Upon reception of a burst detection start trigger signal, a gain control signal is output to an automatic gain control amplifier (201) so as to perform amplification with a maximum value.
当接收到短脉冲检测开始触发信号时，向自动增益控制放大器(201)输出一个增益控制信号，以便用最大值进行放大。
A single trigger pulse generating circuit outputs a pulse signal when an output level of an amplifying unit is changed.
单触发脉冲产生电路在放大单元的输出电平改变的时刻输出脉冲信号。
This modulation is converted to a square wave output signal proportional to the rotary speed by an amplifier with trigger characteristics.
通过带有触发器特征的放大器将这种调制转换为方波输出信号，该输出信号与旋转速度成正比。
The A1210-A1214 Hall-effect latches include the following on a single silicon chip: voltage regulator, Hall-voltage generator, small-signal amplifier, Schmitt trigger, and NMOS output transistor.
在A1210 - A 1214霍尔效应锁存包括一个单一的硅芯片上以下内容：稳压器，霍尔电压发生器，小信号放大器，施密特触发器和NMOS输出晶体管。
The A1210-A1214 Hall-effect latches include the following on a single silicon chip: voltage regulator, Hall-voltage generator, small-signal amplifier, Schmitt trigger, and NMOS output transistor.
在A1210 - A 1214霍尔效应锁存包括一个单一的硅芯片上以下内容：稳压器，霍尔电压发生器，小信号放大器，施密特触发器和NMOS输出晶体管。
应用推荐