With site deterioration the wood crushing and bending strength is increased.
随着立地的贫瘠化，木材抗压、抗弯强度增大；
Bending strength significantly increased after 200 and 400 hours of aging only.
弯曲强度显著增加200和400小时的老化只。
Bending Strength and Weibull modulus of eight kinds of ceramics samples were studied.
研究了八种不同陶瓷试样的抗弯强度和韦布尔模数。
Additionally, the fracture surfaces of bending strength specimen were also explained.
此外，还对抗弯强度试样的断口进行了分析。
The hardness, the fracture toughness and the bending strength of the composites were tested.
对热压烧结后材料的硬度、断裂韧性和抗弯强度进行了测试和分析；
Bending strength is a critical index for inspection and evaluation of cement concrete facing.
水泥砼面层以抗折强度作为强度检验和评定的首要指标。
It is found that the bending strength of gauge glass increases when the temperature decreases.
随着温度降低，玻璃板的抗弯强度测定值增加。
Full radius hob on tooth tip is one of the effective measures by increasing gear tooth bending strength.
应用齿顶整圆弧滚刀是提高齿轮弯曲疲劳强度的有效措施之一。
The mechanism of bending strength increased by bauxite chalmette and the process were investigated by XRD and SEM.
利用XRD、SEM等测试手段，对熟铝矾土提高瓷坯抗弯强度的机理和生产工艺进行了研究。
Bending strength, compressive strength, interfacial bond strength and frost-resistance were also studied and analyzed.
并对其抗压、抗折、新老界面粘结强度及抗冻性等进行了实验研究。
Within certain temperature range, the bending strength of wood and plastic composites reduces with the temperature power-up.
在一定温度范围内，木塑复合材料的抗弯性能随温度的升高而降低。
Considering the system errors of gear drive and teeth synthetic flexibility, the loading point of bending strength was studied.
考虑系统误差和轮齿综合柔度，对齿轮弯曲强度的计算力点进行研究。
The carrying capacity of a reinforced concrete slab under concentrated load depends on its bending strength and punching strength.
集中力作用下钢筋砼板的承载力取决于板的抗弯强度与冲切强度。
The tensile strength and bending strength of gas-assisted molding automobile handle were compared with conventional injection molding.
并对汽车把手件气辅成型制品和传统注塑成型制品的抗拉强度和抗弯强度进行了比较。
The effect of the sintering temperature and the mullite content on the dielectric properties and the bending strength has been studied.
研究了烧结温度和莫来石含量对复合材料的介电性能和抗弯强度的影响。
When detection bending strength of perforation board, it is necessary to based times of theory width of modules on the width of modules.
提出检测穿孔板静曲强度时，要以试件构成单元理论宽度的倍数作为试件宽度的计算依据。
The tensile strength, bending strength, impact strength, tensile modulus of elasticity and bending modulus of elasticity were determined.
测试了塑木板材的拉伸强度、弯曲强度、冲击强度、拉伸弹性模量、弯曲弹性模量等力学性能；
The results show that porosity is a linear function of graphite content and that bending strength is an exponential function of porosity.
结果表明：孔隙度与石墨含量呈线性关系，抗弯强度与孔隙度呈指数关系。
The dry density, bending strength and compressive strength of foam concrete block increased with the increasing of the amount of fly ash.
粉煤灰加入量增加，泡沫混凝土砌块的干密度递增，抗折和抗压强度增大。
The results show that steel fiber reinforced ferroconcrete t beam possesses high bending strength and excellent crack resistance property.
结果表明，钢纤维增强钢丝网混凝土T形梁具有较高的正截面抗弯强度和良好的抗裂性能。
Bending strength and fracture toughness of the composite were studied, and the microstructure of the composite was researched by TEM techniques.
对复合材料的强度及韧性进行了研究，采用TEM技术对材料的微观结构进行了分析。
The result shows that, for a definite hybrid composite, the bending strength increases as the numbers of the plies drop-off at a station reduce.
结果表明：对于一定的混杂复合材料，弯曲强度随着某一位置层错数目的减少而增加；
The measuring technique of tensile strength of ceramics is usually sophisticated, but it is easy for us to measure the bending strength of ceramics.
陶瓷材料抗拉强度的测试技术一直是个难以解决的问题，而抗弯强度的测定则已经较成熟且简便。
Airport cement concrete pavement structural parameters include slab thickness, concrete bending strength elastic modulus and foundation reaction module.
机场水泥混凝土道面结构参数包括板厚、混凝土弯拉强度和弯拉弹性模量、地基反应模量。
The study results in the paper can be conclude that the bending strength and fatigue life of RPC with steel fibre are much higher than those of plain RPC.
本文研究结果可归纳为：与无纤维RPC相比，钢纤维的加入大大增加了活性粉末混凝土的抗折强度和疲劳寿命。
The stress shielding rate, bending strength of different directions and torsion strength of the three different fixation methods were measured and compared.
然后对三种固定方法对固定骨段的应力遮挡率、不同加载方向的弯曲强度和扭转强度进行测试。
The results show that the dry density, bending strength and compressive strength of foam concrete block decreased with the increasing of the amount of foam.
研究结果表明：泡沫加入量增加，泡沫混凝土砌块的干密度逐步减小，抗折和抗压强度递减。
The results are compared to those of the standard involute gear and proof that the bending strength of the composite profile tooth is higher than that of involute one.
结果表明，复合齿形齿轮比渐开线齿形齿轮具有更高的弯曲强度。
The results of mechanical test show that is bending strength, toughness against impact and void ratios can be improved after the rich iron matris is added with rare earth.
力学性能测试结果表明：添加稀土的富铁胎体及其金刚石复合材料的抗弯强度、冲击韧性和孔隙度均有明显的改善。
It indicates that there are significant differences for microfibril Angle, basic density, bending strength and rate of shrinkage of poplar 63 and poplar 69 by variance analysis.
方差分析表明：63杨、69杨微纤丝角、基本密度、抗弯强度和干缩率差异显著，说明63杨和69杨受滩地类型影响较大。
应用推荐