Therefore, are used in high temperature steam pipe, water pipe.
因此，常被用在高温水蒸气输送管道、水煤气管道中。
Vibration of main steam pipe seriously affect the unit's running security.
摘要：主蒸汽管道振动严重影响机组运行安全。
Elbow is one of parts in the system of main steam pipe which is easy to damage.
弯管是火力发电厂主蒸汽管道系统中较易损坏的部件之一。
The steam trap is a valve that releases condensate water in steam pipe network system.
蒸汽疏水阀是一种用于蒸汽管网系统中疏导冷凝水的阀门。
The residual life prediction model of steam pipe and design of module were discussed in details.
分析管道寿命预测的模型及模块的设计过程。
The design of quality inspection center for key products used in steam pipe network is introduced.
介绍了蒸汽管网关键产品(疏水阀、减压阀、温控阀、凝结水回收泵等)质量检测中心的设计。
Induction pressure welding is often used to manufacture the butt joints of steam pipe of power plant.
感应压力焊常用于生产电站蒸汽管对接接头； 但在抽检样品时接头断口上有时存在所谓的“白斑”组织。
To clean frozen process equipment, workers use frequently steam provided by a hose linked to a steam pipe.
对于结冰工艺设备的清理，工人经常使用的工具是一根连在蒸汽管上的软管。
This Paper introduced structure reform for main steam pipe of heat and power plant at a Petrochemical factory.
本文简述了某炼油厂热电站主蒸汽母管的结构改造和动力设备的调优运行。
Mainly used in steam pipe above, the compensation steam pipe for heat bilges cold shrink from the displacement.
主要用在蒸汽管道上面，补偿蒸汽管道因热胀冷缩产生的位移。
This paper introduces the structure of this system and the theory of setting up numerical models of steam pipe system.
介绍了该系统的构架和建立蒸汽管网数字模型的理论。
There were some analysis and probe of creep in main Steam pipe and reheat pipe (hot segment) in service utility boiler.
对目前在役的高压电站主蒸汽管道和再热汽管道(热段)蠕变现象进行了分析与探讨。
Steam pipe configuration shall be such as to prevent entrainment of any heating steam into boiler feed pump suction lines.
蒸汽管结构应能避免将任何加热蒸汽带入锅炉给水泵吸入管路。
Finally, this paper describes a better model of the speed-governing systems, steam pipe and penstock with emphasis on t...
介绍了功能上比较完全的调速器及汽、水管道模型装置，并着重分析了其中的一些问题。
Flugel formula can be used to calculate pipe pressure loss of extractive steam and diagnose problems of extractive steam pipe.
弗留格尔公式可用于计算变工况下抽汽管道的压损，也可用于诊断抽汽管道的故障。
Regarding the abnormal large vibration of reheat steam pipe of unit 3 for Shandong Huangdao Power Plant, the causes were analyzed.
针对山东黄岛发电厂3号机组再热管道出现的异常大幅度振动，进行了原因分析；
Finally, this paper describes a better model of the speed-governing systems, steam pipe and penstock with emphasis on the analysis of som...
介绍了功能上比较完全的调速器及汽、水管道模型装置，并着重分析了其中的一些问题。
This paper analyses accident cause for steam pipe on Wudang Road and points out some attentive questions to extend as far as pipe engineering.
本文对采用直埋敷设方式的武当山路蒸气支管事故调查和原因进行了分析，提出了应用该技术需注意的问题。
Through statistics and analysis dealt with the steam output and sales, and got the overall change rules of steam load and the steam pipe heat loss.
对蒸汽热网的蒸汽产量和销售量进行了统计和分析，得出了蒸汽负荷的总体变化规律和总的管网蒸汽损失。
The bottom of the water tank is connected with a water return pipe which is provided with a water return valve and is communicated with the steam pipe.
水箱底部连接有回水管，回水管上装有回水阀并且和蒸汽管连通。
CFD software is used to perform 3-d numerical simulation of steam flow field inside direct air-cooling exhaust steam pipe of a 660 MW supercritical unit.
利用计算流体动力学软件(CFD)，对某660MW超临界发电机组直接空冷排汽管道内的水蒸汽流场进行了三维数值模拟研究。
According to the total strain energy failure theory author provides calculate formula of creep Life loss in creep deformation accumulation of steam pipe.
根据总应变能理论，作者提出按管子累积蠕变变形量计算寿命损耗量。
These regulations shall include the necessary measures for such symptoms as high water level alarming, metal temperature sharp fall or steam pipe vibration.
这些规定应包括有出现如高水位报警，金属温度急剧下降或蒸汽管道振动等征兆时必须采取的措施。
1 before the fire, steam boiler, should check the valve pipe, steam pipe, pressure gauge, safety valve, water level gauge, drain valve is in good condition.
蒸汽锅炉生火之前，应检查各阀门水管、汽管、压力表、安全阀、水位表、排污阀等是否处在完好状态。
The steam pipe and correlative branch pipe of power plant are detected to appear thermal diffuse crack, which influence the normal run of the generator severely.
发电站蒸汽管道的支管连接部位以及与之相连接的支管接管座处出现的热疲劳裂纹，严重影响了发电机组的安全运行。
According to the welding properties of P91 and C12A steels, the paper presents a welding solution to assemble C12A water pressure valve to P91 main steam pipe in field.
根据P 91和C12A钢的焊接性能，提出了现场中在P 91主汽管道上加装c 12 A水压闸阀的焊接工艺措施。
The product applies to such industrial steam heating equipment as petroleum, chemical, printing, paper making and pharmaceuticals and discharge of the steam pipe network.
它适用于石油、化工、印刷、造纸、制药等工业蒸汽加热设备和蒸汽管网的阻汽排水。
The method of through monitoring 16N activities in the main steam pipe to get the leak rate of steam generator, now is the main way of steam generator leak rate monitoring.
基于主蒸汽管道中16N核素监测的蒸汽发生器泄漏率监测方法，目前已成为蒸汽发生器泄漏监测的主导方法。
Aimed at effectively monitoring and managing indoor steam pipe network in thermal plant, mathematic model of steam pipe was constructed which based on exergy analysis method.
为了提高对某热力厂室内蒸汽管网的监测和管理，以火用分析方法为基础，建立蒸汽管网的数学模型。
Aimed at effectively monitoring and managing indoor steam pipe network in thermal plant, mathematic model of steam pipe was constructed which based on exergy analysis method.
为了提高对某热力厂室内蒸汽管网的监测和管理，以火用分析方法为基础，建立蒸汽管网的数学模型。
应用推荐