When the guiding track framework is joined to 10m, you should make vertical of guiding track framework's axle and the base from the front and side.
导轨架接高到10米时，需用丝线坠从正面和侧面分别找正导轨架轴线与底座平面的垂直度。
Automobile application character is directly affected by the problem of automobile axle base difference between left and right.
汽车左右轴距差问题可直接影响到汽车的使用性能。
At present, the WIM systems were studied on the base of wheel load and axle load, this paper discussed the way of axle load.
目前汽车动态称重主要有检测轴载荷和轮载荷两种称重方法，本文使用轴载荷称重的方法进行动态称重技术的研究。
The base is fixed near the building wall, the vertical axle line is parallel to the building wall, the distance from vertical axle line to the wall is 3m.
底座固定在建筑物墙面附近，其纵向轴心线与建筑物墙面平行，纵轴线到墙面间距为3米。
In addition he lengthened the old transverse springs, mounted them ahead of the front axle and behind the rear axle, stretching the spring base to 123 in. but retaining the old 112-in. wheelbase.
此外他还加长了原先的横置弹簧，把它们分别装在前轴的前面和后轴的后面，把间距增加到了123英寸，但保留了原先112英寸的轴距。
When the central axle is driven to rotate by the driving motor, the central axle can drive an antenna dish and the supporting dish base of the rotary antenna component to rotate.
当该驱动马达驱动旋转该中央轴杆时，该中央轴杆带动该可旋动天线组件的天线盘体及支撑盘座旋转。
The utility model enables the slide handle and active force plug to undergo linear reciprocating motions via the 't' plate and connecting rod rotated on the base axle.
本实用新型通过支座轴上转动的丁字板和连杆，使连接其上的滑柄和活动凸模进行直线往复运动。
This paper describes the distribution of the ration of the rear overhang to the axle base for buses, and it also analyzes the effect on performance of the ration.
论述客车后悬与轴距比值在各种客车上的分布；分析该比值对客车性能的影响。
The design aims to complete the module design of 195diesel rocker axle base, the draw up of its processing line and procedure card and the design of manufacturing special fixture, etc.
本设计目的是完成195柴油机摇臂轴座的模具设计，摇臂轴座加工工艺路线及工艺卡的制定，部分工序专用夹具的设计等。
An ultra-fine roll mill comprises a base, a host cylinder, a centre axle, a bracket, a grinding ring and a grinding roller device.
一种辊碾超细磨包括底座、主机筒体、中心轴、托架、磨环和磨辊装置。
An ultra-fine roll mill comprises a base, a host cylinder, a centre axle, a bracket, a grinding ring and a grinding roller device.
一种辊碾超细磨包括底座、主机筒体、中心轴、托架、磨环和磨辊装置。
应用推荐