Ten years ago, I planned to build a class A power amplifier, but I shelved it due to my limit in knowledge and ability then.
早在十几年前，我就计划做一台单端A类的放大器，但这个计划一直没有实现，直接的原因就是技术不充分。
Driver deadtime control is a popular scheme used to prevent the occurrence of the shoot-through issue in a Class-D APA (audio power amplifier).
在D类音频功率放大器中，驱动死区时间控制是一个很流行的术语。
This thin-style high-power amplifier with versatile charm featured the definitive high-efficiency class A amplifier, the HCA circuit.
这款是全能高效率的A类放大，薄型高功率功放。
The controller combines parallel amplification and drain modulation of the CMOS class-E power amplifier to provide high efficiency over a broad range of output powers.
结合射频E类功率放大器的结构特点，采用CMOS工艺，达到了在大的输出功率范围内保持持续稳定高效率的目的。
As long as the manufacturer isn't rating the amplifier for its output power in this clipped state, the amplifier would normally be called class a, single-ended.
只要制造商不是评价的放大器，其输出功率在此截断的国家，放大器通常被称为A级，单端。
Based on the conventional Class-E resonant high-frequency power amplifier, a new control scheme used in Active-clamped Class-E inverter for ultra-high frequency induction heating is proposed.
以传统的E类高频功率放大电路为基础，提出了应用于高频感应加热电源的有源箝位E类逆变电源的一种新型控制方法。
In order to improve both charge current and transfer efficiency via a lower coupling coefficient inductive link, class E power amplifier based on primary leakage inductance and compensat.
在低耦合系数条件下 ，通过基于初级漏感的E类功率放大器和次级漏感的补偿方法 ，提高电容充电电流和传输效率。
In order to analyze the nonlinear characteristic presented in the subharmonic load pull experiment theoretically, a class a MESFET power amplifier is researched on in this paper.
为了从理论上解释副谐波负载牵引实验中的各种非线性现象，对一个A类MESFET功放进行了研究。
This will lead to "sag" in the power supply that doesn't exist in the true class a amplifier, which again results in a tonal change.
这将导致“凹陷”的电源供应，不存在真正的A类放大器，而这又产生一个音调的变化。
The class E power amplifier hasn't widely used because of a variety of problems, one of which is the difficulty of adjustment.
高效率E类放大器的提出是功率电子学研究方向的重大突破，但它由于受到各种因素的限制，还未能得到广泛应用。
Second, a push-pull class A amplifier output stage will have inherent rejection of power supply ripple and noise.
第二，推挽A级放大器输出阶段将拥有固有拒绝电源纹波和噪声。
Combining the secondary circuit, we have proposed the design methodology of transcutaneous power transmission system with a class-E amplifier.
结合次级电路，提出了基于E类放大器的经皮能量传输系统的参数设计方法。
Integrated circuit of a class-D audio power amplifier with very high efficiency using CMOS technology is presented in this paper.
分析了高频开关电源的特点及将其应用到音频功率放大器中所遇到的主要问题，以及解决这些问题的基本方法。
Integrated circuit of a class-D audio power amplifier with very high efficiency using CMOS technology is presented in this paper.
分析了高频开关电源的特点及将其应用到音频功率放大器中所遇到的主要问题，以及解决这些问题的基本方法。
应用推荐