The elasticity module of ADI is lower than that of steels, so that the surface contact stress borne by ADI gears during working process would be lower than steels.
奥贝球铁材料的弹性模量比钢小，因而奥贝球铁齿轮工作时受到的表面接触应力比钢齿轮小。
Bearing contact fatigue failure of the working surface by means of alternating the role of stress arising from failure.
接触疲劳失效系指轴承工作表面受到交变应力的作用而产生失效。
In this paper, an electric device is proposed to measure contact stress on the sealing surface of sealing elements.
介绍了西北工业大学研制的密封面接触应力的电测装置。
When analyzing structures with joints or cracks, state changing of these interfaces will affect stress and displacement of contact surface.
对这些有缝结构进行计算分析时，接缝及裂缝状态的变化会使得接触界面的范围和界面上的应力和位移不断发生变化。
The curvature radius was derivated and the contact stress of the three-arc-sect isometric type surface was calculated through the elastic dynamics theory.
应用弹性力学理论，推导出接触点的曲率半径，对三弧段等距型面联接进行接触应力计算。
Particle penetrating direction has influences on the magnitude of surface deformation, contact pressure and stress, and the distribution forms of contact pressure and stress.
磨粒侵入方向不仅影响材料表面变形、表面接触压力和表层应力的大小，而且会引起压力和应力分布形状的改变。
By using the finite element method, the dynamic stress caused by vertical contact impact between bolt locking surface and barrel extension locking surface of a new rifle was studied.
采用有限元方法研究了某新型自动步枪枪机闭锁面与节套闭锁面间垂直接触碰撞的动应力。
Due to the above mentioned defects, early fatigue peeling occurs under the condition of overly contact stress at the top of the tooth caused by abnormal contact at the tooth surface.
因此，在齿面非正常接触导致齿顶接触应力过大的情况下，该齿轮发生了早期疲劳剥落。
In the mechanism analysis of consolidation of foundation soil by heavy tamping method, the dynamic contact stress calculation of hammer bottom and foundation surface is the key technical problem.
在强夯法加固地基机理的分析中，夯？底部与地基表面的动接触应力计算是关键技术问题。
The analysis on fatigue cracks of the outer race of aero-bearing shows that the distribution of residual tensile stress on race surface could reduce its contact fatigue life.
航空轴承外圈的疲劳裂纹分析表明，套圈表面的残余压应力分布致使轴承表面接触疲劳寿命降低。
Statistical characteristic of fatigue strength of contact wires was obtained by comprehensively considering such coefficients as stress concentration, size and surface quality.
综合考虑了接触线应力集中系数、尺寸系数、表面质量系数和材料疲劳强度的影响，得到了接触线疲劳极限的统计特征。
Statistical characteristic of fatigue strength of contact wires was obtained by comprehensively considering such coefficients as stress concentration, size and surface quality.
综合考虑了接触线应力集中系数、尺寸系数、表面质量系数和材料疲劳强度的影响，得到了接触线疲劳极限的统计特征。
应用推荐