Objective:To compare the effect of FL-Bond adhesive system with that of total etching adhesive system, that in treating wedge-shaped defect with light cured composite resin.
结论表明自酸蚀粘接系统的复合树脂修复牙体楔状缺损与全酸蚀粘接系统相比，具有固位性好、边缘封闭性强、对牙髓刺激小、成功率高等优点。
For a good bond, an adhesive must counteract the effect of surface roughness and boundary layers.
为了取得很好的粘结，粘结剂必须能克服表面粗糙和边界层的反应。
The glue on the tape is a wonderful adhesive agent and will bond well to anything from a piece of crystal to the handle of a broom.
这种带子的粘胶是一种极好的粘合剂，它能牢固地粘接到任何东西上，不论是一块水晶还是一个扫帚把。
Through pullout tests for shear resistance of the adhesive steel bar in the metal tube, the bond principals and failure modes of adhesives are studied.
通过对钢筋与金属套筒之间采用植筋胶粘结的拉伸抗剪试验，探讨了植筋胶的粘结机理和拉伸抗剪破坏模式。
This thesis mainly studies the adhesive performance between concrete and polymer mortar and the bond performance of steel weirs anchoring in the mortar.
本论文主要研究聚合砂浆与混凝土之间的粘结性能以及钢绞线在聚合砂浆中的粘结锚固性能。
They excrete a sticky adhesive and they can use that natural glue to repair the anchoring bond.
它们分泌出一种粘性粘合剂用这种天然胶水来修复锚定链接。
The first requirement for any adhesive bond is that the adhesive most wet the substrate.
对所有粘结剂粘结的首先要求，就是必须能浸润基材。
The defect testing and strength estimating of metal to metal single step-lap adhesive bond structures are studied by means of acoustic emission (AE) technique.
应用声发射检测技术研究金属铝单搭接胶接结构的缺陷检测和强度估计问题。
Adhesive for leather and footwear materials. bond strength. minimum requirements and adhesive classification.
皮革和制鞋材料用胶粘剂。粘结强度。最低要求和胶粘剂分类。
The tensile bond strength between enamel and orthodontic bracket mediated by a mo-mix orthodontic adhesive fabricated in this department was tested in case of five experimental conditions.
采用一种自制的非调和型正畸粘接剂，考察了牙釉质与正畸托槽在五种实验条件下的粘接抗张强度。
This paper discusses how to improve the performance of oxidized corn starch adhesive, including low green bond, bad consistent glue viscosity, bad water-resistance and slowly dry speed.
针对氧化淀粉胶粘剂初粘力低、干燥速度慢、稳定性差、抗水性差等缺点进行改性研究。
However, once the treated surface has been interfaced with a coating, ink, adhesive, or another material, the bond becomes permanent.
然而，一旦处理的表面已经连接了涂料，油墨，胶粘剂，或另一种物质，债券成为常任理事国。
The results show that the adhesive has the characteristics of higher bond strength and better Storage Stability.
结果表明，该胶粘剂具有较高的粘结强度和优良的贮存性能。
They excrete a sticky adhesive and they can use that natural glue to repair the anchoring bond.
它们能够分泌出一种粘性的物质，并且可以运用这种天然胶来修复锚固粘结。
The selection principal of low toxic mixed solvent of CR adhesive is depended upon hydrogen bond index and solubility parameter of the solvent.
氯丁胶粘剂的低毒混合溶剂的选择原则是：根据溶剂的氢键指数及溶解度参数。
Based on experimental data, adhesive length, the number of layers and sticking technology, and the effects of the parameters are discussed, and the bond mechanism is described.
探讨了碳纤维布的粘接长度、层数、宽度比以及粘贴工艺等不同粘接参数对复合构件粘接性能的影响，初步描述了碳纤维布与钢构件的粘接机理。
The application of feature analysis of ultrasonic nondestructive testing(UNDT)of adhesive bond structures(ABS)is presented in this paper.
本文介绍了超声无损检测特征参数分析在胶接结构中的应用。
The bond strength adhesive tape for repeatability of test results is critical.
胶带的粘合强度对于测试结果的可重复性非常关键。
Objective To compare the shear bond strength of light cured and chemically cured resin adhesive.
目的对光固化和化学固化树脂粘接剂的剪切强度进行对比研究。
Xeno III Adhesive provides bond strength comparable to total etch systems.
异种三胶粘剂粘结强度可比提供总额蚀刻系统。
This results in an adhesive bond forming between the coaxial cable and the connector to create a secure, mechanical bond and moisture seal.
结果，粘结剂粘结形成于同轴电缆与连接器之间以生成牢固的机械粘结及水气的密封。
A special silicone adhesive is used to bond the heat shield tiles on the space shuttle.
特种硅橡胶粘合剂用于粘合航天飞机上的隔热片。
Objective: to investigate the shear bond strength of three adhesive systems bonded with ceramic brackets to the porcelain surfaces.
目的：研究三种不同釉质粘接剂对陶瓷托槽与瓷修复体粘接剪切强度的影响。
Polyvinylformal based adhesive for fireworks is introduced. It have advantages of simple technology. high bond strength. good initial tack. thermal stability and freeze resistance.
介绍了一种以聚乙烯醇缩甲醛为主体的烟花胶。它的制造工艺简单，采用此法制造的烟花胶粘接强度高，初粘性、热稳定性、耐冻性能好。
Objective The bond effect of the fluoride-releasing orthodontic adhesive was studied in vitro.
目的通过离体牙试验，阐明口腔正畸含氟牙釉质粘接剂的粘接强度。
The adhesive forces were found to be related to the metal to oxygen chemical -bond energy.
已经发现，粘著力与金属-氧的化学结合能有关。
The adhesive forces were found to be related to the metal to oxygen chemical-bond energy.
已经发现，粘著力与金属-氧的化学结合能有关。
DING Hong, WU Jian-Yong. The vitro study of the influence of different silane coupling agents and adhesive materials on shear bond strength of metal brackets to porcelain surface [J].
丁宏，吴建勇。不同偶联剂和粘接剂对烤瓷瓷面与金属托槽抗剪切强度影响的体外研究[J]。
The adhesive performance between concrete and polymer mortar and the bond performance of steel weirs anchoring in the mortar, to a great extent, affect the integrated reinforced effect.
钢绞线网-聚合砂浆粘结锚固性能在很大程度上影响到加固或修补的整体效果。
The adhesive performance between concrete and polymer mortar and the bond performance of steel weirs anchoring in the mortar, to a great extent, affect the integrated reinforced effect.
钢绞线网-聚合砂浆粘结锚固性能在很大程度上影响到加固或修补的整体效果。
应用推荐