The numerical simulation of the injector of atmospheric gas burner is carried out using software FLUENT, and the relationship between nozzle position and primary air coefficient is obtained.
采用FLUENT软件对大气式燃气燃烧器的引射器进行数值模拟，得出喷嘴位置与一次空气系数的关系。
In tangential combustion system, the reheat steam temperature can be adjusted by changing burner nozzle Angle to just the flame position.
在切向燃烧系统中，通过改变燃烧器喷口的角度可以调节炉内火焰中心位置，可达到调节再热汽温的目的。
Experimental research on atomizing properties of spinning air atomizing spray nozzle of crude oil burner.
气动旋流雾化原油喷嘴雾化特性的实验研究。
The SW Sidewinder Flat Flame burner is a nozzle mix excess air burner designed for radiation heating.
SW钙土平焰炉头是一款烧嘴混合过量空气炉头，辐射加热设计。
In this article, the test results of a tilting burner with short nozzle on a cold model, in a pilot plant and under actual operating conditions are presented.
本文介绍了摆动式燃烧器短喷嘴结构冷态模拟试验结果，以及中间工业试验和热态运行试验结果。
With high oil consumption and low thermal efficiency of boiler truck, a new type burner nozzle is brought forward based on the analysis study of the burning mechanism of boiler.
针对锅炉车燃烧时耗油量大、锅炉热效率低等特点，从锅炉的燃烧机理上进行了分析和研究，提出了一种新型燃烧器。
This paper describes the design method of full automatic integrated oil burner with centrifuge mechanical spray nozzle.
本文论述了利用离心式机械雾化喷嘴构成集成式全自动段式燃油锅炉燃烧器的设计方法。
It is pointed out that the soot volume depends greatly upon ash content in the fuel, the performance of burner nozzle, air temperature, and burning operation.
指出燃料灰分含量的高低、燃烧器雾化质量好坏、燃烧空气温度的高低及操作人员的技术水平的高低都是影响灰垢生成量的主要因素。
The nozzle body extends towards the outside of the pump body to provide a burner with supercharging oil.
所述喷嘴体朝泵体的外部延伸，以便将增压油供至一个燃烧器。
Selection of the primary and secondary airflow rate, the guide Angle of the blade, the primary air ratio as well as the material for manufacture of the burner nozzle are given.
然后介绍了一、二次风速，旋流叶片的导角，一次空气比例系数等参数的选择及制造烧嘴的材料。
Selection of the primary and secondary airflow rate, the guide Angle of the blade, the primary air ratio as well as the material for manufacture of the burner nozzle are given.
然后介绍了一、二次风速，旋流叶片的导角，一次空气比例系数等参数的选择及制造烧嘴的材料。
应用推荐