高强船板拉伸试验后出现断口分层现象。
Layered fracture occurs after tensile test of high strength ship plate.
模拟拉伸试验结果与分析结果完全吻合。
通过单轴拉伸试验，研究原状黄土的拉伸特性。
The tensile character of undisturbed loess is analysed by monaxial tension tests.
评定根据母材和全焊缝拉伸试验结果建立评定曲线；
The failure assessment diagrams were derived from the tensile test results.
连杆螺钉在加工完成后成品交验前，要求进行预拉伸试验。
Before completing linkage screw in the machining, finished products are needed to do the pre-tensile test.
本论文通过缺口拉伸试样的拉伸试验数据证明了以上关系。
In this paper, the experimental results of notch tensile specimens demonstrate the above relationships.
经不同温度下的拉伸试验，考察了几种热作工具钢的中温脆性。
The medium temperature embrittlement of several hot-working tool steels has been investigated by tensile tests at various temperatures.
在SEM下的拉伸试验，直接从微观上证明了这种约束的作用。
Through the tensile test in SEM, the constraint effects of particles have been investigated qualitatively in microscope.
摘要单向拉伸试验中，在比例极限内，应力应变关系服从胡克定律。
In simple tension experiment, the stress-strain relationship submits Hook's law within the limit of proportionality.
针对小直径螺栓和螺钉的拉伸试验要求，设计了一种拉伸试验装置。
To meet the needs of tensile test for small diameter bolt and screw, this article gives a design of tensile testing device.
最佳答案之间的关系应力和应变在一个特定的物质决心通过拉伸试验。
The relationship between stress and strain in a particular material is determined by means of a tensile test.
通过拉伸试验，分析了预拉伸变形对X60管线钢拉伸性能的影响。
The influence of per-tension deformation to the tensional function of X60 pipeline steel is investigated by tension experiment.
介绍了一种用于MEMS薄膜材料力学特性测试的单轴拉伸试验方法。
A uniaxial tensile test method for measuring mechanical properties of MEMS thin film materials is presented.
通过恒速拉伸试验，对一种生产保持架用铅黄铜的准超塑性进行研究。
The quasi-superplasticity of leaded brass for bearing cage was investigated through the constant velocity tensile test.
作者用国产单纤维电子强力仪对兔毛、澳毛和国毛进行一次拉伸试验。
The strength of rabbit hair and Australian wool was measured in one-process by means of the domestic-made single fibre strength tester.
经实验发现细晶粒碳钢焊接接头拉伸试验断口在远离热影响区的母材上。
It is found that the weld of fine grain steel break apart from heat effect zone in the tensile test.
结合工程实践对这两种节点进行了静力拉伸试验，分析了节点的破坏机制。
According to practice of project, static tensile tests are performed on the two connection types and the constructive mechanisms are analyzed.
扫描电镜下的原位准静态拉伸试验表明，合金的断裂行为是穿晶韧性断裂。
The result of insitu-tensile test shows that the behavior of fracture is transcrystalline rupture.
在材料力学的常规拉伸试验中，往往仅关心拉伸失稳而忽视了材料是否失稳。
More attentions to the tensile failure in tension test are paid; but the material failure is overlooked.
本文介绍了微型剪切试验与拉伸试验、断裂力学试验等参数之间的对应关系。
This paper describes the correlation between the characteristic values of the micro shear test and those of the conventional tensile, fracture mechanical tests.
对矩形试样拉伸试验测量的不确定度进行分析，得出了计算其不确定度的公式。
This paper analyzes the uncertainty of tensile test measurement for square specimen and gives formulae to calculate the uncertainty of measurement.
应用拉伸试验和慢拉伸试验，研究X70管线钢电化学充氢后材料拉伸性能的变化。
Tensile tests and slow strain rate tests (SSRT) are used to investigate the mechanical behaviors of X70 pipeline steel after electrochemical hydrogen charging.
通过单向拉伸试验研究了AZ31镁合金轧制板在不同温度和应变速率下的力学性能。
The mechanical property of AZ31 magnesium alloy rolling sheet under different temperatures and strain rates was studied through uniaxial tensile test.
使用SEM、EDX分析了界面微观结构，通过拉伸试验对接头力学性能进行了评定。
The interface microstructure is analyzed by SEM and EDX. The mechanical properties of the joint is evaluated through tensile tests.
通过极限抗拉强度试验和围压作用下的拉伸试验，研究了柔性混凝土的抗拉破坏特性。
Based on the ultimate tensile strength test and extension test under confining pressure, the characteristics of flexible concrete are studied.
充氢条件下应力弛豫和恒载荷拉伸试验结果表明，氢有引起钢的软化和硬化的双重作用。
The experimental results of stress relaxation and constant load tests in hydrogen charging condition prove that hydrogen has dual action of softening and hardening steel.
本文采用单试样逆光拍照法对延性材料拉伸试验缩颈后的真实应力-应变进行了有效的测量。
The backlight photography with single sample was used to measure the true stress-strain of the ductile material after necking in tensile test.
织物传送带。全厚度拉伸试验。第1部分：拉伸强度、断裂伸长率和标准负荷下伸长率的测定。
Textile conveyor belts - Full thickness tensile testing - Part 1: determination of tensile strength, elongation at break and elongation at the reference load.
测定了铝合金的微型剪切试验和拉伸试验的性能参数，研究了这些性能参数之间的数量关系式。
The characteristic values of micro shear test and tensile test of alloy aluminium were determined and the quantitative expressions of these characteristic values were studied.
测定了铝合金的微型剪切试验和拉伸试验的性能参数，研究了这些性能参数之间的数量关系式。
The characteristic values of micro shear test and tensile test of alloy aluminium were determined and the quantitative expressions of these characteristic values were studied.
应用推荐