硬件系统设计和软件系统设计三个方面对控制系统进行分析。
应用推荐