The negative pressure gradient and slip velocity in standpipe increase with the increase of circulating rate.
随着循环量的增大,立管内的负压差梯度及气固相对速度也随之增大;
The distribution of slip displacement, slip velocity and friction force on the strike slip fault were obtained by numerical simulation.
通过数值计算得到了平移断层上滑移位移、速度及摩擦力的分布规律。
According to the simulation data of slip velocity and adhesion coefficient, a fuzzy model, RV-TS model, is built to describe the adhesion characteristic curve.
通过仿真实验,采集蠕滑速度和粘着系数的数据,利用RV -TS模型对粘着特性曲线进行模糊建模。
The experimental results show that the radial profiles of local slip velocity are non-uniform :flat in the central region and steep in the region near the wall.
实验结果表明,提高颗粒循环速率,在任一径向位置的气固滑落速度均增加;
The rollers and ring are designed in inverted trapezium, which reduce the material's slip velocity between rollers and ring, extend grinding time, and enhance crushing efficiency.
该机将磨辊与磨环设计成阶梯状,降低了进入磨辊与磨环之间物料的下滑速度,延长了对物料的碾压时间,提高了粉碎效果。
When driving across a hill, vehicles do not lose linear velocity. At a certain angle, vehicles start to slip off the hill.
当行驶越过一座山,车辆不失去线性速度。从某个角度看,车辆开始从山上滑下去。
A method for resolving the energy equation of the circular microchannel, which considers axial heat conduction, temperature jump, velocity slip and thermal entrance is presented.
提出了一种考虑轴向热传导、速度滑移、温度跳跃和入口效应情况下圆形微通道能量方程的求解方法。
The results show that both the inter-phase velocity slip and temperature slip always exist in the whole two-phase region, but are not obvious.
结果显示:气液两相间的速度滑移和温度滑移在整个两相区一直存在,但在绝大部分区域内,这种非平衡性并不显著;
It is explained in this paper what the velocity component contours in slip-line-field are and how to draw them.
本文论述了滑移线场中理论速度分量等值线的概念及作法。
The effects of the temperature jump and the velocity slip on the heat transfer for the slip-flow regime in the cold trap of the freeze dryer are considered.
对真空冷阱中处于滑流区的气体换热,应考虑温度跳跃和速度滑移对换热的影响。
The precondition of realizing slip ratio based on Anti-lock Braking System(ABS) is the accuracy measurement of vehicle velocity.
实现基于滑移率控制的汽车防抱制动系统的前提是车速的准确测量。
In hardware designing, TMS320F2812 and its peripheral circuit make up the velocity capturing circuit. Anti-skid controller controls slip ratio error and exports braking pressure signal.
在硬件电路设计上,防滑控制器采用TMS320F 2812和外围电路构成速度捕获电路,完成滑移率偏差的控制并输出刹车压力信号。
The average sedimentary velocity under no-slip wall condition is largely less than that under periodic wall boundary condition.
固壁条件下多根椭圆粒子的平均沉降速度大大小于周期性壁面条件下的平均沉降速度。
In the paper, the steady NS equation was solved to simulate aircraft roll by adding tangent velocity to no slip wall boundary condition.
文中在物面无滑移边界条件的基础上施加物面绕体轴的切向速度,通过求解定常ns方程对飞行器滚转进行模拟。
Based on the tire magic formula model, the dynamic variation process of the tire optimal slip ratio and the maximum friction coefficient on the road with the vehicle velocity is researched.
基于轮胎的魔术公式模型,研究了轮胎在路面的最佳滑移率和最大摩擦系数随汽车速度的动态变化过程。
The velocity field and shear rate distribution are reduced and uniform along with the proper increase of slip length. The die swell and the interface deflexion phenomenon will be reduced effectively.
适当增加流道的长度,可以减小胶料出口处的速度场、剪切速率场的集中程度并使之趋于均匀,能够有效降低挤出胀大和模外熔体偏转流动现象。
Another nonlinear inversion controller was designed for the slow variables. It allows the pilot to control the slow dynamics, the Angle of attack, side-slip Angle and the velocity bank Angle.
对慢变量进行非线性逆控制器的设计可使飞行员控制飞机慢动力学,即迎角、侧滑角和速度矢量滚转角。
When the forward slip difference is large, the influence of velocity difference is small and workpiece is easily bent…
前滑差小时,速差起主导作用,轧件易往小辊或慢辊侧弯。
Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.
粘附滑移流动是一种密集颗粒的急跳式的运动,在壁面处,颗粒的速度稍低于呈杆状的中心的速度。
Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.
粘附滑移流动是一种密集颗粒的急跳式的运动,在壁面处,颗粒的速度稍低于呈杆状的中心的速度。
应用推荐