The influence of geometric size, material properties of the slabs, inhomogeneous subgrade, sleeper beam and bituminous overlay on the bending stresses and deflection is investigated.
分析中包括了搭板的几何尺寸、材料因素、地基非均匀、枕梁及沥青加铺层对搭板弯拉应力及变形的影响。
The structural properties of concrete bridge externally prestressed with CFCC, and the analysis methods of deflection, ductility, bending and shear design of the bridge are discussed.
探讨了碳绞线体外预应力混凝土桥梁的结构特点和构造措施，以及该类桥梁中挠度、延性及抗弯、抗剪的计算分析方法。
Find the value of the bending stress and the deflection at the center if the ribs are omitted.
如果略去肋条，求中心处的弯曲应力和挠度之值。
According to theoretic analysis, computing the bending deflection of every roller is enabled to ignore the effect of the web and only allow to the rectangular section made up of flange plates.
理论分析认为求解各可调辊的压下挠度时，可以不考虑腹板的影响而按翼缘组成的“矩形”断面来进行。
In this paper, the study of disc spring is simplified and regarded as the symmetrical bending of circular plate with initial bending deflection.
本文将碟形弹簧简化为具有初挠度的圆环形薄板的对称弯曲问题。
Formula to compute nonlinear deflection at the top of the column subjected to both axial and transverse bending is then derived.
然后，推导出承受纵横弯曲塔身顶部的非线性变形计算公式。
This paper studied the relationship among bending moment, curve, deflection and concrete compression height by design principle for reinforced concrete structure.
从钢筋混凝土结构设计原理出发，分析截面弯矩、曲率、挠度、受压区高度之间的相互关系；
Series solutions were derived for the in-plane strain, deflection and bending strain that satisfy the simplified boundary conditions to calculate the shear lag coefficient.
根据简化的边界条件，得到了面内应变和弯曲应变的级数解，进而求得剪力滞后系数。
Geometricshape and energetic parameters of H-beam are tested for different bending deflection. Theresults of test show that theoretical and simulation analysis is correct.
测试了不同压下挠度矫直时H型钢的几何形态和主要力能参数，进一步证明了理论分析和仿真结果的正确性。
In pipe laying and lifting analysis, the contact condition between pipeline and seabed, including deflection, rotation Angle and bending moment, is sometime tricky in a normal mechanical model.
海底管道的铺设分析和提升分析都用到管道和海床之间的接触条件，这个同时含有挠度、转角和弯矩的接触条件，在一般的力学模型中是很难理解的。
Aimed at the bend of poplar-straw laminated beam, the theory of delamination shearing deformation was used to analyse its bending deflection and strength, and compared the results with other theories.
针对杨木—秸秆层合梁的弯曲问题，利用分层剪切理论对其变形和强度进行了分析。并将分析结果与经典理论、一阶和高阶剪切变形理论的结果进行了比较。
Through the example we know that the distribution line of the bending moments, pressure and deflection obtained by this method is the same as by the differential method.
通过算例发现该分析法得出的弯矩、压力和位移分布线与按微分分析法分析结果非常吻合。
It was shown that computed bending moments along pile shaft and deflection occurred at pile top are consistent with the measured ones.
桩身弯矩和桩顶位移的计算值与实测值基本符合。
The loading of a tubular busbar is equivalent to that of a large-span beam, and the stress on the cross -section is mainly the tensile stress of the dead weight bending moment with much deflection.
管型母线受力状况相当于大跨度的梁，截面上的应力主要是自重弯矩的拉应力，挠度比较大。
With the help of the method, the bearing capacity in bending, the limitation of crack width and the deflection of the members can reach optimum.
可使构件正截面承载力、裂缝宽度，挠度同时都达到最佳程度的满足。
For the two-bar robot arm, we focus merely the whole kinetic energy at horizontal condition, and neglect the change of potential energy due to the bending deflection of the robot arm.
对二连杆机器人手臂在水平状态下仅考虑总的动能，而忽略由于手臂挠曲变形而产生的位能变化。
Through measuring deflection and strain of test girders under loading, performances of this type of box girder, including bending, torsion and distortion are analyzed.
通过测试模型梁在静力荷载作用下的挠度和应变，来分析这种箱梁结构的弯曲、扭转和畸变等力学特性。
Furthermore, the front pile has curtain effect on the back pile. The bending moment and deflection of the back pile decrease obviously for the existence of front pile.
而两桩中的前桩对后桩具有遮拦效应，前桩的存在使得后桩的弯矩和变形明显变小。
The test result shows that deflection of CFST truss girder is mainly attributed to deformation of shear-bending parts and much smaller than that of solid web girder.
试验结果表明：钢管混凝土桁梁变形比实腹梁小很多且主要集中于边段；
In nonlinear analysis, FGM plates and shells behaviors, which include large deflection bending, large deflection vibration, post-bucking, are discussed using Galerkin variational method.
在线性分析中，用解析的方法分析了FGM板、圆柱壳与双曲率扁壳弯曲、振动与屈曲等力学行为。
In this paper, an appropriate FEM model is established. The bending deflection is simulated by ANSYS when the web is considered and not considered. The correctness of the theoretic result is ve...
通过建立适当的有限元模型，运用ANSYS软件仿真了考虑腹板和不考虑腹板的情况，从而验证了理论结果的正确性。
In this paper, an appropriate FEM model is established. The bending deflection is simulated by ANSYS when the web is considered and not considered. The correctness of the theoretic result is ve...
通过建立适当的有限元模型，运用ANSYS软件仿真了考虑腹板和不考虑腹板的情况，从而验证了理论结果的正确性。
应用推荐