The annealing temperature is passed through lowly either is overtopped.
退火时间不变、退火温度过低或过高；
The hardness of the alloy decreased as the annealing temperature increased.
退火温度越高，硬度下降幅度越大。
The optimal middle annealing temperature increases with the increase of the carbon content.
合金的最佳中间退火温度随碳含量的增加而升高。
The optimum middle annealing temperature depends on the chemical composition of the alloys.
而最佳中间退火温度受合金成分的影响。
The results show that the thermal diffusivity decrease with annealing temperature elevating.
结果表明：纳米氧化铝的热扩散率随退火温度的升高而减小。
Objective:To explore a method for quicker identification of the optimal annealing temperature in PCR.
前言： 目的：探讨和尝试一种较为迅速确定最佳退火温度的方法来扩增目的基因。
Conductivity was increased with the increase of volume ratio, annealing temperature and annealing time.
随覆层材料体积比的增加、扩散退火温度的升高及扩散退火时间的延长而升高。
As the annealing temperature rises, the resistivity of alloyed wire reduced and thermal potential raised.
随退火温度升高，合金丝电阻率下降，热电势升高。
As the annealing temperature increases the red shift of PL peak from nc si shows the quantum size effect.
纳米硅的发光峰随退火温度升高而红移呈量子尺寸效应。
When the annealing temperature has been reached, the steel should be held there until it is uniform throughout.
达到退火温度后，钢应当保持在此温度等到全部均匀受热。
The stress impedance effects of the as-deposited films at different annealing temperature were also investigated.
测试了不同温度退火后，薄膜样品的应力阻抗效应。
With the increase of annealing temperature, the decomposition process of massive microstructure will be accelerated.
提高退火温度，尤其是在高于共析温度退火有助于加快块状组织的分解过程。
The different mechanical properties and plasticity of workpiece were obtained through adjusting annealing temperature.
对旋压工件采用不同温度的退火，得到不同的力学性能和塑性指标。
But if the annealing temperature is too high these will appear coarse-grained structure resulting from entire recrystallization.
但是，如果温度过高，会因产生再结晶而出现粗晶组织，还会导致性能的严重恶化。
The experimental results shows that PL peak energy positions shift towards the lower energy with annealing temperature increasing.
实验表明，发光峰值能量随退火温度的升高而移向低能。
The spontaneous polarization of ferroelectric films was strengthened and then weakened with the increasing of annealing temperature.
此外，随退火温度升高，铁电薄膜的自发极化强度先增强后减弱。
The influence of salt medium, annealing temperature and the critical size of nanoparticles on growth process was analyzed in detail.
分析了纳米颗粒前驱体的大小、盐介质的选取、热处理温度等因素对纳米颗粒固相生长的影响。
At the same time, the peak energy positions of PL spectra shift toward lower energies with the increase of the annealing temperature.
同时，随着退火温度升高，光致发光光谱的峰值能量位置移向低能。
The results indicated that the structures of MgO films were closely related to the amount of collodion and the annealing temperature.
结果表明，薄膜的晶体结构与胶棉液的含量及退火温度有关。
Thecomplete annealing temperature of the defects for low fluence irradiated GaP was250K lower than that for high fluence irradiated GaP.
而高住量辐照样品中观察到比双空位更复杂的缺陷形式，其完全被退火的温度比低剂量辐照的高250k。
This paper summed up the tensile strength of steel wire, annealing temperature and annealing time by experimental datas of wire annealing.
利用钢丝退火试验数据，总结了钢丝的抗拉强度、退火温度和退火时间的关系。
And the influence of annealing temperature was also found to be caused by the expansion coefficient difference and martensitic transition.
晶化处理温度对因热胀系数差异带来的热拉应力因马氏体相变而致的相变压应力均有不同程度的影响。
Effects of annealing temperature on the microstructure and properties of pure vanadium manufactured by hot isostatic pressing were studied.
研究了不同退火温度对热等静压纯钒组织和力学性能的影响。
When annealing temperature increase further toughness of the former will be greatly decreased toughness of the latter will be changed little.
退火温度进一步升高时，前者韧性急剧下降，而后者变化不大。
Influence of annealing temperature on structure and properties of infinitely chilled ductile cast iron roller is studied in the present research.
研究了退火处理温度对无限冷硬铸铁轧辊组织和性能的影响。
The effect of annealing temperature on the structure and electrochromic properties were discussed. Furthermore, coloration mechanism was discussed.
分析了热处理温度对薄膜的结构和电致变色性质的影响，讨论了薄膜的致色机理。
The effect of annealing temperature on fibrous texture of cold rolled IF steel sheet rolled from strip hot rolled in ferrite region was investigated.
研究了铁素体区热轧if钢经冷轧后，不同退火温度对丝织构的影响。
The scanning images of electron microscopy show that high annealing temperature or high laser energy can induce the nanocrystalline Si film with mazes.
扫描电子显微镜的结果表明，高的退火温度或高的激光能量均会导致迷津结构的形成。
The experimental results indicate: The preferred orientation of the abnormal grain growth depends on the annealing temperature and atmosphere sensitively.
结果表明，晶粒异常长大的择优取向依赖于热处理温度及气氛。
The experimental results indicate: The preferred orientation of the abnormal grain growth depends on the annealing temperature and atmosphere sensitively.
结果表明，晶粒异常长大的择优取向依赖于热处理温度及气氛。
应用推荐