The degree or angle of torsional stress.
转轴角-----球旋转时转轴的水平角度。
The state of being twisted into a spiral; torsional stress or strain.
螺旋状，扭力扭成螺旋状；扭转的压力或张力。
This paper analyzes the admissible stresses used to calculate the diamter of axles according to torsional stress and resultant stress, and some suggestions are given.
对按扭矩估算轴径和按弯扭合成力矩计算转轴轴径公式中的许用应力进行了分析，给出了修正意见。
The NNE fault system is mainly controlled by tension-torsional stress, and the NNE-NE fault system by these factors: boundary condition, sedimentary facies zone and regional tensional stress.
NNE向断裂系统主要受张扭应力作用控制；而nne - NE向断裂系统主要受边界条件、沉积相带、区域张应力的控制。
A torsional vibration balancer is used to reduce torsional vibrations on the crankshaft and to minimise component stress e. g. on the belt drive.
采用扭振平衡器来减少曲轴箱的扭转震动，并将部件压力(如皮带驱动上的压力)减至最小。
A torsional vibration damper is used to reduce torsional vibrations on the crankshaft and in turn minimise component stress.
扭振减震器用于降低曲轴上的扭振，进而最大程度上减小部件应力。
Dispersion equations of torsional modes in three different two-layer pipes are obtained by means of analyzing different stress and displacement boundary conditions of these structures.
通过分析不同的应力和位移边界条件得到了三种不同双层管结构中扭转模态的频散方程。
When the torsional vibration amplitude and stress exceed the limit, the rubber torsional vibration damper should be designed to reduce the amplitude within the permitted range.
当扭振振幅或扭振应力超过限值时，设计橡胶扭振减振器将振幅衰减到容许范围内，消减曲轴系统的扭转振动。
The results indicate that the elastic operating stress range of a torsional axis is extended greatly by pre-twist process and the main reason lies on surface residual stress.
结果表明，预扭后扭力轴弹性工作应力范围得到极大扩展，其主要原因在于预扭塑变形成的表面残馀应力。
This paper presents the test results of a series of dynamic cyclic torsional shear tests on saturated sands using both stress-controlled and strain-controlled process.
本文采用应变控制和应力控制两种控制方式对饱和砂土进行了大量的振动扭剪试验。
The influence to stress of skew arch bridge was studied by changing the abutment torsional stiffness and width-span ratio.
通过改变桥台抗扭刚度和宽跨比，研究对斜交拱桥受力的影响。
The fatigue rupture made up 80 percent of the total petroleum drillstring failures, which is related to the flexural-torsional alternate stress acted on drillstring.
石油钻柱的失效80 %以上都为疲劳破坏，这与钻柱在弯曲和扭转组合下的交变应力有关。
With these difference equations and compensatory ones, the torsion problem of this kind of beam can be solved to get its torsional shear stress and co.
联立差分方程和补充方程即可求解此类复杂截面的扭转问题，得到扭转剪应力及截面扭转常数。
The results show that low cycle fatigue life is reduced and cyclic stress is raised by torsional prestrain raising.
结果表明，扭转预应变降低低周疲劳寿命，循环应力随扭转预应变的增大而增大。
The three-dimensional photoelasticity method is used to analyze the stress distribution in the bevel gear under torsional moment and centrifugal load.
本文用三维光弹性法分析锥齿轮在扭矩和离心载荷下的应力分布。
The longitudinal bias stress may always weaken the anomalous amplitude-dependent effect, while the torsional one may induce different effects from different directions applied.
纵向偏应力总是削弱反常内耗效应，而切向偏应力因施加方向的不同引起不同的内耗效应。
It is indicated that the stress-strain relationship under the excitation of vertical and torsional vibration can be characterized with a hyperbola curve.
试验结果表明，煤灰土在纵向和扭转振动时的动应力-应变关系均满足双曲线关系。
The torsion resistance of the tension bar and the calculatiolls of bending shear stress, free torsional shearstress and bending torsional shear stress on the section are also discussed.
性质：用圆柱形材料试件作抗扭实验可求得扭矩和扭角的关系，相应最大扭矩的最大剪断应力叫抗扭强度。
Because its deformation, stress and vibration of three dimensions are bending-torsional-coupled, the mechanics analysis of this kind of structure is comprehensive.
由于它的变形、受力和振动均是弯扭耦联的，其力学分析就显得比较复杂。
This paper reformed the DTC-199 Type-torsional cyclic load triaxial apparatus, it can better simulate complex initial stress conditions of compacted loess foundation or sub-grade.
本文通过对DTC-199型周期扭转荷载三轴仪进行简单的改造后，可以较好的模拟压实黄土地基或路基在受到循环动荷作用前所处的复杂初始应力状态。
This paper reformed the DTC-199 Type-torsional cyclic load triaxial apparatus, it can better simulate complex initial stress conditions of compacted loess foundation or sub-grade.
本文通过对DTC-199型周期扭转荷载三轴仪进行简单的改造后，可以较好的模拟压实黄土地基或路基在受到循环动荷作用前所处的复杂初始应力状态。
应用推荐