Viscous coupling; Torque characteristics; Bench test;
粘性联轴器；转矩特性；台架试验；
The relation between the duty cycles of solenoid force is established by bench test.
通过台架试验，得到了电磁阀控制占空比与换挡力的关系。
Done the bench test with the proper proportion emulsified diesel oil as automotive fuel.
将适当比例的乳化柴油作为内燃机燃料做了台架试验。
Compared with the bench test under the same conditions, the established model has higher precision.
与相同工况下的台架试验对比可知，所建模型精度较高。
The authors have developed a computer based control system in bench test of engine using virtual technique.
作者运用虚拟技术开发出一个运用计算机进行控制的发动机台架试验系统。
The result of the bench test shows that the newly developed brake disc has fairly good braking performance.
台架试验结果表明，新研制的制动盘具有良好的制动性能。
The characteristics of motor and driving system were analyzed and evaluated in detail by practical bench test.
通过感应电机驱动系统实际台架试验对整个电机以及驱动系统的特性进行了详细的分析和评价。
The simulation results is close to that of the bench test, which validates the effect of this numerical model.
经过模拟计算与实验对比，验证了该数值模型的模拟效果。
Onsite bench test of refinery odor sulf-gas treatment has been successfully carried out with bio-filter process.
应用生物滤床工艺，对炼油厂含硫恶臭废气进行了现场小型侧流试验研究并取得成功。
The aim of this paper is to develop a kind of bench test for evaluating the soot dispersancy of diesel engine oil.
此项工程旨在开发出一种能评价柴油机油烟炱分散性能的试验方法。
After bench test, it's shown that ECU can meet the control demand of high pressure common rail system in diesel engine.
台架试验结果表明：电控单元能满足柴油机高压共轨系统的要求。
The bench test and vehicle road test of the dissociated methanol engine were conducted and better results were attained.
通过发动机的台架试验和配车道路试验，均达到了较好的配试效果。
The final wear-off field test for the teams that survive the bench test will be Oct. 4 in a four-hour field test competition.
在92个小时后仍存有电量的系统将在10月4日进行为期4个小时的战场竞争测试。
Thus the dynamic temperature rise laws of two solid tire materials were obtained and the laws were confirmed by the bench test.
台架试验结果很好地验证了有限元分析的温升规律，证实建模选用模块合理有效。
Bench test shows that the double row short roller bearing works flexibly and normally and meets the basic performance requirement.
台架试验表明，该双列偏心短圆柱轴承运转灵活正常，达到了设计基本性能要求。
Based on the bench test, a system is developed for measuring the variation of the friction between piston ring and cylinder liner.
作者结合发动机试验台，设计了一套对活塞环-缸套动态摩擦力进行采集的装置。
The principle of this controlling system is discussed and some resultsobtained from steady state engine bench test are also reported.
并报告了发动机台架稳态工况试验的结果。
Ignition advance Angle MAP is obtained by calculating ignition model. The MAP is optimized by on line tune up system in the bench test.
根据点火模型确定点火提前角MAP图，并在台架实验中采用在线修改系统进行优化。
Screened formula has past the bench test with high pressure pump, getting good application in concrete pumping truck with high pressure.
经过筛选后形成的配方通过了高压泵台架试验并在高压混凝土泵送车上取得了良好的应用效果。
Finally, bench test was toke out on CNG engine, the influence of ignition advance Angle on dynamic and combustion characteristic was studied.
最后进行了天然气发动机台架实验，研究了点火提前角对发动机燃烧特性、排放性能的影响。
It is one of the key techniques in the research and development of automotive catalyst to evaluate its performance through the engine bench test.
用发动机试验台架对催化器进行性能评价是催化器研制开发中的关键技术之一。
The results showed that, an iron concentrate with a TFe grade of 65.50% and a recovery of 83.09% can be obtained by the closed-circuit bench test.
结果表明，采用选择性絮凝脱泥-阳离子反浮选流程闭路试验可获得铁精矿品位为65.50%，回收率为83.09%的较好指标。
The bench test of three-cone bits and analysis of their bottom hole patterns are the simplest and useful means of checking and improving their design.
三牙轮钻头地面台架试验与井底模式的分析是对牙轮钻头设计的合理性进行检验与改进的最简便又较真实的方法。
In order to verify the performance of fracturing truck and plunger pump, bench test, final assembly test and field industrial test should be performed.
为了验证压裂车和柱塞泵的性能，进行了台架试验、出厂试验和现场工业试验。
To validate the design, a bench test was performed and the results show that the electronic control unit fulfils the control requirements satisfactorily.
为了验证系统设计的正确性，进行了台架试验，结果表明，电控单元能完成控制要求并具有较好的控制效果。
Discussion is made on the engine automation measurement equipment for bench test, especially in its operating principle and breakdown diagnosis and maintenance.
主要阐述了发动机自动测试设备的工作原理及故障诊断与维修。
A specialized noise test bench of automobile cooling fan was designed to carry out the bench test and the outer vehicle acceleration noise test also was conducted.
设计制造了发动机冷却风扇噪声性能测试专用试验台，用于冷却风扇的台架试验。
This paper attempts to use the parameter estimation method to backward calculate tooth-rock sample interaction mathematical model according to some bit bench test data.
本文尝试用参数估计的方法，依据一些钻头台架试验的数据，来反求牙齿-岩样互作用的数学模型。
This paper attempts to use the parameter estimation method to backward calculate tooth-rock sample interaction mathematical model according to some bit bench test data.
本文尝试用参数估计的方法，依据一些钻头台架试验的数据，来反求牙齿-岩样互作用的数学模型。
应用推荐