AIM: To explore the effects of axial stress regulation on healing of lengthened callus.
目的：探讨轴向应力调节在延长段骨痂愈合中的作用。
Now the FBG sensors in operation mostly make use of its sensing characteristics of axial stress and strain.
现阶段投入使用的光纤布拉格光栅传感器主要利用的是其轴向应力、应变特性。
The higher the coupling coefficient is, the lower the axial force, the axial stress and the axial moment are.
耦合系数越大，轴向应力、轴向力以及轴向弯矩越小。
Meanwhile, the side friction resistance and axial stress of each pile change diversely along the pile length.
同时各桩的桩侧摩阻力及桩身轴力沿桩长的变化也有所不同。
According to the regulation of axial stress distribution, a way to design the rational end construction is given.
根据端部所呈现的应力分布规律，提出了确定端部合理结构型式的方法。
The pressure study was undertaken to evaluate axial stress of the facet joints after anterior cervical discectomy.
本研究通过颈前路椎间盘部分切除，观察小关节在轴向载荷时压应力的变化。
The formula for calculating the axial stress of casing was discussed with theoretic deduction and calculation methods.
通过实例计算，对比分析了用“三向应力圆”理论与其他几种理论计算的抗挤强度值。
The method proposed can also be used to analyze the problem of size effect of axial stress-circumferential strain curves.
上述方法也可用于分析轴向应力-环向应变曲线的尺寸效应问题。
It will decrease the maximum axial stress of the lining, but it will increase the maximum shear stress and flexural stress.
开挖引致的松动区减少围岩劲度，将减少衬砌轴向应力，但增加剪应力及挠曲应力。
The fiber breaks into incrementally smaller fragments at locations where the fiber's axial stress reaches its tensile strength.
在纤维的轴向应力达到其强度的地方，纤维逐步破成小的碎片。
The experimental result shows that the lateral stress threshold of the second creep stage is less than that of axial stress threshold.
试验结果表明，横向稳定蠕变阶段的应力阈值低于轴向稳定蠕变阶段的应力阈值；
In the past, this character was not considered in the strength calculation of gun barrels and the effect of the axial stress is ignored.
已往在进行火炮身管强度计算时，均不考虑材料的这一性质，而且也都忽略了轴向应力的影响。
The internal stress is consisting of circumferential stress and axial stress, from which the compound stress of the weld seam is derived.
该内应力由环向应力和轴向应力构成，据此推导出了焊缝处的合成应力。
The interim point on the vertical symmetrical line at which the axial stress changes from the compression stress to tensile stress is further found.
并求出了垂直对称线上轴向应力由压应力转变成拉应力的过渡点。
Through a lot of creep test of frozen clay under single-axial stress, the curves and parameters of creep under single-axial stress state are obtained.
通过大量的冻结粘土单轴蠕变试验，获得了单轴应力状态下的蠕变曲线及其参数。
The result of this experiment reveals that the tangential modulus is exponential with axial stress, and varies with rock block size and rock property.
试验结果表明：松散岩块的切线模量与轴向应力间呈指数关系，并随其颗粒粒径和岩性不同而变化；
The result shows that axial stress of Pile takes on degression along with deepness and the effective length of Pile is influenced by replacement-ratio.
结果表明桩身轴向应力随深度增加呈递减趋势； 粉喷桩复合地基的有效桩长受桩土模量比与置换率的影响。
It is also improper that secondary stress is totally substituted by axial stress when checking fatigue safety, because such design is too conservative.
计算分析还发现，将次应力与轴向应力等同进行疲劳检算不恰当，将次应力全部当成轴向应力考虑的设计过于保守。
On the basis of theory analysis, it is deduced that the axial stress is linear distribution, when the steel support is loaded by axial force and moment.
根据壳体理论对钢支撑受力机理进行分析和简化计算，得出钢支撑在轴力和弯矩共同作用下，轴向正应力呈线性分布。
The axial stress on the steel tube which appears on the contact region of the steel tube and mandril is larger than the radial and circumferential stress.
钢管周向和径向的应力值不大，而轴向应力值较大，最大轴向应力出现在钢管与芯模的接触部位。
Through the experimental research on the compaction of friable rock block, the relationship among deformation modulus, axial stress and strain were obtained.
通过对松散岩块压实试验研究，得到了变形模量与轴向应力、轴向应变的相关性规律。
The relationships from vertical soil pressure, axial stress of anchor, lateral displacement of foundation to construction process are got by test data analysis.
通过对试验数据的分析得出了土中竖向应力、锚杆轴向应力、基坑侧向位移与施工过程间的变化关系。
Based on the local strain method of the single axle stress condition method, the multi axial stress condition computing method of the proportional loading is presented.
基于单轴应变疲劳分析，提出了比例加载多轴应力状态下的疲劳寿命计算方法。
Through the analysis of support axial stress actual measurement data compared with design numeric, adjust the design scheme of the support and yield good economic returns.
通过对支撑轴力实测数据与设计值对比分析，调整了支撑设计方案，取得了一定经济效益。
It is shown that the characteristics of shear stress acting on bolt vary in different zones zone of surrounding rock and are reflected in the axial stress distribution of bolt.
结果表明，在围岩不同区内，锚杆所受剪切力具有不同的特点，而且，锚杆所受剪切的特点在锚杆轴力分布中得到了反映。
The relationship among many factors are obtained on the creep behaviour of sedimentary soft rock, such as axial strain, axial strain ratio, axial stress, and axial stress ratio.
系统地把握了多种软岩在不同条件下的强度、变形特性，探讨了各种软岩的变形、变形速率、时间依存性等影响因素，为预测软弱岩体的长期力学稳定性提供了重要依据。
The strains of all elements could be obtained by the displacements of all nodes owing to axial stress was predominant, and the relationship can be expresses by a transition matrix.
对于空间杆系结构，认为其杆件只承受轴向应力，因此，由节点位移可得出各杆件应变。
The strains of all elements could be obtained by the displacements of all nodes owing to axial stress was predominant, and the relationship can be expresses by a transition matrix.
对于空间杆系结构，认为其杆件只承受轴向应力，因此，由节点位移可得出各杆件应变。
应用推荐